phases vertical separator that handle specific stream. The stream has gas flow rate arou 3.5MMscfd, working at 300 Psia and 20 °C, the amount of condensate load 120/bbl./MMscfd retention time is 288 sec., if density of gas 4.7 lb./cuft and liquid 34.5 lb./cuft. It is possible to separator has size (24in. x10 ft) to handle this stream? Compressibility factor 0.86 Gas sizing constant K 0.10

Q: The velocity profile for a fluid flow down an inclined plane is given by: g.sin(0) (H.y- -2). ), V u…

A:

Q: The free energy change for the following reaction at 25 °C, when [Co²+] = 1.15 M and [Cd²+] =…

A: Given that T=25 C△G= -36.7 KJ

Q: A wet sphere of gelatin gel at a temperature of 20 "C contains a uniform concentration of urea of…

A:

Q: 3.  A) A 3000 A0 initial oxide is to be grown on the Si wafer. The process is to be carried out at…

A: Given that- Initial thickness of oxide layer to be formed is,…

Q: Derive a mathematical representation of the mass flow rate of species I entering or exiting the…

A:

Q: Calculate the heat required to raise 11b mole of 1-butene at 600°F to 1000°F. Given that Cp=3.909…

A: Heat required to raise the temperature of I-butane is to be calculated. Given: Moles of I-butane, n…

Q: Q3/ An Orsat analysis produces dry basis composition as showing in the table: Composition N₂ 67% CO₂…

A: Given that, The mole fraction of dry gas in the stack gas xdry gas = 0.95 The mole fraction of water…

Q: 7.10. A cylinder with a movable piston contains 4.00 liters of a gas at 30°C and 5.00 bar. The…

A: Given Data T = 30 oC V = 4.00 liters P1 = 5.00 bar P2 = 8.00 bar The compression work done on the…

Q: Flash distillation is used to evaporate half of a 40 mole% methanol-water mixture. The pressure is 1…

A: A mixture of methanol-water is to be flash distilled.

Q: Q2// For the liquid phase reaction A D, with second-order kinetics and CAo = 1 mol.L-¹, we get 35%…

A:

Q: A 4-m high and 6-m-wide wall consists of long 15-cm x 20 cm cross section horizontal bricks (k of…

A:

Q: If ice homogeneously nucleates at -57.8°C, calculate the critical radius given values of -3.1 x 108…

A: given = Tm = 0^c = 273 K T = -57.8^c = 215.2 K y = 25*10-3 J/m2 ∆Hf = -3.1*108 J/m3

Q: Problem 3: A small lake with volume 10,000 m³ has a stream flowing into it with flow rate 100 m³/day…

A:

Q: lodic acid is added to 29.4 mL of calcium sium hydroxide is required to reach neutra original…

A: Given that  The volume of the hydrochloric acid V1 = 36.7 mL. Molarity of the hydrochloric acid M1 =…

Q: 104: Hot liquid is flowing at a velocity of 2 m/s through a metallic pipe having an inner diameter…

A:

Q: the total of hardness of asample has calcium contailut of 28 my IL and mognasium in term of Cacos…

A: Given that, in CaCO3,- Calcium content (Ca)=28 mg/L Magnesium content (Mg)= In terms of CaCO3  From…

Q: Water is flowing through a pipe of 5cm diameter under a pressure of 29.43N/cm² (gauge) and with mean…

A:

Q: What is the atomic packing factor for simple cubic structures and the ratio of this factor to that…

A: To find Atomic packing factor for simple cubic structures, FCC, and find the ratio of Atomic packing…

Q: Question (2): An element in plane stress at the surface of a large machine is subjected to stresses…

A: Given that  σx = 15000 psi σy = 5000 psi τxy = 4000 psi we need to calculate…

Q: reactor should be maintained in excess of 4 to minimize the chance of other unwanted side reactions.…

A: The desired product C is formed by the reaction of A and G in the gas phase.

Q: 2. Consider the P-x-y diagram at 300 K for A-B mixtures at right. (a) What are the vapor pressures…

A: The P,x-y diagram of a mixture represents the distribution of species in liquid and vapor phase with…

Q: Exercise 4.1: CSTR Design Using Damköhler Number (Da) The elementary reversible reaction A + B 2 C…

A: A reversible, elementary reaction is carried out in a CSTR.

Q: 914. Normal heptane is dehydrocyclicized to toluene and hydrogen in a continuous vapor-phase…

A:

Q: 2C is carried out isothermally Q3// The gas phase reaction 2A + B isobarically. The reaction is…

A: Given reaction is- 2A+B→2C Specific reaction rate constant, k=4.0 dm3/mol.s Conditions are…

Q: Air is to be dehumidified by condensing the water vapour present in it by cooling at constant…

A:

Q: Propylene is produced by the dehydrogenation of propane. The product stream leaving a…

A: Reactor effluent is fed to two distillation columns connected in series.

Q: Over a 0.1 m X 0.1 m sheet at 175°C, air flows at 25°C and 1 bar with a velocity of 1 m/s. Calculate…

A:

Q: A storage vessel exposed to atmosphere (absolute pressure = 10.3 m of water) has a diameter of 3 m…

A: Net Positive Suction Head (NPSH) available (NPSH) is the amount of pressure available at the suction…

Q: Lat a total pressure of 1.25 atm. How many moles of c sure of water is 23.8 mmHg at 25.0°C.

A:

Q: Consider the excess chemical potential of a gas, x= μ- where is the ideal contribution. Show that it…

A: Given The excess chemical potential of a gas μex=μ-μig Where  μig-Chemical potential for Ideal gas…

Q: The water-gas shift reaction is an important industrial reaction used to generate useful hydrogen…

A: Given that  CO (g)   +  H2O   (g)       ↔   H2   (g)    +    CO(2)       (g)     Flow rate of feed…

Q: Calculate the heat needed for the expansion of a quantity of 0.073 Kg of saturated dry steam to a

A: For saturated dry steam, the specific heat can be determined using the Steam Tables. At a pressure…

Q: If E> 0, in which direction will the cell reaction proceed, and conversely if E<0, in which…

A: Effect of E on the direction of cell reaction is to be discussed.

Q: Q2. Consider a fuel which is an equimolar mixture (1 mole each) of propane (C3Hs) and methane (CH4).…

A: Given that, The number of moles of propane C3H8 in the fuel = 1 mol The number of moles of methane…

Q: Consider the following phase diagram of a three-component system of A. B and C. Q15. The plait point…

A: Ternary phase diagram represents the distribution of components in single- and two-phase region in…

Q: The temperature on one side of a 6-in. thick solid wall is 200°F and the temperature on the other…

A: Given that, Thickness of the solid wall x = 6 in × 1 ft12 in = 0.5 ft Temperature on one side of the…

Q: We want to flash distil a binary mixture feed with 60% A and 40% B. Feed flow rate is 100 kmol/hr.…

A: Note: We are authorized to answer one question at a time, since you haven not mentioned which…

Q: What control pH in seawater?

A: Given that As it is given that which control pH in seawater

Q: 31 These 3 wells have been drilled with a mud of specific gravity of 1.25 gr/cm3. In which well A, B…

A: Hydrostatic bottom hole pressure of each well is to be determined.

Q: wife State the limitations of the emf series and the advantages of galvanic series for an engineer?

A: The limitations of emf series and advantage of galvanic series are to be outlined.

Q: How did you get the overall cp value?

A: Given that Cp value of given substance which are used in reaction are given in table form

Q: Krypton is compressed adiabatically in a closed system from initial pressure P1 = 1 bar, T1 = 9 oC…

A:

Q: A set of four reversible elementary reactions that describe the oxidation of CO to CO2 in the…

A:

Q: A bituminous coal has the following compositions: C = 71.6 %, N2 = 1.3 %, A = 9.1 %, H2 = 4.8 %, S =…

A: Given data: C = 71.6 %, N2 = 1.3 %, A = 9.1 %, H2 = 4.8 %, S = 3.4 %, W = 3.5 %, O2 = 6.3 %.…

Q: Calculating V for any vapor using the ideal gas law will be within 10% of it's actual value. True…

A:

Q: Acetone is to be recovered from a 8 % acetone-air mixture by scrubbing with water in a packed tower…

A: Given that- Acetone has to be recovered from 8% acetone-air mixture. Liquid flow rate,  L=1.85…

Q: An unknown polymer sample was found to have the following molecular weight distribution: Molecular…

A:

Q: A three dimensional velocity field is given by V=5x yi+ Cyj-10 xyzk, where i, j, k are the unit…

A:

Q: Hello, please kindly help me with this Chemistry exercise with all the steps, thanks a lot!…

A: Volume of butane = 6 L

Q: A certain reaction is first order, and 1080s after initiation of the reaction, 32.5% of the reactant…

A: Time after which 32.5 % of initial reactant remains = 1080 s