! Q10 Quantitative ProblemThe State of Maryland is considering a requirement that for every ton of CO2 produced by out-of-state electricity producers, a permit costing $40 must be purchased. It takes approximately0.5 tons of coal to make 1 MWh of electricity, and every 1 ton of coal produces 2.86 tons of CO2.Write out the linear variable cost function for a coal-fired power plant in Ohio selling electricityto Maryland utilities which includes the permit cost assuming that the current cost of coal is$150 a ton and that this coal fired plant has an annual fixed cost of $1,000,000. (You may usethe variable q to denote quantity of electricity in MWh in the cost function.)Intermediate StepsEnter your answer here

Permit cost per ton of CO2 produced = $ 40 Coal consumed per MWh of electricity = 0.5 tons CO2…

Answered: O Quantitative Problem

Engineering

Electrical Engineering

O Quantitative Problem

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

predicts that coal will decrease from a 24% share of US electric generation in 2020 to a 13% share in 2050. This is while the total annual US electric generation is predicted to rise from about 4000 billion kWh in 2020 to about 5400 billion kWh in 2050. Growth in renewable energy sources are predicted to make up for the decline in coal-based electric generation. Using the figure of 1000 kg/MWh of CO2 , what is the expected reduction in annual CO2 emissions due to this decline in the coal-based generation?
Studies indicate that between the present and 2050, substantial growth in population and energy consumption will occur both in less developed countries (LDCs) like India and China and in more developed countries (MDCs) like the United States and Japan. The table below displays these projections. Describe the process by which fossil fuels are used to provide electrical energy.
Estimate the AEP for a 3-MW wind turbine in a wind regime that has a CF= 30%. For this turbine explain why the increase of wind speed to levels greater than 25 m/s generates less electrical power compared to wind speeds around 11 m/s
A hydroelectric power station is supplied from a reservoir having an area of 50 km2 and ahead of 50 m. If overall efficiency of the plant is 60%, find the rate at which the water levelwill fall when the station is generating 30000 kW.
Q 03: Briefly discuss, how the energy consumptions for operations of a fork lifter could be justified. Suppose that a fork lifter has a total energy consumption of 150 W.Hr. The total trips of the vehicle are 375. How the battery duty cycle may be calculated in this case?
When electricity is transported from a power station to a city, the line voltage (relative to ground) is usually on the order of several hundred thousand volts. A power line cable has a radius of a = 2.0 cm, is made of aluminum with a resistivity of ρ = 2.7×10−8 Ω ⋅ m, and spans a distance of l = 100 km from a power station to a city. The city consumes 100 MW of power (so I2RL =100MW). (a) Find the resistance of the power cable between the station and the city(i.e.,between points A and B). (b) Suppose that the line voltage ∆VBC = 120 V. i. How much current is required to flow through the power line to deliver 100MW of power to the city? ii. How much energy is lost as heat between points A and B? (c) Suppose that the line voltage ∆VBC = 300 kV. i. How much current is required to flow through the power line to deliver 100MW of power to the city? ii. How much energy is lost as heat between points A and B?
A large electric utility company spews 62 million tons of greenhouse gases (mostly carbon dioxide) into the environment each year. This company has committed to spending $1.2 billion in capital over the next five years to reduce its annual emissions by 5%.More will be spent after five years to reduce greenhouse gases further. Solve, a. What is the implicit cost of a ton of greenhouse gas? b. If the United States produces 3 billion tons of greenhouse gases each year, how much capital must be spent to reduce total emissions by 3% over the next five years based on your answer in Part (a)?
A non-adiabatic tank receives paddle work for 30 min. The power varies with time according to Ẇp = 12t, where Ẇp is in watts and t is in minutes. In addition there is heat transfer from the tank at a constant rate of 170 Btu/hr. Determine the net change of the gas’s energy (in kJ) after the 30 min.
Estimate the total land requirements for wind farms generating an amount of electric energy equal to 2008 US annual consumption (4.4 × 1012 kWeh) if individual units are rated at 2 MWe, have a rotor with a 100 m diameter, and are spaced 3 diameters side to side, 10 diameters front to rear in giant contiguous wind farms having an annual average capacity factor of 25%. Compare the required area to that of North and South Dakota (combined land area of 145,000 square miles), which have some of the best US wind resources. Discuss the factors that would favor or impede the practical implementation of a Grand Midwestern Wind Farm plan to provide the bulk of US electric energy by the year 2050.
6.A 50-liter hot-water tank is used in the laundry service of a hospital clinic. The water in the tank is heated up using an electrical heater that is operated from 200V (mains) power line. The heater draws 5A from the mains. Assume that the thermal resistance of the tank is Rt=0.04 °C/W. The temperature of the tap water is 10C. How much is the maximum temperature of the water in the tank in the steady state? The original of the problem is attached.
The selected coal was tested and found to be able to produce heat of 67.4 MJ at a quantity of 2 kg. The coal is to be used at a 50 kW generation power station that has an overall efficiency of 25%. The load demands the maximum capacity of the power station at a daily load factor of 56.2%. (Assume that 1 kWh=861kcal) 7. Determine the calorific value of coal (kcal/kg) & the required heat of coal per kWh (kcal) 2.Determine the coal consumption per kWh (kg) 3.Determine the coal consumption per day (tonnes)
A 50-liter hot-water tank is used in the laundry service of a hospital clinic. The water in the tank is heated up using an electrical heater that is operated from 200V (mains) power line. The heater draws 5 A from the mains. Assume that the thermal resistance of the tank is Rt=0.04 ℃/W. The temperature of the tap water is 10 ℃. How much is the maximum temperature of the water in the tank in the steady state?