OR e) What is BILS? Explain their significance in power system studies.

Q: QUESTION 2 Q2: Find the equivalent resistance of the given network between terminals A and B. All…

A: Given circuit,

Q: R$ 2k Q1 +9v RE Cc Rc RL

A:

Q: A signal has a single-sided bandwidth of W = 10 kHz. If this signal is sampled at the Nyquist rate…

A: Given: A signal has bandwidth, W=10 kHz Nyquist rate, fs=2W samples/sec Bits, n=3

Q: Q2:- in electric circuit the current (5m A) when the voltage (1V) finds the value of current for the…

A:

Q: OR e) Describe the working principle of SF6 circuit breaker and discuss the advantages and…

A: SF6 is  gas which  is compressed and filled in a tank. Whenever there is a fault conditions, the…

Q: Difference between KVL and KCL

A:

Q: the resistance

A:

Q: R 8១ រ = — ja

A: Curcuit behave like resistive at resonances condition Total inductive reactance equal to total…

Q: 1. Using Norkons resistor of ike 40v Theorem network Shown Find the Current below 4.5 62 52 A $. B…

A:

Q: recall the topcis of the electronic Device and circuits

A: There are many topics in EDC  These topics are  1- Semiconductor diode  2-Diode circuit

Q: In an attempt to boost DC voltage, two students thought of using a transformer to accomplish such…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Sketch the root locus diagram for a unity feedback system G(s) = K(s+3)/s(s2+2s+2) (s+5)(s+9). Thus…

A:

Q: (9) A carrier frequency of 105 Hz modulated by a message signal m(t) produced an FM signal expressed…

A: Given here a FM signal and asked to find the modulation index.

Q: 15 Find i for the circuit shown in Fig. 10-19. 10 cos 106 t V 500 Ω Fig. 10-19 See Prob. 5. HH 0.001…

A: In this question,  We need to determine the current i as shown the circuit.  We are solving this…

Q: to c correct the errors that can occur when the data is moved or stored from t to the receiver.…

A: (i) The number of message bit(m) is 16. To find parity bits(p) we use the formula as  Given m=16,…

Q: Q4 - 3-phase, 6 pole, 400V 50Hz, I.M, has the stand still impedance of (0.04 + j 0.44) ohm/phase and…

A: Induction Motor: Relative slip is defined as the difference between synchronous speed to motor rotor…

Q: A discrete-time signal x[n] is shown in the figure below. Sketch and carefully label each of the…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: The wavelength of possible stationary wave for an integer in a cubic system of size L is Oj= // 4nj…

A: Given data, Size is given L Let number of integer is nj

Q: A 25 KVA transformer supplies a load of 12 KW at a power factor of 0.6 lagging. Find the percentage…

A: A 25 KVA transformer supplies a load of 12 KW at a power factor of 0.6 lagging. S=25 KVAP=12…

Q: < Notes What are the characteristics of an ideal operational amplifier? 8

A: In this case, the characteristics of an ideal operational amplifier are to be determined.

Q: QUESTION 1 Problem 1: A continuous-time signal xc (t) = 2sin(25πt) + sin(15πt) + 4 sin (20лt) + 2…

A: Aliasing: When the signal is sampled if the message signal overlaps the sample signal is called the…

Q: A sheet of charge , ρs = 2nC/m2 is present at the plane x =3 infree space, and a line charge , ρL =…

A:

Q: A three-phase four-wire system has unbalanced connected loads that draws 7 amps from line A, 16…

A:

Q: 3. Use superposition to find the current through the 82 2 resistor. For the circuit shown in Figure…

A: Superposition theorem :- It states that if linear, bilateral and active network have multiple…

Q: (3) A modulated signal y(t) = m(t) cos(4000ft) where the message signal m(t) has frequency…

A:

Q: 7. What is the voltage at 2nd terminal in the given circuit? 135V + 2002 100 2 500 → 5A

A: Given circuit,

Q: (c) A solar farm contains 300 modules each with an active area of 1 m² and generates 30 kW of power.…

A: Utilization factor:The utilization factor is also known as the use factor where the time used by…

Q: If a 10 V battery, 8 μF capacitor and 500,000 ohm resistor are connected in series, please calculate…

A:

Q: 2.8. Determine and sketch the convolution of the following two signals: t+1, 0≤t≤1 2-t, 1<t≤ 2, 0,…

A: Given data, x(t) = t+1, 0≤t≤12-t, 1&lt;t≤2  0    , elsewhereh(t) = δ(t+2)+2δ(t+1)

Q: : Differentiate between Lightening arrester and lightening conductor?

A: Differentiate between Lightening arrester and lightening conductor: Lightning conductor: A lightning…

Q: Q7:- A 3-phase, 4 pole, I.M ,developing a maximum torque at speed 1320 rpm .The resistance of star…

A: Since you have asked multiple questions, we will solve the first question for you If you want any…

Q: Show that the RF filter is given by the transfer function

A: It is given that:

Q: Determine the rms value for the waveform elin ( -9 ДЛД 0.1 0.2 0.3 0.4 0.5 r(s) -0.3 -0.2 -0.1

A:

Q: In a short circuit test on 132 kV, 3-phase system, the breaker gives the following results: Power…

A:

Q: Fig. 39.17 shows the negative voltage feedback amplifier. What is the value of feedback fraction?…

A:

Q: 2.18. Find Vout in the following circuit: 10 ΚΩ www + 5 V 15 V 40 ΚΩ Vout

A: Given,

Q: where should exerted on 91 = -44c 50cm 92 = 840 9 It will be equal to zero third charge be placed?…

A: Coulomb’s Law- According to Coulomb’s law, the force of attraction or repulsion between two charged…

Q: Given the loop transfer function below L(s) = 110(s+1) (s+10)² Compute the parameters T and T% to…

A: Given the loop transfer function below   L(s) = 110(s+1) /(s+10)^2   And F(s) = Tzs/Tps+1 The…

Q: B- The height of a wind turbine is 32.13m. Find the wind speed in K/h needed to generate 4641.7Kw if…

A: Given data, Height of wind turbine d=32.13 m Mass of air m=6.125 kg/5 m3 Density is given by,…

Q: The response of a second order system

A:

Q: 13.78 currents in the circuit of Fig. 13.140. 1+ 100/30° V (+ 20 Ω I₁ j80 Ω determine the mesh 40 Ω…

A:

Q: What are the characteristics of an ideal operational amplifier?

A: The solution is provided in the following section.

Q: What is tungsten,CFL,led bulb... Which one save electricity and why ?

A: Please find your answer below.

Q: What will be the value of R1 with the given  RTL code XOR , where R1 is 1011 0110, R2 is 1100 0111

A: Given, R1 = 1011 0110, R2 = 1100 0111 RTL code XOR =?

Q: The primary and secondary coils of a transformer each have an inductance of 200 x 10-6 H. The mutual…

A: Given, Primary and secondary inductance of coil, LP=LS=200×10-6 H Mutual inductance between winding,…

Q: Two coils A and B known to have the same resistance are connected across a 110-volts, 60 cycle line.…

A: Given data, Two coils are connected in series.  Resistance of both coils are same. Supply 110 V, 60…

Q: Example 14.8. A 15-mH inductor is in series with a parallel combination of an 80 2 resistor and 20…

A: Given, Inductance, L = 15 mH Resistance, R=80 Ω Capacitance, C = 20 μF Angular frequency, ω=1000…

Q: If A = 1001 1001 0000 0010, show the result of the logical shift right operation in hex

A: If A = 1001 1001 0000 0010, here we have to show the result of the logical shift right operation in…

Q: (c) The difference equation describing the input-output relationship of a discrete-time system is =…

A: Given data, Discrete-time system is un+1+3un = 8n,  with uo = 0

Q: Example 2.33. Using Node voltage method, find the current in the 302 resistance for the net- work…

A: Given circuit,

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.