One of the engineers in the electric-power industry came up with the idea of using inductors to store electrical energy generated during low-demand hours to help meet customer requirements during high-demand hours. What inductance would be needed to store adequate electrical energy to run a 1000 W heater for one hour using an inductor carrying a 200 A current? Elektrik enerjisi sektöründeki mühendislerden biri, talebin yüksek olduğu saatlerde müşteri gereksinimlerini karşılamaya yardımcı olmak adına düşük talep saatlerinde üretilen elektrik enerjisini depolamak için indüktörler kullanma fikrini ortaya atmıştır. Bir indüktör kullanarak 1000 W'lik bir ısıtıcıyı bir saat boyunca çalıştırmak için yeterli elektrik enerjisini 200 A akımda depolamak için gerekli indüktans değeri nedir? 50 H 2.5 H 0.8 H 90 H 25 H 0.05 H 360 H 180 H 100 H

One of the engineers in the electric-power industry came up with the idea of using inductors to store electrical energy generated during low-demand hours to help meet customer requirements during high-demand hours. What inductance would be needed to store adequate electrical energy to run a 1000 W heater for one hour using an inductor carrying a 200 A current? Elektrik enerjisi sektöründeki mühendislerden biri, talebin yüksek olduğu saatlerde müşteri gereksinimlerini karşılamaya yardımcı olmak adına düşük talep saatlerinde üretilen elektrik enerjisini depolamak için indüktörler kullanma fikrini ortaya atmıştır. Bir indüktör kullanarak 1000 W'lik bir ısıtıcıyı bir saat boyunca çalıştırmak için yeterli elektrik enerjisini 200 A akımda depolamak için gerekli indüktans değeri nedir? 50 H 2.5 H 0.8 H 90 H 25 H 0.05 H 360 H 180 H 100 H

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter32: Inductance

Section: Chapter Questions

Problem 32.4CQ

See similar textbooks

Similar questions

The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
(a) An inductor designed to filter high-frequency noise from power supplied to a personal computer is placed in series with the computer. What minimum inductance should it have to produce a 2.00 k(reactance for 15.0 kHz noise? (b) What is its reactance at 60.0 Hz?
Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 M (a) What is the inductance of the circuit? (b) What resistance would give you a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.
One application of an RL circuit is the generation of lime-varying high voltage from a low-volt age source as shown in Figure P32.82. (a) What is the current in the circuit a long time after the switch has been in position a? (b) Now the switch is thrown quickly from a to b. Compute the initial voltage across each resistor and across the inductor. (c) How much time elapses before the voltage across the inductor drops to 12.0 Y?
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
(a) What is the characteristic time constant of a 25.0 mH inductor that has a resistance of 4.00 ? (b) If it is connected to a 12.0 V battery, what is the current after 12.5 ms?
Check Your Understanding The angular frequency of the oscillations in an LC circuit is 2.0103rad/s . (a) If L = 0.10H, what is C? (b) Suppose that at t = 0, all the is stored in the inductor. What is the value of ? (c) A second identical capacitor is connected in parallel with the original capacitor. What is the angular frequency of this circuit?
A radio receiver uses an RLC circuit to pick out particular frequencies to listen to in your house or car without hearing other unwanted frequencies. How would someone design such a circuit?