Venturi meter: Assuming Cd = 0.955 for venturi meter , rho = 1000 kg/m3Orifice plate: Assuming for orifice plate, K = 0.601 and r = 1000 kg/m3 PenyadopmanomaterAlironSetno.1Meter venturi+ 莊26mm16mmPeresap bersudutlebaroE F-20mmTORotometercl-26mm 51mmMeterOrificeManometer readings (mm)ABCDE FGH318 158 295 304 312 135 165 128I15You are given the following data for a flow measurement apparatus. Fill in the tableAnd show the calculations. Determine the cross sectional area of A, B, C, D, E and FMass flow rate (m)AH/ Inlet headRotameter readingVolumeVol. flow rateTime17Liter secondsseconds50:15:23dia VenturiHydraulic flowOrificeRotameterVenturiOrificeRotameterm³/s kg/s kg/s kg/s kg/s

Solution: Given Data: CD=0.955K=0.601ρ=1000 kg/m3 Note: Dear Student! As per Bartleby guidelines,…

Penyodop manomater Aliren Set no. Meter ventur +14+ 16mm 26mm Peresop bersudut lebor lo E F A -20mm TI 26mm 51mm /Meter Orifice Manometer readings (mm) A B C D E F GHI Liter seconds m³/s kg/s kg/s kg/s kg/s - 1 318 158 295 304 312 135 165 128 15 17 5 0:15:23 Rotometer cl You are given the following data for a flow measurement apparatus. Fill in the table And show the calculations. Determine the cross sectional area of A, B, C, D, E, and F Mass flow rate (m) AH/ Inlet head Rotameter reading Volume Vol. flow rate Venturi Hydraulic flow Rotameter Time Orifice Venturi Orifice Rotameter

Penyodop manomater Aliren Set no. Meter ventur +14+ 16mm 26mm Peresop bersudut lebor lo E F A -20mm TI 26mm 51mm /Meter Orifice Manometer readings (mm) A B C D E F GHI Liter seconds m³/s kg/s kg/s kg/s kg/s - 1 318 158 295 304 312 135 165 128 15 17 5 0:15:23 Rotometer cl You are given the following data for a flow measurement apparatus. Fill in the table And show the calculations. Determine the cross sectional area of A, B, C, D, E, and F Mass flow rate (m) AH/ Inlet head Rotameter reading Volume Vol. flow rate Venturi Hydraulic flow Rotameter Time Orifice Venturi Orifice Rotameter

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

include a free body diagram The flow rate of ammonia with mass density of 624.6 kg/m^3 and viscosity of 1.697 x 10^-4 kg/m-s, through a 2 cm diameter pipe is to be measured with 1.5 cm diameter flow nozzle equipped with differential pressure gage. If the gage reads a pressure differential of 4 kPa. determine the flow rate of ammonia through the pipe in m^3/s if Cd= 0.96. a. 1.456 x 10^-2 b. 78.43 x 10^-6 c. 2.456 X 10^-5 d. 0.734 x 10^-3
Air at 68 degrees Celsius is being pumped through a pipe of internal diameter 6.4 inches. If the volumetric flow rate has been set to 6.2 cubic feet per minute, determine if the flow is laminar or turbulent. Assume pressure is atmospheric. Use the data for air viscosity given below. c1 = 1.425x10^-6 c2 = 0.5039 c3 = 108.3
Three pipes connected in series with lengths L1 = L2 = L3 = 150 m and diameters D1 =75 mm, D2 = 50 mm, D3 = 25 mm. The discharge at the 25mm pipe = 200 lps, kinematic viscosity = 1.12 x 10-6 m2/s and ε = 0.35 mm. Using Colebrook and Darcy-Weisbach Formula, determine the following:a. relative roughness of the 25mm pipeb. roughness coefficient of 75mm pipec. head loss of 50 mm pipe
What is the volume flow rate for water (viscosity= .0010 Pa×s) through a length of pipe L= 0.60m and pipe radius r= 1.03cm if the pressure difference across this length of pipe is 5.2 kPa? Note that 1 kPa= 1000 Pa. What would the volume flow rate be if the same pipe had a radius that is reduced by 21% (i.e. the radius is 79% of its previous value)? Let's call this flow rate Q1. What is the ratio of Q1 to the original flow rate Q? Express this as a decimal number.
Determine the Prandtl number, Nusselt number, and Reynolds number from the following flow data: cp = 0.5 Btu/lbmR k = 2 Btu/h-ft-R h = 20 Btu/h-ft2-R dynamic viscosity = 0.222 lbm/ft-s v = 5ft/s D = 2in Density=58 lbm/ft3
An oil with dynamic viscosity of 0.8 Pa.s and specific gravity of 0.9 is flowingthrough a horizontal pipe of 50 mm diameter. If the flow is a laminar flow, basedon Table 1 and the setting given, determine :(i) flowrate of the oil;(ii) centerline velocity;(iii) power required to maintain the flow;(iv) drag force on the pipe; and(v) velocity and shear stress at 10 mm from the wall. 2100 = Pressure Different(kN/m2) 99= PipeLength(m)
choose the correct answer Q1A- If the viscose force is dominate in Reynolds number, the flow will be: * a) Laminar flow b) Turbulent flow c) Transition flow d) All the answers Q1B- Chézy and manning equations are controlled in design of : * a) Water pipes network b) Open channels c) Water jet applications d) None of all above
Oil with a density of 917kg/m3917kg/m3 is flowing smoothly through a pipe, as shown. In the lower portion, the oil is flowing at v1=2.24m/sv1=2.24m/s, and the pressure gauge indicates P1=227kPaP1=227kPa. In the upper portion of the pipe, oil is flowing at v2=3.26m/sv2=3.26m/s at a height that is 12.98m12.98m above the lower portion. What is the pressure reading, in kilopascals, on the gauge on the upper portion of the pipe?
Sulfuric acid with a density of 1980 kg / m3 and a viscosity of 26.7 cP flows in a pipe with a diameter of 35 mm. If the acid flow rate is 1 m3 / min, what is the pressure loss due to friction in a 30 m long smooth pipe? a. Reynold number = Answer. b. Loss of Pressure = AnswerkPa.
Distilled water flowing with a flow rate of 50.2 L / min in the venturimeter with a narrow section of 8.6x10^-5m^2 and a wide section of 6.88x10^-4 m^2 transitions from wide to narrow section. The pressure in the wide cross-section of water at 200C is 0.8 bar and tell whether cavitation will occur. (Contraction Loss = KdV22 / 2g and Kd = 0.35) (Vapor pressure values are given in the table below.)
Water at 10 ° C flows from a large reservoir to a smaller one through a 5 - cm - diameter cast iron piping system, as shown in Fig. Determine the elevation z, for a flow rate of 6 L / S. Note that Properties The density and dynamic viscosity of water at 10e are p999.7 kg / m and 1.307 X100 kg / m3
What is the pressure drop in the blood as it passes through a capillary 1 mm long and 2 μm in radius if the speed of the blood through the centre of the capillary is 0.66 mm/s ? (The viscosity of whole blood is 4 x 10-3 Pa.s?A. 2.6 kPaB. 10.5 kPaC. 34.5 kPaD. 23.5 kPa