One person sends one 8MB file from his computer to his friend computer. The network used circuit switching technique with TDM.5 slots are there. Bit rate of network is 2 Mbps. Network take average time to set up circuit 3 seconds. What is the total time needed to transfer the file? Ignore if there is any delay.

One person sends one 8MB file from his computer to his friend computer. The network used circuit switching technique with TDM.5 slots are there. Bit rate of network is 2 Mbps. Network take average time to set up circuit 3 seconds. What is the total time needed to transfer the file? Ignore if there is any delay.

Computer Networking: A Top-Down Approach (7th Edition)

7th Edition

ISBN:9780133594140

Author:James Kurose, Keith Ross

Publisher:James Kurose, Keith Ross

Chapter1: Computer Networks And The Internet

Section: Chapter Questions

Problem R1RQ: What is the difference between a host and an end system? List several different types of end...

See similar textbooks

Related questions

Q: We are using the selective repeat ARQ for sending the file from point A to point B. The file size is…

A: Introduction :Given , Selective repeat ARQ implementation file size = 500 KB frame size = 20 B…

Q: the question i am having trouble with is: you are designing an application at work that transmits…

A: Design the application at work and it must transmit data records to another building within the same…

Q: In a connection, data can be either sent or received on the wire but not at the same time Select…

A: In a ............ Connection data can be either sent or received on wire but not at the same time.

Q: In a connection, data can be either sent or received on the wire but not at the same time Select…

A: Here in this question we have asked the connection name in which data can be sent or received on the…

Q: chooses K = 4? The result K = 4 corresponds to a delay of how many seconds on a 10 Mbps Ethernet?

A: The required answer is as follows

Q: what the total time required to send 5000 bytes across a 3000 kilometers link at 1 Mbps?use a signal…

A: The transmission time (Tt) = L/B = Length of the data / Bandwidth The propagation time (Tp) = d /…

Q: Given a effective delay of 20ms when network usage is 38%, what is the effective delay when network…

A: The answer is in step 2:

Q: is transmitting on Ethernet. Write the bit stream in the order of transmitting.

A: Assume that 8 bits of data "10011101" is transmitting on Ethernet. Write the bit stream in the…

Q: Four computers are sending the digital data over a multiplexed line as shown in the Figure below.…

A: A) Multiplexing is the process of combining multiple signals into one signal, over a shared medium.…

Q: Answer Four only, choose right or false In Paging system, message may be either text or voice…

A: Since it is a multipart question, we are only allowed to answer the first 3 subparts of it.

Q: Stations in network send frames of size 1000 Bytes at the rate of 10 Mbps. What is the vulnerable…

A: Required: Stations in network send frames of size 1000 Bytes at the rate of 10 Mbps. What is the…

Q: You are required to develop a MAC protocol for an access network in which N nodes continually…

A: Given: You are required to develop a MAC protocol for an access network in which N nodes continually…

Q: If we first send a 10 MB package over a 200 km long, 10Mbps link and later send a 50,000-bit package…

A: Propagation delay Propagation delay is the amount of time required for the head of the signal to…

Q: An IV is sent in the clear in every frame in Wired Equivalent Privacy (WEP).True or False.

A: To be determine: True or False

Q: An IEEE802.11g with 54 Mbps has 58 byte MAC header and 50 byte IP header, the antenna has…

A: When causation little packets, 802.11 protocol overhead becomes vital, that hampers performance.…

Q: Perform the following Assign switch ports to Vlans on (swictch 0/ switch1) Determin which orts have…

A: Addressing Table Device Interface IP Address Subnet Mask VLAN PC1 NIC…