Part of a two story building is shown in the figure in which a concerte column and a steel column are used in the first and second floor. The compressive force on the roof of the second floor is PC = 370 kN. The compressive force on the first floor is PB = 420 kN. The steel [Esteel = 200 GPa] column is a wide angle steel shape that has a cross section area of A2 = 1950 mm2. The concrete [Econcrete = 30 GPa] column has a circular section with a diameter of d = 560 mm.[L1 = 5.6 m, L2 = 5.6 m] Using this equation FL/AE

Part of a two story building is shown in the figure in which a concerte column and a steel column are used in the first and second floor. The compressive force on the roof of the second floor is PC = 370 kN. The compressive force on the first floor is PB = 420 kN. The steel [Esteel = 200 GPa] column is a wide angle steel shape that has a cross section area of A2 = 1950 mm2. The concrete [Econcrete = 30 GPa] column has a circular section with a diameter of d = 560 mm.[L1 = 5.6 m, L2 = 5.6 m] Using this equation FL/AE

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter33: Hydronic Heat

Section: Chapter Questions

Problem 25RQ: The temperature of the water at the outlet of a three-way mixing valve will most likely be A. equal...

See similar textbooks

Similar questions

SN-88
Thelightingrequirementsofanindustrialfacilityarebeingmetby70040-Wstandard fluorescent lamps. The lamps are close to completing their service life and are to be replaced by their 34-W high-efficiency counterparts that operate on the existing standard ballasts. The standard and high-efficiency fluorescent lamps can be purchased in quantity at a cost of $1.77 and $2.26 each, respectively. The facility operates 2800 hours a year, and all of the lamps are kept on during operating hours. Taking the unit cost of electricity to be $0.105/kWh and the ballast factor to be 1.1 (i.e., ballasts consume 10 percent of the rated power of the lamps), determine how much energy and money will be saved per year as a result of switching to the high- efficiency fluorescent lamps. Also, determine the simple payback period.
An electric windshield defroster is used to remove 0.25-in of ice from a windshield. The properties of the ice are Tsat = 328F, uif = hif = 144 Btu/lbm, and v = 0.01602 ft3/lbm. Determine the electrical energy required per square foot of windshield surface area to melt this ice and remove it as liquid water at 328F. What is the minimum temperature at which the defroster may be operated? Assume that no heat is transferred from the defroster or ice to the surroundings.
Q4(1).State the salient features of the Pakistan Environmental Protection Act (PEPA) 1997.
The American Society of Heating, Ventilating, and Air Conditioning Engineers (ASHRAE) sets the standard for outdoor air requirement for ventilation purposes. For example, for a gymnasium, an outdoor air requirement of 9.4 L/s per person is required. What is the total volume of the outdoor air that must be introduced into a gym during a 12-hour period if on average 30 people are using the gym every minute? Express your answer in liters and m3 .
Select all proper governing equations for the not well insulated mixing chamber below. (The kinetic and potential energy changes are very small.)_______ A. B. C. D.
If the heat rejected to the surroundings is 40% larger than the heat absorbed at the food compartment, determine COP.
A PUC is considering a subsidy program to encourage consumers to install improved insulation in homes as a way of reducing the amount of electricity consumed and reduce air pollution. The insulation program would cost $1,500,000 and would save 5,000 MWh of power. Assuming that natural gas is used to generate the electricity and 1 MWh produces 1,135 pounds of carbon dioxide. What is the cost of this program per ton of carbon dioxide?
What is the total required heating energy in raising the temperature of a given amount of water when the energy supplied is 1000 kwh with heat losses of 25%?
What is the heat transfer rate required to condense the water, cool the water vapor, and cool the air?
1) Determine the height of chimney required in a boiler having natural draught equivalent to 25 mm of water. The flue gases are at temperature of 600K , atmospheric air temperature is 25 C and 15 kg air per kg of fuel is required in boiler.
isn't h1 154.99?