nswer the following questions. 1. What are the procedures in water and Sediment test?

Q: An eccentric load is applied at a point 22 mm from the geometric axis of a 60-mm-diameter rod made…

A: Given data: Diameter of the rod=60 mm Eccentricity, e=22mm Stress, σy=250 MPa Young's modulus, E=200…

Q: A 4.5m simply supported T- beam shwon below carry a uniform Dead load=25 kN/m and Uniformly live…

A: Given: Span = 4.5 m DL = 25 kN/m LL = 15 kN/m fc = 21 MPa fy = 415 MPa ds = 10 mm cover = 50 mm…

Q: Determine the force P (in Newton) required to hold the 175 kg crate in equilibrium. The weights of…

A:

Q: A bar of 400 mm length and a uniform cross-section 20 mm diameter is subjected to tensile load of 50…

A:

Q: To find the Reduced Level of a roof slab of building, staff readings were taken from a particular…

A: Given data, Back Sight, BS = 1.050 m Reduced level, RL = 135.15 m Fore sight, FS = -2.300 m (as…

Q: Determine the normal stress and shear stress acting on the inclined plane AB. Solve the problem…

A:

Q: 5. Using VWM or CTM, solve the slope of the elastic curve at the right support for the beam loaded…

A:

Q: The predicted traffic mix of a proposed four-lane urban non-interstate freeway is as follows.…

A: Given, Passenger cars = 78% Single-unit trucks: 2-axle, 5,000 lb/axle = 12% 2-axle, 9,000 lb/axle =…

Q: Girder AB. Assume Use Fy = 50 ksi and select a shape for that the floor slab provides continuous…

A:

Q: Excavation was being carried out for a foundation on plastic clay with a unit weight of 22,5 kN/m³.…

A:

Q: A solid plastic rod has a diameter of d = 21 mm and a length of L = 600 mm. An axial load of P = 24…

A:

Q: x 0.324 0.443 0.979 0252 0.184 0.257 0.393 256 346 581.6 633.3 630 165 596.6 Oraws a curve with the…

A: Following are the given points. x y 0.324 256 0.443 348 0.979 581.6 0.252 633.3 0.184…

Q: Draw the influence lines for the structure shown below,mark the values at peaks.

A: GIVEN: TO FIND: ILD OF FOLLOWING

Q: m 3. Determine the following unknowns on the beam shown below using Conjugate-Beam Method.  Consider…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: A 2-m-long, cantilevered beam has a 4 kN load applied at its free end and a 2 kN load applied at the…

A:

Q: A prestressed concrete rectangular beam of size 300 x 900 mm is prestressed with an initial…

A: Given a prestressed concrete rectangular beam of Size, A = 300×900 mm. b=300 mmd=900 mm Initial…

Q: At the proportional limit, a 20-mm-thick x 75-mm-wide bar elongates 5.4 mm under an axial load of…

A: Given data in question  Load 525 kN Length 1.6 m Poissons ratio 0.32  Cross section 20×75 mm To find…

Q: 2. A rectangular beam has b=300 mm and an effective depth of 490mm concrete compressive strength f'c…

A: Given, b = 300 mm  d = 490 mm  f'c = 27.6 MPa  fy = 276 MPa  Mu = 100 kN m

Q: need shear and bending moment diagram for this problem please! will rate

A: Given:- To find:- Shear force and bending moment diagram Concept:- Shear force diagram (SFD) and…

Q: 1 A tensile load of 40 KN is acting on a rod of diameter 40 mm and of length 4m. A bore of diameter…

A:

Q: The length of chain measured with a chain was found to be 250 m. If the length of chain was measured…

A: Given: Length of chain measured, L' = 250 m Actual length of chain, l = 30 m The chain was 10 cm…

Q: The Liquid Limit and Plastic Limit of sample are 40% and 30% respectively. If 20% of the soil is…

A: Given data :- Liquid limit of the soil = LL= 40% Plastic limit of the soil = PL = 30% If 20% of the…

Q: A prestressed concrete rectangular beam of size 300 x 900 mm is prestressed with an initial…

A:

Q: Three reservoirs are interconnected as shown. Calculatethe discharge in each pipe.

A:

Q: Show min weld strength (kips/in) of the nominal size of the fillet weld from 1/8" to ¾” with SMAW.…

A: To determine the minimum weld strength (kips/in) of a fillet weld, we need to consider the size of…

Q: P8.20. (a) Compute the vertical deflection and slope of the cantilever beam at points B and C in…

A: Finding deflection at point B : considering beam with uniformly distributed load with help of double…

Q: A tensile member consists of 2 ? 4 x 3 x 1/2 carries a service dead load of 50 k and live load of…

A:

Q: 3.25 Compute the moment of the force F about point A for the conditions shown. 5'-0" 60° F = 150 lb…

A:

Q: P9.4. Compute the reactions for the beam in Figure P9.4. El is constant. Use support B as the…

A: Reference : Structural Analysis, Computation of reactions Given data : UDL acting on beam AC To…

Q: Using the method of sections, answer the problem below: Indicate all zero force members and…

A: A truss is given.  The truss is externally determinate. Therefore the support reactions can be…

Q: H.W5: A cast-iron channel supported at two points, 11 m apart, carries water as shown in figure…

A:

Q: Problem. A column shown in the figure below is reinforced by an 8-20mm diameter rebar. Assuming…

A: Answer  Based on the given data we can use the Interaction curve in order to obtain the ultimate…

Q: Determine the P and P/, for each of the columns, using the AISC Specification and F, = 50 ksi, 5-9.…

A: Steel W 10 x 77  Radius of gyration, r = 2.6 in Gross area, A =  22.6in2 Effective length, LC = kL =…

Q: A vinyl [E = 2.70 GPa; v = 0.42] block with width b = 40 mm, depth d = 80 mm, and height h = 210 mm…

A:

Q: A load of P 90 KN is supported by a structure consisting of rigid bar ABC, two identical solid…

A:

Q: 7-9. Determine the equations of the elastic curve using the coordinates x, and x, and specify the…

A: I have solved it in detail although somewhere i wrote the result directly after solving on…

Q: Design Values Perception/Reaction Time = 2 seconds Average Vehicle Length = 25 ft Lane Width = 12 ft…

A: As per Bartleby's guidelines we are supposed to answer only first question. Kindly repost other…

Q: A w=1 kip/mt L=40-0 P= 5 kips 8

A: A simply supported beam is given with UDL of 1kip/ft throughout the beam and a point load of 5kips…

Q: A partly saturated sample from a borrow pit has a natural moisture content of 20% and bulk unit…

A:

Q: Identify problem degrees of freedom and use Slope-Deflection equations to solve for displacements…

A: Given: Required : Degree of freedom  Displacement  Moment at A, B, C and D Shear and moment diagram…

Q: Water flows steadily through the funnel shown in the figure below. Throughout most of the funnel the…

A:

Q: 3.13 A 1200-ft equal-tangent crest vertical curve is currently designed for 50 mi/h. A civil…

A: Sight distance: The length of the road that is visible ahead to the driver from a specified height…

Q: For a total storm rainfall of 90 cm, total storm runoff was recorded as 20 cm. Taking initial loss…

A: Given that :- For a total storm  rainfall = P = 90 cm Runoff = Q = 20 cm Taking initial loss = ∆L =…

Q: A vinyl [E = 2.65 GPa; v = 0.41] block with width b = 60 mm, depth d = 120 mm, and height h = 320 mm…

A:

Q: A 20cm well penetrated directly into a confined aquifer of permeability 4.4x10-4 m/s is with a…

A: Given data- 20 cm well,Radius of well, rw=20/2=10 cmpermeabilityk=4.4×10-4 m/s,thicknessB=12 mradius…

Q: 780 MPa; v = 0.46] rod has a diameter of 90 mm before lo d must not exceed 92 mm when loaded. What…

A: Given data -  Young's modulus (E) = 780Mpa  Poisson's ratio (v) = 0.46  Diameter of rod (d) = 90 mm…

Q: (i) During BOD test conducted on a 5% dilution of waste, the following observations were taken. (1)…

A:

Q: Use the virtual work method to determine the horizontal and vertical components of the deflection at…

A:

Q: Assemblies' placement and interconnections have the greatest impact on which aspect of a…

A: Sociotechnical System A sociotechnical system (STS) is a complex system comprising both social and…

Q: 3.9 An equal-tangent crest curve connects a +2% initial grade with a −1% final grade, and is…

A: Answer  Grade g1 = 2% Grade g2 = -1% Design speed V = 55 mi/h Station at PVI = 233+40 Elevation of…

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.