Part II. 1. Herschel-Buckley Equation An unknown non-newtonian fluid underwent theology analysis. Assuming the yield stress is 36.3 Pa. Determine the fluid behavior index, consistency coefficient and type of non-newtonian fluid. Shear Rate (1/s) Shear Stress (Pa) 1 159 10 260 20 312 30 350 40 380 50 407 60 430

Part II. 1. Herschel-Buckley Equation An unknown non-newtonian fluid underwent theology analysis. Assuming the yield stress is 36.3 Pa. Determine the fluid behavior index, consistency coefficient and type of non-newtonian fluid. Shear Rate (1/s) Shear Stress (Pa) 1 159 10 260 20 312 30 350 40 380 50 407 60 430

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.9P: When a sphere falls freely through a homogeneous fluid, it reaches a terminal velocity at which the...

See similar textbooks

Similar questions

Unit weight of liquids Derive the formula used in determining the unit weight or density of a liquid using the displacement method. How is it different from the direct method? What are the practical applications of experiment?
A nuclear reactor is cooled by liquid sodium. The liquid sodium has the following properties: dynamic viscosity = 0.41 mPa·s, specific heat capacity = 1.2 kJ/kgK, thermal conductivity 82 W/mK. Which of the following statements is correct for this scenario? please explain A The thermal boundary layer is thicker than the hydraulic boundary layer. B Heat is transferred through the fluid more easily than momentum. C The velocity varies significantly from the surface to the thickness of the thermal boundary layer. D The hydraulic boundary layer is thicker than the thermal boundary layer.
What is Newton’s law of flow and its application? Differentiate flow properties and corresponding rheograms between Newtonian and non-Newtonian materials. Define and show calculations on the effects of temperature on viscosity and recognize similarities between viscous flow and diffusion relative to temperature. What are the rheologic behaviors with their corresponding rheograms. can you also indicate some references
A small wind turbine is tested in a wind tunnel using the following model parameters: ρ = 1.2 kg/m3 , µ = 1.81x10-5 Ns/m2 , v = 12 m/s, A = 0.03 m2 and Cp is measured as 0.42. Assuming dynamic similarity exists, calculate the power output of a full-size turbine of diameter 60 m operating in air of density 1.3 kg/m3 and viscosity µ = 1.73x10-5 Ns/m2 with wind speeds of 15 m/s
A steel ball with the density of 6229 kg/m and the radius of 0,65 cm was dropped into the oil whose viscosity was to be measured as isseen in the figure. When the ball attains a constant velocity, the distance that the ball travelled was measured as 99 cm within the time interval of 4,7 sec. Before the experiment, the mass of the 100 ml-oil was measured as 2,1 gr. According to the data given above, find; a) the density of the oil (in kg/m ). (Please do not use any decimal digit.) b) the speed of the steel ball after the ball attains a constant velocity (in m/s). (Please use 4 decimal digits.) c) the dynamic viscosity of the oil (in Pa.s) (Please use 3 decimal digits.) d) the flow Reynolds number. (Please use 4 decimal digits.) Please solve this question step by step to reach correct answers. correct answers: a) 21 b) 0,2106 c) 2,715 d) 0,0212
another question: Within the field of mechanical engineering, what are the intricate interplays between fluid dynamics, heat transfer, and thermodynamics that engineers must meticulously analyze and optimize in order to design highly efficient and compact cooling systems for electronic devices, and how do these advancements contribute to the continuous evolution of computing technology and its diverse applications in modern society
A pipe of diameter 2.5 m is required to transport an oil of sp.gr. 0.86 & viscosity 3×10- 2 poise at 3750 li/s. Tests were conducted on a 20cm diameter pipe using water at 20oC Find the velocity and rate of flow in the model. Viscosity of water at 20 m= 0.01poise.
Provide the statement of the trouton rule and the typical numeric value of certain thermodynamic parameter described in this rule
Casson model often used to describe the shear stress vs. shear rate relationship in colloidal suspensions where particle aggregation might cause the measured viscosity to increase at low shear rates. shear stress τ and the appliedshear rate S were fitted to the Casson model as written as
Taylor number (Ta) is used here to describe the ratio between the inertia effect andthe viscous effect. By applying Buckingham Pi’s Theorem, determine an equation forTa as a function of the radius of inner cylinder (r), cylinder tangential velocity (v),fluid dynamic viscosity (μ), gap distance (L) and fluid density (ρ).
η =2gr^2(ps−pl)/ 9v State the value of the viscosity and error on the value obtained in your experiments. Youshould show the formula derived for calculating the error on viscosity. pl (density of liquid)= 1294.164 ps ( density of solid sphere)= 8404 kg/m^3 v= 0.0479 +- 1.16x10^-3 m/s r= 0.0024325m error for radius is 1.65 x 10^-3 all values are in si units.
The variation of the dynamic viscosity of water with absolute temperature is given as Using these tabulated data, develop a relation for viscosity in the form of ? = ? (T ) = A + BT + CT2 + DT3 + ET4. Using the relation developed, predict the dynamic viscosity of water at 50°C at which the reported value is 5.468 × 10−4 Pa⋅s. Compare your result with the results of Andrade’s equation, which is given in the form of ? = D⋅eB/T, where D and B are constants whose values are to be determined using the viscosity data given.