Normal No Spacing I Heading Heading z 4. A 9.0 μF capacitor and a 20 μF capacitor are connected in parallel to an 11.0 V battery. a. What is the total capacitance of the circuit? b. What is the voltage, V₁, across capacitor, C₁? c. What is the voltage, V₂, across capacitor, C₂? d. How much charge, Q₁, is on capacitor, C₁? Heading S How much charge, Q₂, is on capacitor, C₂? Heading

Normal No Spacing I Heading Heading z 4. A 9.0 μF capacitor and a 20 μF capacitor are connected in parallel to an 11.0 V battery. a. What is the total capacitance of the circuit? b. What is the voltage, V₁, across capacitor, C₁? c. What is the voltage, V₂, across capacitor, C₂? d. How much charge, Q₁, is on capacitor, C₁? Heading S How much charge, Q₂, is on capacitor, C₂? Heading

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter20: Electric Current, Resistance, And Ohm's Law

Section: Chapter Questions

Problem 10PE: A clock battery wears out after moving 10,000 C of charge through the clock at a rate of 0.500 mA....

See similar textbooks

Similar questions

A small light-bulb draws 0.22-A current from a 6-V battery. In 2 min: a) How much energy does the battery supply? b) How many electrons passes through a point in the circut every second?
A proton is accelerated across a 240 V voltage difference. a) What will its speed then be? b) How close does it get to another stationary proton before it turns around and shoots back?
A clock battery wears out after moving 10,100 C of charge through the clock at a rate of 0.520 mA. (a)How long (in s) did the clock run? s (b) How many electrons per second flowed? electron(s)
A fully charged capacitor with a voltage of 120 V is discharged through a resistor. (a) What is the voltage across the capacitor at the end of five time constants?(b) At this time, what is the voltage across the resistor?
4.A 2-W light bulb is connected to a 6-volt battery and left on for 20 minutes. (a)What is the power (W) of the light bulb? (b)How much charge flows through the light bulb in this time? What total battery energy has been used?
In the circuit shown in the figure, both capacitors are initially charged to 45.0 V.a. How long after closing the switch S will the potential across each capacitor be reduced to10.0 V?b. What will be the current at that time?
A laptop battery has an emf of 10.8 V. The laptop uses 0.70 A while running.a. How much charge moves through the battery each second?b. By how much does the electric potential energy of this charge increase as it moves through the battery?
A constant current transfers 10*10^14 electrons onto one plate of a capacitor in 3 minutes [min]. (a) What is the current, in units of amperes [A]? Express the answer using an appropriate SI prefix such that there are only 1, 2, or 3 digits shown to the left of the decimal. (b) If the capacitor has a capacitance of microfarads [F], what is the voltage in units of volts [V] across the capacitor?
Three capacitors each of capacitance 9 pF are connected in series.(a) What is the total capacitance of the combination?(b) What is the potential difference across each capacitor if the combination is connected to a 120 V supply?
Using Ohm’s Law, what is the relationship of current, voltage, and resistance? How do batteries produce potential energy? As a student, what can you contribute to the conservation of electricity?
A) What is the total resistance?B) Of the voltage of the battery is 12V, what is the current through the battery when the switch is closed?C) What is the current through R1?D) What is the voltage across R4?
What is the voltage change if you cross a resistor R in the same direction as the current I? (This means you want Vf-Vi, where Vi is the voltage where the current enters the resistor and Vf, is the voltage where the current leaves the resistor.) What is the voltage change if you cross a resistor R opposite the direction of the current I? (in this case, Vi is the voltage where the current leaves the resistor, and Vf is the voltage where the current enters the resistor.) Which answer is correct? +IR in both cases +IR in the first case and -IR in the second case. +IR in both cases -IR in the first case and +IR in the second case.