Part A An 1200-turn coil of wire that is 2.3 cm in diameter is in a magnetic field that drops from 0.15 T to 0 T in 12 ms. The axis of the coil is parallel to the field. What is the emf of the coil? Express your answer in volts. For the steps and strategies involved in solving a similar problem, you may view a Video Tutor Solution. E = V

Part A An 1200-turn coil of wire that is 2.3 cm in diameter is in a magnetic field that drops from 0.15 T to 0 T in 12 ms. The axis of the coil is parallel to the field. What is the emf of the coil? Express your answer in volts. For the steps and strategies involved in solving a similar problem, you may view a Video Tutor Solution. E = V

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter32: Faraday’s Law Of Induction

Section: Chapter Questions

Problem 63PQ

See similar textbooks

Similar questions

Consider the system pictured in Figure P28.26. A 15.0-cm horizontal wire of mass 15.0 g is placed between two thin, vertical conductors, and a uniform magnetic field acts perpendicular to the page. The wire is free to move vertically without friction on the two vertical conductors. When a 5.00-A current is directed as shown in the figure, the horizontal wire moves upward at constant velocity in the presence of gravity. (a) What forces act on the horizontal wire, and (b) under what condition is the wire able to move upward at constant velocity? (c) Find the magnitude and direction of the minimum magnetic Field required to move the wire at constant speed. (d) What happens if the magnetic field exceeds this minimum value? Figure P28.26
100-turn square coil of side 20.0 cm rotates about a vertical axis at 1.50 103 rev/min as indicated in Figure P31.42. The horizontal component of the Earths magnetic field at the coils location is equal to 2.00 105 T. (a) Calculate the maximum emf induced in the coil by this Held, (b) What is the orientation of the coil with respect to the magnetic field when the maximum emf occurs?
A coil of area 0.100 m2 is rotating at 60.0 rev/s with the axis of rotation perpendicular to a 0.200-T magnetic field. (a) If the coil has 1 000 turns, what is the maximum emf generated in it? (b) What is the orientation of the coil with respect to the magnetic field when the maximum induced voltage occurs?
A thin conducting bar (60.0 cm long) aligned in the positive y direction is moving with velocity v=(1.25m/s)i in a region with a spatially uniform 0.400-T magnetic field directed at an angle of 36.0 above the xy plane. a. What is the magnitude of the emf induced along the length of the moving bar? b. Which end of the bar is positively charged?
A flat, square coil of 20 turns that has sides of length 15.0 cm is rotating in a magnetic field of strength 0.050 T. If tlie maximum emf produced in die coil is 30.0 mV, what is the angular velocity of the coil?
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
A time-dependent uniform magnetic field of magnitude B(t) is confined in a cylindrical region of radius R. A conducting rod of length 2D is placed in the region, as shown below. Show that the emf between the ends of the rod is given by dBdtDR2D2 . ( Hint: To find the between the ends, we need to integrate the electric field from one end to the other. To find the electric field, use Faraday’s law as “Ampere’s law for E”.)
The square armature coil of an alternating current generator has 200 turns and is 20.0 cm on side. When it rotates at 3600 rpm, its peak output voltage is 120 V. (a) Wliat is the frequency' of the output voltage? (b) What is the strength of the magnetic field in which the coil is turning?
Suppose a uniform magnetic field is perpendicular to the 81211-in. page of your homework and a rectangular metal loop lies on the page. The loops sides line up with the edges of the page. The magnetic field is changing with time as described by B = 3.75 103 t, where B is in teslas and t is in seconds. a. Is the magnetic field increasing or decreasing? b. Find the magnitude of the emf induced in the loop.
(a) A nonferrous screwdriver is being used in a 2.00 T magnetic field. What maximum emf can be induced along its 12.0 cm length when it moves at 6.00 m/s? (b) Is it likely that this emf will have any consequences or even be noticed?
A wire of length 1.0 m is wound into a single-turn planar loop. The loop carries a current of 5.0 A, and it is placed in a uniform magnetic field of strength 0.25 T. (a) What is the maximum torque that the loop will experience if it is square? (b) If it is circular? (c) At what angle relative to B would die normal to the circular coil have to be oriented so that the torque on it would be the same as the maximum torque on the square coil?
Unreasonable results To construct a non-mechanical water meter, a 0.500-T magnetic field is placed across the supply water pipe to a home and the Hall voltage is recorded, (a) Find the flow rate through a 3.00-cm-diameter pipe if the Hall voltage is 60.0 mV. (b) What would the Hail voltage be for the same flow rate through a 10,0-cm- diameter pipe with tire same field applied?