One of the index place of a milling machine dividing head has the following hole circler 15, 16 17, 18, 19, 20. A gear wheel of 34 teeth has to be milled by simple indexing method. To machine each tooth, the index crank has to be rotated through (a) 17 holes is the 20-hole circle (b) 18 holes is the 20-hole circle (c) 1 revolution and 3 holes in 17-hole circle (d) 1 revolution and 2 holes in 18-hole circle

One of the index place of a milling machine dividing head has the following hole circler 15, 16 17, 18, 19, 20. A gear wheel of 34 teeth has to be milled by simple indexing method. To machine each tooth, the index crank has to be rotated through (a) 17 holes is the 20-hole circle (b) 18 holes is the 20-hole circle (c) 1 revolution and 3 holes in 17-hole circle (d) 1 revolution and 2 holes in 18-hole circle

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Please solve the question on the sheet and get a clear picture and submit the picture. thankyou
Please solve the question on the sheet and get a clear picture and submit the picture. thankyou
Write the Compatibility Equations?
In a lathe machine, The diameter of the driver and driven pulley are 2745 mm and 1200 mm respectively, And the driver pulley runs at speed of 225 rpm. Find the speed at which is driven pulley runs in the machine. the speed of the driven pulley in rpm is
Statics of Rigid Bodies Note: If you have already answered the problems in this post, kindly ignore it. If not, then answer it. Thank you, Tutor! Content Covered: - Method of Joints Direction: Create two problems based on the topic "Method of Joints" and then solve them with a complete solution. In return, I will give you a good rating. Thank you so much! Note: Please bear in mind to create two problems based on the topic "Method of Joints." Be careful with the calculations in the problem. Kindly double check the solution and answer if there is a deficiency. And also, box the final answer. Thank you so much!
please show all the work with diagrams
a) If a pneumatic cylinder -driven power tool has the following data as shown in Table 1, determine the rate of reciprocation in rpm. Table 1 Piston diameter 44.5 mm Piston stroke 152 mm Air pressure and temperature (at the 687 kPa gauge and 27°C pneumatic cylinder Available flow rate 0.05 m³/min (at standard atmospheric conditions of 101 kPa and 20°C)
kinetics of particles-relative motion report
4. What are the theorems of Papus and Guldinus used for?
Find warrk done
Would the plank and the roller have the same acceleration why or why not?
a diagonal of a polygon is a line segment that connects nonadjacent vertices of the polygon.in the following polygons, a triangle has 3 sides and 0 diagonal, a quadrilateral has 4 sides and 2 diagonals, a pentagon has 5 sides and 5 diagonals, a hexagon has 6 sides and 9 diagonals. predicts the number of diagonals in a 12-sided polygon.