(1-8) Find the diffusion coefficient of holes and electrons for Germanium at 300 k. Themobilities in cm2/v-s at 300 k for electrons and holes are respectively 3600 and 1700. Density of carriers is2.5x 1023/m .Boltzmann constant K=1.38 x 1023.carrier

Answered: Image /qna-images/answer/64e201e3-8348-4e57-bfbb-d2da9a9b5a02.jpg

Answered: of holes and electrons for Germanium at…

of holes and electrons for Germanium at 300 k. The lectrons and holes are respectively 3600 and 1700. Der stant K=1.38 x 1023.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.2P: The temperature dependence of resistance is also quantified by the relation R2=R1[ 1+(T2T1) ] where...

See similar textbooks

Related questions

Q: na single phase AC capacitor start and run induction motor, to make the rotation in anti-clockwise…

A: In a single phase AC capacitor start and run induction motor to make the rotation in anti clock wise…

Q: Q3. A\ Specify the possible causes of low Oz sensor voltage. Q3. B\ State the inspection steps for…

A: Given We need to specify the possible causes of low O2 voltage. Please find the below attachment…

Q: own opinion, What 3 characteristics/features of microprocessor that future designers should focus…

A: In these days microprocessor are extensively used in almost every electronics gadgets .And in order…

Q: 02-In the below circuit the zener diode acts as voltage regulator. Given that V,=12V and the zener…

A: Brief description : Here they have mentioned a zener voltage regulator circuit which is used to…

Q: What is the value of V* in the following Op-AMP circuit. 10 kN 1 kN 20 V 2 kN

A: Op-Amp is known as operational amplifier. It has two terminals namely inverting and non-inverting.…

Q: 4 - Define diffrentiator

A: Operational amplifier can be used as Integrator Summer Differentiator Voltage amplifier Current…

Q: Example XL Determine the power factor and the true ll power (average power) in the shown circuit :…

A: given here a circuit and asked to calculate the power factor and average power. and given voltage is…

Q: In source transformation, the voltage source with a series resistor can be replaced with a current…

A: According to source transformation method, The voltage source with series resistor can be replaced…

Q: To eiminae he hamonic votage fro the phase votage of anatemao, he cols ne to be hot pthed by…

Q: Given the circuit shown, determine the current in each branch 100 V/60 Hz/0 Deg (+? I1. 50 uF 35 Ohm…

Q: 2. Consider an LTI system with x [n] = 5 cos( 0.5nn) h[n] = ()" u[n] and find y[n] where y [n] = H…

Q: b) Use Karnaugh maps to simplify the following Boolean functions expressed in the sum of minterms. f…

A: Given Boolean function, fw,x,y,z=∑1,2,4,5,6,7,9,12,13

Q: * In hollow rectangular waveguides the phase velocity is greater than the group velocity the phase…

Q: Solve the power triangle at Z3 using the following network law below. Thanks in advance!!! 2.)…

A: Power triangle at Z3 using Kirchoff's Law We have to find Active, reactive and apparent power…

Q: In a single phase AC capacitor start and run induction motor, to make the rotation in anti-clockwise…

A: Single phase induction machine is not self starting machine The net torque at the starting equals to…

Q: if you design differentiator to differentiate input signal varies in frequency between 1 KHz and 20…

A: Given An differentiator using opamp and it's input frequency range and input signal,we need to…

Q: USE MESH ANALYSIS IN THE FIGURE SHOWS BELOW TO FIND THE VOLTAGE IN Z2. Z3 Z1 Vs2=20230 Vs1=10210 Z4…

A: We assume unit of given Voltage sources as "Volts" and unit of given impedances as "ohms".

Q: For the following circuit shown in figure1, find an expression for Vout R2 v2 R1 v1 w R3 Vout V3 W…

Q: Q2 In step-down regulator in Figure below, calculate the output voltage if the switching frequency…

A: Step Down Switching Regulator: The output voltage is compared to the reference voltage to see if…

Q: In closed loop control system, that the system is unstable C the output has an effect upon the…

Q: 1) Use the K-map to simplify the following function: fA, В, С, D) 3 2 m (0, 5, 7, 8, 10, 12, 14, 15)

A: K-map or Karnaugh Map are used to simplify the Boolean expression .In this we used min terms so…

Q: Make the mathematical calculations, using the transformation ratio equations, to compare the results…

A: In this question we need to find current through each transformer ( primary side and secondary side…

Q: For the system shown in Figure below, find the output C(t) (in Time Domain) r(t) = 2u(t) 20 e(t) S…

Q: In the circuit below VA-B = 48.3 /30° What is the value of V1? U1 B j40 j8.66N X

Q: A given monocrystalline silicon solar cell has the following specifications: Isc=5 A and Voc=0.6 V.…

A: Given that Voc=0.6VISC=5An=25 Although, All are connected in series Hence,…

Q: Find the basis functions of the two sighais OSISI S()% 1 S, (1) =e 0SISI

Q: For the JFET amplifier shown in figure 3, calculate the gain voltage with Rs in two conditions:…

Q: The word 'success' has no adjective. O True False

A: Adjective: Adjectives seem to be words that provide additional information about either a pronoun or…

Q: Determine the value of Voltage V2. 0.6 A 15 0 12 V 9Ω V2 0.125 V 0.525 V O 1.125 V O 1.925 V 3 925 V

A: Given, The circuit is

Q: 3. A single-phase 30KVA, 2000V/200V, 60HZ distribution transforme transformer at the load end of a…

A: The transformer problem can be solved as below.

Q: The voltage regulation can be equal to zero :when .The t and current is not too highO .The p.f. is…

Q: For the circuit shown in the Figure, if R1=8 , R2=6 Q, and C=0.2 F, and if i = A + Bet, answer the…

A: Fig: Given circuit Although , It is given that voltage source is…

Q: The cut-off frequency of a waveguide depends on dimensions of the waveguide wave mode C the…

Q: 1.5 mH is 50 N 0.25 µF 30 N 1:53 PM arch | 90% 59°F 5/14/2022

Q: 4. Use The Routh- Hurwitz Criterion to determine Following Systems are Stable or Not? Why? S* + 353+…

A: Given, The characteristics equation is s4+3s3+5s2+6s+8=0

Q: 14. A voltmeter with high internal resistance is more accurate than with low internal resistance? A)…

Q: A 55 hp, 440 V, 400 rpm DC shunt motor draws 107 A when operating at rated conditions. The motor has…

Q: Q4: A small sphere, rolling with an initial velocity of 9 m/s, moving up a plane inclined 30° with…

A: initial velocity : The velocity at time interval t = 0 is indicated by the symbol u. It is the speed…

Q: What is the impedance of a 50uH inductor at f=10,000HZ? jo.5 jo.318 j2 j3.14

Q: Q5: Use a Karnaugh map simplify the Boolean function F(A,B,C) = Em(0,1,2,3,4,5)

Q: Identify the transfer function IA, of the RL circuit shown below. Express the transfer function…

A: Given: A parallel RL circuit Use ω0=R/L

Q: FIND Io in THE CIRCUIT. 6LOA jer 30430V 8.2 jq

A: Kcl problem can be done

Q: a). If it is known that the total traction force in the Bung Tomo circuit is 231.9 N, what is the…

A: Given information, The total traction force in the Bung Tomo circuit is F=231.9 N. Radius of the…

Q: Calculate the resistance and power rating of a resistor that is required to operate a super blue LED…

Q: Consider the parallel RLC circuit

Q: 4. The current i, in the circuit Fig 4 is 4A is, iz is is and ig Viand Vz. o 25 0 4 50 W- 13 10 Q…

A: For the given circuit calculation of all parameters if current I0=4 A To solve such type of…

Q: 1 kN +, 20V 2 kN . 20V . 2V +1

A: In this question the basic understanding operational amplifier is being discussed.It is no -…

Q: How experimental setup is prepared for a CE transistor configuration. Draw its a h-parameter model.…

A: Since you have posted a question with multiple subparts, we will draw the experimental setup and two…

Q: AQ-meter is supplied with an oscillator having a 500 mV output voltage, While testing an unknown…

A: Given a Q-meter is supplied with an oscillator having, Output voltage, V=500 mV Voltage across…

Q: gure 1 of 1 R 10 V < Retu

Concept explainers

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.

Question

(1-8) Find the diffusion coefficient of holes and electrons for Germanium at 300 k. The
mobilities in cm2/v-s at 300 k for electrons and holes are respectively 3600 and 1700. Density of carriers is
2.5x 1023/m .Boltzmann constant K=1.38 x 1023.
carrier

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Semiconductor Material and Its Energy Band Analysis

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Suppose the hole concentration in silicon sampleis described mathematically by p(x) = 105+1019 exp(− x/ Lp) holes/cm3, x ≥ 0 in which Lp is known as the diffusion length for holes and is equal to 2.0 μm. Find the diffusion current density for holes as a function of distance for x ≥ 0 if Dp = 15 cm2/s. What is the diffusion current at x = 0 if the cross-sectional area is 10 μm2?
Problem 10. Given a piece of Si doped with B to a level of 1015 atoms/cm3, (a) what carrier moves with a higher mobility (including why), and (b) How would this change if the dopant were P instead of B?
The electron number density in a semiconductor varies from 1020 m-3 to 1012 m-3 linearly over a distance of 4 μ Determine the electron diffusion current and electric field at the midpoint if no current flows, μе = 0.135 m2V-1s-1 and T = 300 K.
InP is composed of equal atoms of indium and phosphorus in a lattice similar to that of silicon. (a) Suppose a germanium atom replaces an indium atom in the lattice. Do you expect the germanium atom to behave as a donor or acceptor impurity? Why? (b) Suppose a germanium atom replaces a phosphorus atom in the lattice. Do you expect the germanium atom to behave as a donor or acceptor impurity? Explain.
What is the relation between the diffusion coefficient of election and the mobility of electron? What will be the modified form of the relation at 300 K temperature?
conducting line on an IC chip is (2.8 mm) long, and has a rectangular cross-section (1x 4 um). A current of (5 mA) produces a voltage drop of (100 mV) across the line. Determine the electron concentration given that the electron mobility is (500 cm²/V.Sec.).
Neglecting losses and fringing effects and assuming the substrate of a stripline to have a thickness of 0.42 (mm) and a dielectric constant of 2.83, determine the required width (in mm) of the metal strip in order for the stripline to have characteristics resistance of 78 Ohms. No need for a solution. Just write your numeric answer in the space provided. Round off your answer to 2 decimal places.
Please explain temperature dependence of carrier concentration on metals and semiconductors separately.
A) Explain briefly various theories of breakdown in liquid dielectrics. B) What are the requirements of a sphere gap for measurement of high voltages? Discuss the advantages and disadvantages of sphere gap for measurements. C) Determine the Townsend’s first ionization coefficient if a steady current of 500 ?A flows through the plane electrode separated by a distance of 0.4cm when a voltage of 10 kV is applied. A current of 25 ?A flows when the distance of separation is reduced to 0.1 cm and the field is kept constant at the previous value. Find also the value of γ if the breakdown took place when the gap distance was changed to 0.7 c
Find the total charge in mC of a cylindrical conductor (solid wire) 1 meter long and a diameter of 2mm. Given also its charge density (De) is 10^29 carriers/m^3 and its carrier velocity (u) is 19.9x10^-6 m/s
(1) What is normally the origin of majority charge carriers? and of minority charge carriers? (2) How does one estimate the overall (net) charge in a piece of extrinsicsemiconductor where we have both majority and minority carriers?
A sonar beam travels in a fluid for a distance of 200 m in 0.12 s. The bulkmodulus of elasticity for the fluid is about 2600 MPa. What is the density ofthe fluid?