Over the interval t|$1, an angle modulated signal is given by EM(t) = 10 cos 13000t The carrier frequency o = 10000 rad/s. (a) If this were an FM signal with k; = 1000, determine m(t) over the interval | t| <1. (b) If this were a PM signal with k, = 1000, determine m(t) over the interval |t| s1.

Over the interval t|$1, an angle modulated signal is given by EM(t) = 10 cos 13000t The carrier frequency o = 10000 rad/s. (a) If this were an FM signal with k; = 1000, determine m(t) over the interval | t| <1. (b) If this were a PM signal with k, = 1000, determine m(t) over the interval |t| s1.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A SSR has the following specifications: The transmitter gain (Gt ) = 27 dB. Antenna half-power beam width (θB) = 2.45o ERP (effective radiated power) = Pt Gt = 52.5 dB R = 256 nmi The propagation loss (LP) = -2 dB The antenna loss (La) = - 3.5 dB Pr (min) = -101 dB Would you expect an aircraft transponder to receive an adequate signal at that maximum range?Consider the SSR with specification given and interrogation pulses width of 0.5μs. If the aircraft is at the maximum range, how many times the interrogation will be done before receiving the first echo? Let the time spacing between two successive interrogations = 45 μ assume that mode 3/A AND C
4. short answers a. What is the effective antenna area of an antenna at 2500 MHz, if the gain is 13 dBi. b. For a WCDMA handset with 7 dB noise figure and 5 MHz effective noise bandwidth, calculate the noise floor in dBm. c. An NBA basketball player is close to 2 meters tall, and an “Umpa-Lumpa” from the movie “Willie Wonka” is 0.5 meters tall. Assuming 2-ray propagation model, what is the ratio of the signal strength received by the two people? d. Consider a 12-km microwave link with 15 meter towers at both ends, calculate the minimum frequency in GHz, such the first Fresnel zone does not intersect the ground? Assume that the ground is flat between the towers.
Wireless communication Determine the minimum C/N ratio for an 8-PSK system when the transmission rate is 60Mbps, the minimum energy of bit-to-noise density ratio is 15 dB, and the receiver bandwidth isequal to the minimum Nyquist frequency.
1. Select the correct statement(s) regarding amplitude modulation (AM). a. If the AM Index is greater than 1 (i.e., µAM>1), then over modulation occurs leading to signal distortion b. With AM, the message is captured as amplitude changes to the carrier’s amplitude. c. The AM modulated carrier bandwidth is dependent upon the baseband signal’s frequency bandwidth d. All of the above are correct 2. What is true about the frequency bandwidth of a modulated electrical or electromagnetic (EM) signal? a. signal bandwidth is only determined by the frequency of the unmodulated carrier wave b. modulation technique and the amount of information transmitted determines the signal’s bandwidth c. only the baseband signal determines frequency bandwidth; i.e., modulation technique has no impact on bandwidth d. a and c are true 3.Regarding carrier modulation, identify the carrier signal variable(s)…
In a broadcast superheterodyne receiver having no RF amplifier, the loaded Q of the antenna coupling circuit (at the input to the mixer) is 100. If the intermediate frequency is 455 kHz, calculate the image frequency and its rejection at 25 MHz.
A cellular service provider decides to use a digital TDMA scheme which can tolerate a signal- to-interference ratio of 15 dB in the worst case. Find the optimal value of N for(a) omnidirectional antennas, (b) 120° sectoring, and (c) 60° sectoring. Should sectoring beused? If so, which case (60° or 120°) should be used? (Assume a path loss exponent of n=4and consider trunking efficiency.)
An FM transmitter outputs 1kW of power when modulated by a 3kHz sinusoid. If modulation index is 4, determine (a) The power in the carrier component (b) The power in the largest sideband (c) The approximate bandwidth if sideband is considered insignificant if its amplitude is lessthan 8% of the carrier amplitude
A mobile station (MS) is located 15 km away from a base station (BS) transceiver and uses a vertical quarter wavelength monopole antenna with a gain of 3.5 dB to receive cellular radio signals. The E-field at 5 km from the transmitter is measured to be 10-3 V/m. The carrier frequency of the Fourth Generation Long-Term Evolution (4G LTE) system is 1.85 GHz. Calculate: (a) The wavelength in m. (b) The length and effective aperture of the receiving antenna. (c) The received power (Pr) in W, dBW, and dBm at the mobile using the two-ray ground reflection model assuming the transmitter height (hte) is 50 m, and receiver height (hre) is 2 m above ground.
You have an FSK transmitter using a mark frequency of 500 kHz, a space frequency of 380 kHz, and sending 10 kbps. A) How much bandwidth do you need for your transmission? B) if you are to design the system with continuous phase shift keying in mind, what would be the value of the space frequency if the mark frequency remains the same?
5. The following data is available: fc= carrier frequency = 750kHz, Ac= maximum amplitude of the unmodulated carrier = 10V fm= modulator frequency = 300Hz-8kHz modulation index m=0.5 a) What is the frequency of the upper sideband? b) What is the frequency of the lower sideband? c) What is the amplitude of the modulating signal? d) What is the maximum amplitude of the envelope of the modulated signal? e) What is the minimum amplitude of the envelope of the modulated signal? f) What is the bandwidth of the modulated wave? g) Write an expression for the modulated wave
For an Armstrong indirect FM transmitter with the crystal carrier oscillating at 210 kHz, the crystal reference oscillating at 10.2 MHz, the sideband voltage is 0.018 V, the carrier input voltage to the combiner is 5V, the first and second multipliers are both 40, and the modulating signal frequency is 2 kHz, determine: a.) modulation index at the output of the combining network and the power amplifier; b.) frequency deviation at the same two points; and c.) the transmit carrier frequency.
1.An FM transmitter is determined to have a transmitter sensitivity of 203.314Hz/V. If the modulating signal is designed to be 13.158V, and the modulation index is kept to be at 5, solve for the peak voltage of the 1st sideband. if the carrier signal is determined to be Vc(t)=25sin(2π160000000t) 2.An FM transmitter is determined to have a modulation index of 5. If the carrier voltage is determined to have a peak voltage of 24.800Vp. Solve for the power transmitted in dBrnC of the highest sideband considering a transmitter antenna resistance of 116.204Ohms.