"One end of a steel rod of radius R = 10mm and length L = 90 cm is held in a vise. A force of magnitude F = 70000 N is then applied perpendicularly to the end face (uniformly across thearea) at the other end, pulling directly away from the vise. What will be the elongation of the rod (in the unit meters)? Young modulus is 200 x 109 N/m²)"1.0 x 10-33.4 x 10-4O 4.6 x 10-4O 2.7 x 10-4

"One end of a steel rod of radius R = 10mm and length L = 90 cm is held in a vise. A force of magnitude F = 70000 N is then applied perpendicularly to the end fa area) at the other end, pulling directly away from the vise. What will be the elongation of the rod (in the unit meters)? Young modulus is 200 x 10° N/m²y" n 1.0 x 10-3

"One end of a steel rod of radius R = 10mm and length L = 90 cm is held in a vise. A force of magnitude F = 70000 N is then applied perpendicularly to the end fa area) at the other end, pulling directly away from the vise. What will be the elongation of the rod (in the unit meters)? Young modulus is 200 x 10° N/m²y" n 1.0 x 10-3

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter14: Static Equilibrium, Elasticity, And Fracture

Section: Chapter Questions

Problem 52PQ

See similar textbooks

Similar questions

Alarge uniform cylindrical steel rod of density =7.8g/cm3 is 2.0 m long and has a diameter of 5.0 cm. the rod is fastened to a concrete floor with its long axis vertical.what is the normal stress in the rod at the cross-section located at (a)1.0 mfrom its lower end?(b)1.5 m from the lower end?
An aluminium (=2.7g/cm3) wire is suspended from the ceiling and hangs vertically. How long must the wire be before the stress at its upper end reaches the proportionality limit, which is 8.0107N/m2 ?
By how much does a 65.0kg mountain climber stretch her 0.800cm diameter nylon rope when she hangs 35.0m below a rock outcropping? (For nylon, Y=1.35109Pa. )
Can Young’s modulus have a negative value? What about the bulk modulus?
Review the relationship between stress and strain. Can you find any similarities between the two quantities?
A steel cable 2.00 m in length and with cross-sectional radius 0.350 mm is used to suspend from the ceiling a 10.0-kg model aircraft that is flying in a horizontal circle with an angular speed of 6.00 rad/s. What is the strain produced in the cable?
Normal forces of magnitude 1.0106N are applied uniformly to a spherical surface enclosing a volume of a liquid. This causes the radius of the surface to decrease from 50.000 cm to 49.995 cm. What is the bulk modulus of the liquid?
Assume Youngs modulus for bone is 1.50 1010 N/m2. The bone breaks if stress greater than 1.50 108 N/m2 is imposed on it. (a) What is the maximum force that can be exerted on the femur bone in the leg if it has a minimum effective diameter of 2.50 cm? (b) If this much force is applied compressively, by how much does the 25.0-cm-long bone shorten?
A copper rod with length 1.4 m and cross-sectional area 2.0 cm2 is fastened to a steel rod of length L and cross-sectional area 1.0 cm2. The compound structure is pulled on each side by two forces of equal magnitude 6.00 104 N (Fig. P14.57). Find the length L of the steel rod if the elongations (L) of the two rods are equal. Use the values Ysteel = 2.0 1011 Pa and YCu = 1.1 1011 Pa. FIGURE P14.57
What Is Static Equilibrium? Problems 13 are grouped. 1. C A ball is attached to a strong, lightweight rod (Fig. P14.1). The rod is supported by a horizontal pin near the top. The ball is at rest. Is the ball in static equilibrium? If not, why not? If so, which type of equilibrium is itstable, unstable, or neutral? Hint: What would happen if you displaced the ball slightly? FIGURE P14.1
Can compress stress be applied to a rubber band?
A 90-kg mountain climber bangs from a nylon rope and stretches it by 25.0 cm. If the rope was originally 30.0 m bog and its diameter is 1.0 cm, is Young’s modulus for the nylon?