Bonus: The figure shows a long straight current-carrying wire near a rectangular conducting loop. (a) If the current in the long straight wire decreases, what is the direction of the induced current in the loop? Explain. (b) Based on your answer to (a), what is the direction of the force on the loop? Explain your reasoning. R d to

Bonus: The figure shows a long straight current-carrying wire near a rectangular conducting loop. (a) If the current in the long straight wire decreases, what is the direction of the induced current in the loop? Explain. (b) Based on your answer to (a), what is the direction of the force on the loop? Explain your reasoning. R d to

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 86CP: The current in the long, straight wire shown in the accompanying figure is given by, where I=I0sint...

See similar textbooks

Similar questions

The north pole of a mag’iet is moved toward a copper loop, as shown below. If you are looking at the loop from above the magnet, will you say the induced convent is circulating c1ockise or counterclockwise?
The circular conducting loops shown in the accompanying figure are parallel, perpendicular to the plane of the page, and coaxial. (a) When the switch S is dosed, what is the direction of the cun’ent induced in D? (b) When the switch is opened, what is the direction of the current induced in loop D?
A reasonably uniform magnetic field over a limited region of space can be produced with the Helmholtz coil, which consists of two parallel coils centered on the same axis. The coils are connected so that they carry the same current I. Each coil has N turns and radius R, which is also the distance between the coils, (a) Find tire magnetic field at any point on the z-axis shown in the accompanying figure, (b) Show that dB/dz and d2Bdz2 are both zero at z = 0. (These vanishing derivatives demonstrate that the magnetic field varies only slightly near z = 0.)
A square bar of mass m and resistance R is sliding without friction down very long, parallel conducting rails of negligible resistance I see below) The two rails are a distance ' apart and are connected to each other at the bottom of the incline by a zero-resistance wire. The rails are inclined at an angle , and there is a uniform vertical magnetic field B throughout the region, la) Show that the bar acquires a terminal velocity given by vmgRsinB2I2cos2 Calculate the work per unit time done by the force of gravity. (c) Compare this with the power dissipated in the Joule heating of the bar (d) What would happen if B were reversed?
The current in the long, straight wire shown in the accompanying figure is given by, where I=I0sint I0=15Aand=120rad/s. What is she current induced in the rectangular loop at (a) t = 0 and (b) t=2.1103s The resistance of loop is 2.0 .
Use Lenz’s law to determine tl direction of induced current in each case.
The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible, but the section PQ has a resistance of 0.25 . (a) What is the emf (including its sense) induced in the rod when it is moving to tire right with a speed of 5.0 m/s? (b) What force is required to keep the rod moving at this speed? (c) What is the rate at which work is done by this force? (d) What is the power dissipated in the resistor?
A long solenoid of radius a with n turns per unit length is carrying a time-dependent current I(t)=I0sin(t) , where I0and are constants. The solenoid is surrounded by a wire of resistance R that has two circular- loops of radius b with b>a (see the following figure). Find the magnitude and direction of current induced in the outer
A square loop of side 2 cm is placed 1 cm from a long wire carrying a current that varies with time at a constant rate of 3 A/s as shown below. (a) Use Ampere’s law and find the magnetic field as a function of time from the current in the wire. (b) Determine the magnetic flux through the loop. (c) If the loop has a resistance of 3 how much induced current flows in the loop?
The normal to tt plane of a single-turn conducting loop is directed at an angle to a spatially uniform magnetic field B. It has a fixed area and orientation relative to the magnetic fleck Show that the emf induced In the loop is given by i = (dB/dt)(Acos),where A is the area of the loop.
Determine the magnetic field on the central axis at the opening of a semi-infinite solenoid. (That is, take the opening to be at x = 0 and the other end to be at x= .)
Please just help with this question: What would be the terminal velocity of the rod if all the conditions of part (b) of the problem where held, except there was also friction with a kinetic coefficient of ?k=0.0215? (Note: I believe the answer for b) is the induced current of 0.049 A if it helps)