ower is to be transmitted from one shaft to another which is parallel. The shafts are 14 in apart and are to rotate in the same directions with n angular velocity ratio of 3. Determine the diameter of the smaller cylinder.

Q: An airplane is moving due west at a speed of 100 mi/hr. The propeiler 5 ft. long (radius of blades…

A:

Q: A homogeneous rod of mass m= 4 (kg) and length L = 0.3 (m) stands upright on the ground. What is he…

A: Given Data: The mass of the rod is m = 4 kg. The length of the rod is L = 0.3 m. The angular…

Q: A wheel is rolling without slipping with the center velocity is 5 m/s to the left as shown in Figure…

A: 4.3

Q: Answer the following by using the INSTANTANEOUS CENTER METHOD for Velocity Analysis The mechanism…

A:

Q: In a rotating body, when a body rotates with the angular velocity of 53 rad/sec, Calculate the speed…

A: Angular velocity, w=53 rad/sec

Q: determine the magnitude of velocity at C if the angular velocity of bar BCD is 5.35rad/s CCW and…

A: To find: The magnitude of the velocity at C. Given: The angular velocity of bar BCD is ωBD=5.35…

Q: A and B located along the radius of wheel have speeds of 80 m/s and 140 m/s respectively. The…

A: Given:Velocity of point A, Va=80 m/sVelocity of point B, Vb=140 m/s

Q: The disk is rotating with an angular speed of  = 4 rad/s and has an angle of  = 30°. Determine the…

A: Given Data w=4 rad/s r=3 ft

Q: All collars slide freely. A = 5.0 ft/s downward at the instant shown. Using ICR, determine @AB and…

A:

Q: Power is to be transmitted from one shaft to another which is parallel. The shafts are 15 in apart…

A: Power is to be transmitted from one shaft to another which is parallel. The shafts are 15 in apart…

Q: A gear train is shown below. The gears have the following properties: N2 = 18 teeth, N3 = 72 teeth…

A: N2 = 18 teeths N3 = 72 teeths and Pd = 10  N4 = 16 teeth and Pd = 8 N5 = 48 teeth

Q: At some instant in the motion of a lamina in its own (Ox, y) plane the displacement from one of its…

A: given data; ⇒displacement (d)=(-5i+10j)  cm⇒velocity of P =(7i-2j)  cm/s⇒x-component of velocity Q…

Q: The plunger of a reciprocating pump is driven by a crank of radius 250 mm rotating at 12.5 rad/s.…

A: Crank radius, R=250mm=0.250mAngular velocity, ω=12.5 rad/s

Q: If the 8 = 45°, and the bar 0Q is rotating in the counterclockwise direction at 1.4 rad/s, which of…

A:

Q: As shown in the figure, if the velocity of the center of mass of the small cylinder is v = 8 (m/s),…

A:

Q: i need the answer quickly

A:

Q: 8 m/sec 25°. What is the velocity of B relative to A? 2. (4) A and B are two points on a rigid body.…

A: Part (1) : Given Data⇒ Rigid Body The velocity of A relative to B is vAB=8ms Required Data⇒ What…

Q: 35 As the hydraulic cylinder rotates around O, the ex- posed length 1 of the piston rod P is…

A: Given:Angular velocity of the cylinder, ω=60 deg/sAngular acceleration of the cylinder, α=0Linear…

Q: Power is to be transmitted from one shaft to the other by means of two rolling cones whose shafts…

A:

Q: If the shaft is balanced by two counter masses located at 100 mm radii and revolving in Planes…

A:

Q: oim and the masS then the angular frequency w is equal to

A:

Q: At the instant shown below, point O has got a velocity of -5,9i-0.5j m/s while the bat is rotating…

A: Given: The velocity of point O, V=-5.9i-0.5j Angular velocity of the bat; ω=4.3 rad/s ccw about the…

Q: Power is to be transmitted from one shaft to the other by means if two rolling cones whose shafts…

A:

Q: ower is to be transmitted from one shaft to another which is parallel. The shafts are 12 in apart…

A:

Q: In the given planetary gear system, the free end of Driving Shaft E has an angular velocity of WE =…

A: Given: The speed of the driving shaft E→NE=11.2345 rpm      (ccw) The radius of the each planet…

Q: 9. How do you find an instantaneous center of zero velocity? 10. What is KENNEDY THEOREM? State the…

A:

Q: 1. The natural angular frequency of the system will be k, mg K2

A:

Q: A rotor has the following properties. If the shaft is balanced by two counter masses located at 100…

A:

Q: A car travels to the right at a constant speed of 15 m/s under normal driving condition (rolling…

A:

Q: tating shaft carries four masses 176.6 N, 137.3 N, 157 N and N at radii 5 cm, 6 cm, 7 cm and 6 cm…

A:

Q: The angular velocity and angular acceleration of the bar AB shown are ωAB = 2 rad/s, αAB = 10 rad…

A: Please find the answer below

Q: In the given planetary gear system, the free end of Driving Shaft E has an angular velocity of we =…

A: Write the given data. ωE=ωD=11.2345 rpm CCWrB=40 mmrD=60 mmrC=140 mm

Q: Determine the angular velocity, in rpm, of the rotating drum which results in loss of contact…

A: given; lets take radius of drum=Rangle(θ)=1.0239rad               =1.0239*180π…

Q: The ratio of magnitudes of angular velocity

A: Given; Number of teeth on the sun, planet and outer geras to be;   50,25 and 100…

Q: In a four bar chain ABCD, AD is fixed and is 150 mm long. The crank AB is 40 mm long and rotates at…

A: Step-1               Given Data            Length of AD = 105 mm            Length of AB = 40 mm…

Q: Link OA rotates with an angular velocity of w as shown in velocity of 20 cm/s, determine a) the…

A:

Q: Determine the angular velocity, in rpm, of the rotating drum which results in loss of contact…

A: The drum looses contact with cloth at point A.

Q: t is in seconds and omega(a) at t=0 is 20 rad/s.

A:

Q: of 2/220 For a given value of y, determine the upward veloc- ity of A in terms of the downward…

A: Find the total length of belt and differentiate with respect to time.

Q: Qu/ The rotor o fatraction motor o f an electric train has amass of 450 ky and is Supported on two b…

A: The rotor of a traction motor of an electric train has a mass of 450 kg and is supported on two…

Q: The Scotch-yoke mechanism converts rotational motion of the disk to oscillatory translation of the…

A:

Q: The rotor of a gas turbine is rotating of 12 rad/s when the turbine is shut down. It is observed…

A:

Q: Consider the configuration shown below with w1 = 2.5 rad/s, w2 = 1.0 rad/s, and W3 = 5.4 rad/s. Find…

A:

Q: The in-plane angular speed of the bent bar indicated below is w = 0.2 rad/s. The dimensions of the…

A:

Q: In a rotating body, when a body rotates with the angular velocity of 50 rad/sec, Calculate the speed…

A: Angular velocity is the rotational velocity of a body. It is equal to the angular distance covered…

Q: An airplane has multiple angles that are used to track orientation of the craft. If the airplane is…

A: Given data: Airplane pitching speed 5o/s along j-axis and 8o/s along k-axis. Need to determine the…

Q: A slender rod is bent to form a square frame of side 6 in. The frame is attached by a collar at A to…

A: Given Square side = 6 in Angle = 48o To find Magnitude of ω

Q: disk rolling with no slip on horizontal surface. with the instant, angular velocity of disk is w=…

A: