Determine the rms value for the waveform elin ( -9 ДЛД 0.1 0.2 0.3 0.4 0.5 r(s) -0.3 -0.2 -0.1

Q: A 60-Hz synchronous generator having inertia constant H = 5 MJ/MVA and a direct axis transient…

A: Given  f= 60 Hz H=5 MJ/MVA S= Pe+j Q =0.8+ j 0.074 V= 1 pu =1∠0

Q: OV 50 Ω Μ 20 Ω Μ 80 Ω 15 Ω 30 Ω Μ ig 20 Ω Μ is ) 20 V Μ 12 V '60 Ω

A: Kirchhoff's Current Law- This law states that the sum of all incoming current is equal to all the…

Q: A choke coil is connected in series with a fixed resistor. A 240 – volts, 50 – Hz supply is applied…

A:

Q: B) For the circuit shown below, the switch is opened for a long time, at t=0 it is closed. i) Find…

A: Given,

Q: Given the input voltage as shown below. bo. 1 1.5 (V) 1 0 70 mW 60 mW Vop-5 V 11 7 M2 M1 0.5 C-2 F…

A:

Q: Q4:Calculate the work done in moving 10μC charge from point A(0,0,0) to point B(1,1,0) in the…

A:

Q: Prefilters are used to:  (Select all that apply)   A) Increase the bandwidth of the loop   B)…

A: Given options about prefilter  A) Increase the bandwidth of the loop     B) Improve reference input…

Q: Design the circuit of a source follower JFET amplifier biasing circuit with load R₂ and input…

A:

Q: Choose the correct answer: a) Which one of the following transistors cannot operate with VGs=0. 1.…

A: 1. Which of the following transistors can't operate with Vgs = 0V. A. JFET  B. D-MOSFET  C. E-…

Q: Q4: Design a buck converter to produce an output voltage of 18 V across a 10-_ load resistor. The…

A: Current: It is the time rate of the change of the charges. It is also known as the flow of the…

Q: What input condition puts an SR NAND latch into an indeterminate state?

A: Given: S-R NAND Latch Required:  Input conditions to put S-R NAND Latch into an indeterminate state.

Q: 8) A 230 V fed single quadrant chopper has a 40% duty cycle. A separately excited DC mot armature…

A: In this question we will find torque of given separately excited motor...

Q: A B The output of the following circuit is: 4 ΚΩ QIA 01 B 5V 2 ΚΩ -O Y AB =

A: For the given transistor circuit we need to compute it's output voltage for the given combination of…

Q: Describe the effect of mixed load (resistive + inductive) on sending and receiving end voltages,…

A: Effect of (resistive + inductive) on sending and receiving end voltages. Tran mission line can be…

Q: 19 Three parallel loads drawing 3 kW, 5kVA at 0.866 PF lagging and 4 kVA at 0.707 PF lagging are…

A: The Given is 3 parallel loads 3kW, 5kVA at 0.866PF lagging and 4kVA at 0.707 PF The lagging Power…

Q: Q4) A 220 V d.c. shunt motor has an armature resistance of 0.5 ohm, and runs at 850 rpm., When…

A: It is given that: Ra=0.5ΩN=850 rpmIL=32ARsh=110Ω

Q: Multiplexer 32 to 1 has 3 Selectors O 1 Selector O2 Selectors 5 Selectors

A: Given, A 32:1 multiplexer.

Q: Simplify the Boolean function F(w, x, y, z)=Σ (0, 2, 4, 6, 8, 10, 11).

A: We need to simplify the Boolean function

Q: Q4: Find the energy stored in free space for the region 2mm <r<3 mm, 0 <0<90°, 0< < 90° given V =…

A: Given voltage expression, V=300 cosθr2 volt The region, 2 mm&lt;r&lt;3 mm,  0&lt;θ&lt;90°,…

Q: 13. Find the minimum required bandwidth for the base-band transmission of 4-level PCM pulses…

A:

Q: Consider the octal signal point constellation in figure shown below. The adjacent signal points in…

A: Given: PSK-8 Distance d=A

Q: Draw a logic diagram constructing a 3 × 8 decoder with active-low enable, using a pair of 2 × 4…

A: A circuit device that changes a code into a set of signals, know as decoder. It is a just reverse of…

Q: Using mesh analysis, find 1₁ and 12 from the circuit given below, where Vs1 = 66/30° V. j10 Ω 40 Ω…

A: Given circuit:

Q: For the network shown, determine gm if lpss = 12 mA, Yos = 40 μS and Vp = 6 V. 1.5 V O 3 mS 1 ΜΩ O…

A: For the given network,  To determine gm = ?  Given :   IDSS = 12 mA  Vp = 6 volts  VGS = - 1.5 volts…

Q: Q5. Determine the value of drain current for the circuit shown in Fig. 3. VGS 2V +VDD VGS (o)=-6V…

A: Given data,

Q: Pc means: 1. The power consumption in collector. 2. The power consumption in emitter. 3. The…

A: In bjt C stands collector , E stands for emmiter  B stands for base And generally  I stands for…

Q: Efficiency delay Circuit network Datagram network

A: Compare circuit network and Datagram network in terms of efficiency and delay.

Q: 3. Use figure 2 for answering questions a-f. a) b) c) d) 115 V rms 60 Hz Vpis 10:1 eeeee 00000 Dis…

A: For the given figure answer the following question: PIV for each diode. Average output Voltage,…

Q: Q2: A/ The full-wave controlled bridge rectifier of has an ac input of 200 V peak to peak at 50 Hz…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: 19 A balanced three-phase voltage source, Van = 200/0° V rms, positive phase sequence, is connected…

A:

Q: What type is active filter shown

A: An active filter is a type of analog circuit that uses active components, typically an amplifier, to…

Q: QUESTIONS (a) Figure Q.1 (a) represents a common emitter amplifier. Given B-100, Ves(ON) -0.7V,…

A: The circuit diagram of common emitter amplifier is shown below, Where,β=100VBEon=0.7 VVBQ=1.7…

Q: Given the input voltage as shown below. M 1 V-5V 0.5 M2 4 M1 1 C-2 F 1.5 t(ms) The average power…

A:

Q: unive niversal series motor has a resistanc of of 30 and an inductance of X Henry. when connected to…

A: Solution- E1= V-IR=250-30×0.8=226 VNdc = 2000 rpmE2 = V-IR-IX                          IR =…

Q: Problem 1 – The 4.16kV distribution station capacitor bank below consists of 3 ungrounded double-wye…

A: a) 110% of rated rms voltage b) 120% of rated peak voltage. a) Kilo over - 135% b) RMS voltage -…

Q: If the current in a conductor is constant at 2 mA, how much time is required for 6 mC to pass…

A: Given, Current, I=2 mA Charge, q=6 mC

Q: 04. Design a lead compensator for the transfer function shown in figure (4) to obtain closed-loop…

A: Solution- ξ = 0.3ωn = 6  if the compensator is added (KP+KDs) i.e. lead compensator, Gs=4ss+2 Now,…

Q: 1. Are the following statements correct or wrong? (a) Thyristors are used only for low voltage, low…

A: We are authorized to answer one question and three subparts at a time, since you have not mentioned…

Q: 8. If a separate building is supplied with a three-phase ungrounded delta, then the three conductors…

A: Grounding: It is known as grounding or earthing to link the metallic frame, or non-current carrying…

Q: Choose the statements that are true/correct about instruments used in circuits.    The ammeter is…

A: Statement 1: The ammeter is connected along the circuit Solution 1:  To measure the current in a…

Q: 2. Prove the followings: a) b) X+XY=X+YA (X+Y)(X+Y)(X + Z) = XZ

A: a) Given: To prove: X+YX+Y¯X¯+Z=XZ

Q: The content of a four-bit register is initially the 4-bit word 0110. The register is shifted six…

A: Given data : The content of a four-bit register is initially the 4-bit word 0110. Serial input is…

Q: The reactance data for the given power system is as follows: X¹ X² Xº 0.10 0.10 0.05 0.10 0.10 0.05…

A:

Q: 3.) (Based on Neamen, Ch. 10 Checkpoint #5 and #6) (a) Describe in words what is meant by…

A: MOSFET stands for Metal Oxide Semiconductor Field Effect Transistor. It is voltage controlled device…

Q: Calculate the Ips current for an NMOS transistor. Assume that the transistor has W = 50 µm and L = 3…

A: Given: Kn'=150 μAV2,VT0=0.7 V,VG=2V,VS=0.3 V ,WL=503 Required: IDS

Q: Figure 4 shows the transfer curve of a network with an unknown channel Junction Field Effect…

A: Given:  Required: (1) Identify the channel of JFET and justify the answer.                  (2)…

Q: Determine the frequency and duty cycle

A:

Q: Design an active high-pass filter circuit using op-amp and calculate the value of the capacitor,…

A: It is given that: fc=331Hz

Q: Name: (11) The supply voltage VCC equals 9V. The base resistor Rais 42. Take 0.6V for the knee…

A: For the given NPN transistor circuit we need to calculate collector resistance, collector current…

Q: Consider the circuit below with i(t) = 80 sin(20t) mA for t> 0 and i(t) = 0 for t<0. C1-400 uF. C…

A:

Fourier Series

Most of the incidents studied in the field of Engineering and Science as a function of time. For example, current and voltage are in the alternating current circuit. These occasional activities can be analyzed in the activity components (fundamental frequency and harmonics) through a process called Fourier analysis.