Answered: Obtain the most probable distribution…

Obtain the most probable distribution of N molecules of an ideal gas contained in two equal and connected volumes at the same temperature by minimizing the Helmholtz free energy for the two systems.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter20: Kinetic Theory Of Gases

Section: Chapter Questions

Problem 2PQ

See similar textbooks

Similar questions

Consider the Maxwell-Boltzmann distribution function plotted in Problem 28. For those parameters, determine the rms velocity and the most probable speed, as well as the values of f(v) for each of these values. Compare these values with the graph in Problem 28. 28. Plot the Maxwell-Boltzmann distribution function for a gas composed of nitrogen molecules (N2) at a temperature of 295 K. Identify the points on the curve that have a value of half the maximum value. Estimate these speeds, which represent the range of speeds most of the molecules are likely to have. The mass of a nitrogen molecule is 4.68 1026 kg. Equation 20.18 can be used to find the rms velocity given the temperature, Boltzmanns constant, and the mass of the atom or molecule. The mass of a nitrogen molecule is 4.68 1026 kg. vrms=3kBTm=3(1.381023J/K)4.681026kg=511m/s Using the results of Problem 28 and the rms velocity, we can calculate the value of f(v). f(vrms) = (3.11 108)(511)2 e(5.75106(511)2) = 0.00181 The most probable speed, for which this function has its maximum value, is given by Equation 20.20. vmp=2kBTm=2(1.381023J/K)(295K)4.681026kg=417m/s f(vmp) = (3.11108)(417)2 e(5.75106(417)2) = 0.00199 We plot these points on the speed distribution. The most probable speed is indeed at the peak of the distribution function. Since the function is not symmetric, the rms velocity is somewhat higher than the most probable speed. Figure P20.29ANS
An ideal gas has a pressure of 0.50 atm and a volume of 10 L. It is compressed adiabatically and quasi-statically until its pressure is 3.0 atm and its volume is 2.8 L. Is the monatomic, diatomic, or polyatomic?
Under what circumstances would you expect a gas to behave significantly differently than predicted by the ideal gas law?
Find (a) the most probable speed, (b) the average speed, and (c) the rms speed for nitrogen molecules at 295 K.
Give the temperature T of 1 mole of ideal gas as a function of the pressure P, volume V, and the gas constant R and give the internal energy U of a rigid diatomic ideal gas as a function of its temperature T and the gas constant R.
In this problem you are to consider an adiabaticexpansion of an ideal diatomic gas, which means that the gas expands with no addition or subtraction of heat. Assume that the gas is initially at pressure p0, volume V0, and temperature T0. In addition, assume that the temperature of the gas is such that you can neglect vibrational degrees of freedom. Thus, the ratio of heat capacities is γ=Cp/CV=7/5. Note that, unless explicitly stated, the variable γshould not appear in your answers--if needed use the fact that γ=7/5 for an ideal diatomic gas. Find an analytic expression for p(V), the pressure as a function of volume, during the adiabatic expansion. Express the pressure in terms of V and any or all of the given initial values p0, T0, and V0. p(V) = __________
In this problem you are to consider an adiabaticexpansion of an ideal diatomic gas, which means that the gas expands with no addition or subtraction of heat. Assume that the gas is initially at pressure p0, volume V0, and temperature T0. In addition, assume that the temperature of the gas is such that you can neglect vibrational degrees of freedom. Thus, the ratio of heat capacities is γ=Cp/CV=7/5. Note that, unless explicitly stated, the variable γshould not appear in your answers--if needed use the fact that γ=7/5 for an ideal diatomic gas. A) Find an analytic expression for p(V), the pressure as a function of volume, during the adiabatic expansion. Express the pressure in terms of V and any or all of the given initial values p0, T0, and V0. p(V) = __________ B) At the end of the adiabatic expansion, the gas fills a new volume V1, where V1>V0. Find W, the work done by the gas on the container during the expansion. Express the work in terms of p0, V0, and V1. Your…
A diatomic ideal gas at pressure p and volume V is expanding to three times its initial volume under constant pressure. W=2pV. a) If the initial temperature equals T, express the final temperature Tf in terms of the original temperature T. b) In terms of p and V, calculate the expression of the heat Q flowing into the gas. c) In terms of p and V, calculate the expression of the change in internal energy ΔU.
The only form of energy possessed by molecules of a monatomic ideal gas is translational kinetic energy. Using the results from the discussion of kinetic theory in Section 10.5, show that the internal energy of a monatomic ideal gas at pressure P and occupying volume V may be written as U = 3/2PV
A diatomic ideal gas at pressure p and volume V is expanding to three times its initial volume under constant pressure. If the initial temperature equals T, express the final temperature Tf in terms of the original temperature T. In terms of p and V, calculate the work W done by the gas. In terms of p and V, calculate the heat Q flowing into the gas.
A container with rigid walls holds n moles of a monatomic ideal gas. In terms of n, how many moles of the gas must be removed from the container to double the pressure while also doubling the rms speed of the gas atoms?
An amount of n moles of a monatomic ideal gas in a conducting container with a movable piston is placed in a large thermal heat bath at temperature T1 and the gas is allowed to come to equilibrium. After the equilibriumis reached, the pressure on the piston is lowered so that the gas expands at constant temperature. The process is continued quasi-statically until the final pressure is 4/3 of the initial pressure p1. (a) Find the change in the internal energy of the gas. (b) Find the work done by the gas. (c) Find the heat exchanged by the gas, and indicate, whether the gas takes in or gives up heat.