Part AWhich of the following solutions is a good buffer system?A solution that is 0.10 M NaCl and 0.10 M HCIA solution that is 0.10 M Li and 0.10 M HNO3A solution that is 0.10 M H CN and 0.10 M LICNA solution that is 0.10 M Li OH and 0.10 M HNO3A solution that is 0.10 M HCN and 0.10 M Na Cl

As good buffer solution will be: weak acid + its…

Answered: Part A Which of the following solutions…

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter9: Acids, Bases, And Salts

Section: Chapter Questions

Problem 9.101E

See similar textbooks

Similar questions

Follow the directions of Question 64. Consider two beakers: Beaker A has a weak acid(K a=1105). Beaker B has HCI. The volume and molarity of each acid in the beakers are the same. Both acids are to be titrated with a 0.1 M solution of NaOH. (a) Before titration starts (at zero time), the pH of the solution in Beaker A is the pH of the solution in Beaker B. (b) At half-neutralization (halfway to the equivalence point), the pH of the solution in Beaker A the pH of the solution in Beaker B. (c) When each solution has reached its equivalence point, the pH of the solution in Beaker A the pH of the solution in Beaker B. (d) At the equivalence point, the volume of NaOH used to titrate HCI in Beaker B the volume of NaOH used to titrate the weak acid in Beaker A.
A monoprotic organic acid that has a molar mass of 176.1 g/mol is synthesized. Unfortunately, the acid produced is not completely pure. In addition, it is not soluble in water. A chemist weighs a 1.8451-g sample of the impure acid and adds it to 100.0 mL of 0.1050 M NaOH. The acid is soluble in the NaOH solution and reacts to consume most of the NaOH. The amount of excess NaOH is determined by titration: It takes 3.28 mL of 0.0970 M HCl to neutralize the excess NaOH. What is the purity of the original acid, in percent?
A 5.36-g sample of NH4Cl was added to 25.0 mL of 1.00 M NaOH and the resulting solution diluted to 0.100 L.. (a) What is the pH of this buffer solution?. (b) Is the solution acidic or basic?. (c) What is the pH of a solution that results when 3.00 mL of 0.034 M HCl is added to the solution?
An aqueous solution contains dissolved C6H5NH3Cl and C6H5NH2. The concentration of C6H5NH2 is 0.50 M and pH is 4.20. a. Calculate the concentration of C6H5NH3+ in this buffer solution. b. Calculate the pH after 4.0 g NaOH(s) is added to 1.0 L of this solution. (Neglect any volume change.)
A buffer solution that is 0.100 M acetate ion and 0.100 M acetic acid is prepared. (a) Calculate the initial pH, final pH, and change in pH when 1.00 mL of 1.00 M NaOH is added to 100.0 mL of the buffer. (b) Calculate the initial pH, final pH, and change in pH when 1.00 mL of 1.00 M NaOH is added to 100.0 mL pure (pH 7.00) water.
A buffer is prepared in which the ratio [ H2PO4 ]/[ HPO42 ]is 3.0. (a) What is the pH of this buffer? (b) Enough strong acid is added to convert 15% of HPO42- to H2PO4-. What is the pH of the resulting solution? (c) Enough strong base is added to make the pH 7.00. What is the ratio of [H2PO4-] to [HPO42-] at this point?
A bottle of concentrated hydroiodic acid is 57% HI by weight and has a density of 1.70 g/mL. A solution of this strong and corrosive acid is made by adding exactly 10.0 mL to some water and diluting to 250.0 mL. If the information on the label is correct, what volume of 0.988 M NaOH is needed to neutralize the HI solution? Suggest an indicator for the titration.
Some K2SO3 and KHSO3 are dissolved in 250.0 mL of solution and the resulting pH is 7.25. Which is greater in this buffer solution, the concentration of SO32 or the concentration of HSO32? If [SO32] = 1.0 M in this solution, calculate the concentration of HSO3.
Consider the nanoscale-level representations for Question 111 of the titration of the aqueous strong acid HA with aqueous NaOH, the titrant. Water molecules and Na+ ions are omitted for clarity. Which diagram corresponds to the situation: (a) After a very small volume of titrant has been added to the initial HA solution? (b) Halfway to the equivalence point? (c) When enough titrant has been added to take the solution just past the equivalence point? (d) At the equivalence point? Nanoscale representations for Question 111.
The weak base ethanolamine. HOCH2CH2NH2, can be titrated with HCl. HOCH2CH2NH2(aq)+H3O+(aq)HOCH2CH2NH3+(aq)+H2O(l) Assume you have 25.0 mL of a 0.010 M solution of ethanolamine and titrate it with 0.0095 M HCl. (Kb for ethanolamine is 3.2 107.) (a) What is the pH of the ethanolamine solution before the titration begins? (b) What is the pH at the equivalence point? (c) What is the pH at the halfway point of the titration? (d) Which indicator in Figure 17.11 would be the best choice to detect the equivalence point? (e) Calculate the pH of the solution after adding 5.00, 10.0, 20.0, and 30.0 mL of the acid. (f) Combine the information in parts (a), (b), (c), and (e), and plot an approximate titration curve.

Recommended textbooks for you

Introductory Chemistry For Today

Chemistry

ISBN:

9781285644561

Author:

Seager

Publisher:

Cengage

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Chemistry by OpenStax (2015-05-04)

Chemistry

ISBN:

9781938168390

Author:

Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Publisher:

OpenStax

Introductory Chemistry For Today

Chemistry

ISBN:

9781285644561

Author:

Seager

Publisher:

Cengage

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Chemistry by OpenStax (2015-05-04)

Chemistry

ISBN:

9781938168390

Author:

Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Publisher:

OpenStax

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry

ISBN:

9781133611097

Author:

Steven S. Zumdahl

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

Part A Which of the following solutions is a good buffer system? A solution that is 0.10 M NaCl and 0.10 M HCI A solution that is 0.10 M Li and 0.10 M HNO3 A solution that is 0.10 M H CN and 0.10 M LICN A solution that is 0.10 M Li OH and 0.10 M HNO3 A solution that is 0.10 M HCN and 0.10 M Na Cl