Part A The figure (Figure 1)shows a parallel RC circuit. Use a phasor-diagram analysis to find the expression for the peak current IR. Hint: What do the resistor and capacitor have in common? Use that as the initial phasor. Express your answer in terms of some or all of the variables Eo , w, R, and C. O) E) ? IR = Figure 1 of 1 Part B Find the expression for the peak current Ic. Express your answer in terms of some or all of the variables Eo, w, R, and C. E,cos ot R :C Ic = ww

Part A The figure (Figure 1)shows a parallel RC circuit. Use a phasor-diagram analysis to find the expression for the peak current IR. Hint: What do the resistor and capacitor have in common? Use that as the initial phasor. Express your answer in terms of some or all of the variables Eo , w, R, and C. O) E) ? IR = Figure 1 of 1 Part B Find the expression for the peak current Ic. Express your answer in terms of some or all of the variables Eo, w, R, and C. E,cos ot R :C Ic = ww

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 84CP: In this chapter, most examples and problems involved direct current (DC). DC circuits have the...

See similar textbooks

Similar questions

An RC circuit has an emf of 10 sin t (volts), a resistance of 100 ohms, a capacitance of 0.005 farad, and no initial charge on the capacitor. (a)what is the differential equation governing the amount of charge on the capacitor? (b) what is the integrating factor of it?(c) what is the charge on the capacitor at any time t? (d)what is the current in the circuit at any time t?
In the circuit shown in figure 1, all the resistors are rated a maximum power of 1.00 W. What is the maximum emf epsilon that the battery can have without burning up any of the resistors?
Ohm's law gives the relationship between voltage, resistance, and current in a simple circuit: V = IR. a) Find (dV/dt) in terms of I, R, (dI/dt) and (dR/dt). Assume all quantities are functions of time. b) We have a circuit with 500 Ω resistor, and we ramp up the voltage. How quickly is the current changing when we are increasing the voltage by 10 V/s? It will help to remember that t is the independant variable here. Include units, note that 1Ω = 1V/A. c) Is the current increasing or decreasing? How can you tell?
consider the series portion of a circuit shown in the figure. the current in the circuit flows from a to be and is 2.3 A. (a) what is the equivalent resistance? (b) what is the voltage across the entire circuit? (c) which point, a or b, is at higher potential. (d) what is the voltage across each resistor?
A capacitor is being charged with 9.6 V of the voltage supply in a RC circuit shown below. At t = 0 s, the capacitor is empty and does not have any electric charge stored in it. The resistance of the resistor in the circuit is R = 320 Ω. Answer the following questions. (a) What is the electric current in the circuit at t = 0 s? (b) At t = 3.0 s, the voltage reading across the capacitor is 2/3 of the voltage provided from the voltage supply. Find the capacitance of the capacitor. (c) What is the electric charge stored in the capacitor after a long time? (d) After the capacitor is fully charged with 9.6 V of voltage supply, the voltage on the voltage supply is increased to 15 V. What is the electric charge stored in the capacitor after a long time? (e) After the capacitor is fully charged with 15 V, the voltage supply is removed from the circuit and the capacitor is ready to discharge current. What is the electric current at the beginning of the discharge if the resistance remains…
What is the total resistance if you solve for the parallel circuit first? And what is the total resistance if you solve for the series circuit first? Why are the two totals the same/different?
For the given resistor combination circuit, determine (a)the equivalent resistance (show simplification of circuits), (b) the current in the circuit assuming a 30V source (neglecting internal resistance) is connected at terminal a-b, (c) the potential drop across each resistor, and (d) the current across each resistor.Can I have an explanation of how to answer, especially a.)
Consider the RC circuit in the figure below. The switch was at position a for a long period of time and is switched to position b at time t = 0. A) Suppose R=415Ω, C=2.5μ F, and Vb=4.5 V. What will be the voltage drop across the resistor at t=2.1 ms? B) How much energy in total will eventually be dissipated by the resistor? C) Now suppose that the switch has been at position b for a long time and is switched to position a at t = 0 s. What will be the voltage drop across the capacitor after 2.1 ms?
An RC circuit has a resistor and capacitor in series with a switch and a battery. The Resistance is 290 kΩ, capacitance of the capacitor is 4 µF, and the battery emf is 12 V. The capacitor is initially not charged. Calculate the current in the circuit 3 s after the switch is closed. Write your answer in micro-amperes (i.e. 10-6 A).
Consider the RC circuit shown in the figure below. If the resistance of the circuit is R=6kΩ and the capacitance of the initially uncharged capacitor is C=11μF. If the emf of the battery the circuit is connected to is ε=16V and the switch is closed at t=0, determine how long it would take for the current running in the circuit to go down to 41% of its maximum value. Express your answer in units of ms (milliseconds) using one decimal place.
Joule’s law allows us to compute the power in a simple electric circuit: P=I2R. (a) Use the equation above to find an equation relating dP dt , dI dt , dR dt , I and R. (b) I have a circuit with a 400 Ω resistor. I increase the voltage at 20 Volts/s. When the voltage reaches 350 Volts, how quickly is the Power in the circuit increasing? Include units in your answer. Note that 1 Watt is equivalent to 1 Volt2/Ω. Hint: you will need to use another equation relating voltage to current from the activity in class.
A 530-Ω resistor, an uncharged 3.40-μF capacitor, and a 4.80-V emf source are connected in series. What is the instantaneous power to the capacitor after 3 time constants? Calculate your answer in the units of milli-watts (mW). Hint: Instantaneous power is the product of instantaneous potential drop and instantaneous current. Write your answer in decimal form with three digits to the right of the decimal point (e.g. 5.389); do not write any units.