Pipe in ground is moving wet raw sludge down a slope at a 30 degree angle and an elevation difference of 300 ft. Where P1 = 17 psi and P2 = 23 psi, D1 = 2 ft, D2 = 0.9 FT, Flow Rate through pipe Q= 5.8 cfs and specific gravity Weight of water and pipe = 80 lbf and maximum vertical force that can be applied to surrounding soil = 800 lbf. Is vertical force greater than 800 lbf to keep system in balance? P₁₂=23psi D₂=0.9 Ft 30⁰ P₁ =17 Psi 2 Pt=D₁

Pipe in ground is moving wet raw sludge down a slope at a 30 degree angle and an elevation difference of 300 ft. Where P1 = 17 psi and P2 = 23 psi, D1 = 2 ft, D2 = 0.9 FT, Flow Rate through pipe Q= 5.8 cfs and specific gravity Weight of water and pipe = 80 lbf and maximum vertical force that can be applied to surrounding soil = 800 lbf. Is vertical force greater than 800 lbf to keep system in balance? P₁₂=23psi D₂=0.9 Ft 30⁰ P₁ =17 Psi 2 Pt=D₁

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q3. SAE 30 oil (Sp. Gr. =0.833) with a dynamic viscosity 0.28 N.S/m? flows in a 4-cm-diameter pipe which is inclined with an angle 37°. For the pressure measurement shown, determine A. Whether the flow is up or down The flow rate in m'/h C. The shear stress and velocity 1 cm from the boundary Draw the shear stress and velocity profile with the section of the pipe. В. D. P-180 kPa P- sOokPa 15m 20m
• The pressures at the ends of 605m long horizontal pipe flow are 350kPa and 270kPa. The pressure at the point between the ends is 300kPa. The pipe is 305mm in diameter and n=0.018 • What is the total headloss? • What is the amount of flow? • What is the slope of the egl?
The compressible flow is assumed to be..?
c. Derive the expression for the friction factor, f = 64/Re under laminar flow conditions
The pipe bend shown is in a horizontal plane. Oil with a specific gravity of 0.86 enters the reducing bend at section A with a velocity of 3.2 m/s and a pressure of 150 kPa. Neglecting head loss, determine a) FMY (N) b) Fpx (N) c) Fpx (N) de = 100 mm da = 150 mm 30° A
Calculate for the hydraulic gradient if the pressure at point A is 18547N and 15874N for point B. The measured value of height h is 5m and distance L is 3m. L adedaas adedəas
Flow Between pipes A viscos flow is taking place b/w the two horizontal parallel fixed plates which are 80mm apart. The maximum velocity is 1.5 m/s and dynamic viscosity of oil is 1.962 N-s/m². The magnitude of pressure gradient in kPa/m is
PROBLEM 2 The pipe bend shown is in a horizontal plane. Oil with a specific gravity of 0.86 enters the reducing bend at section A with a velocity of 3.2 m/s and a pressure of 150 kPa. Neglecting head loss, determine (a) The velocity at section B, V (m/s) (b) The pressure at section B, ps (kPa) (с) Fмх (N) (d) FMY (N) (е) Fpx (N) (f) Fpy (N) (g) The x-component of the reaction by the bend, FRx (N) and (h) The y-component of the reaction by the bend FRY (N). de = 100 mm B- da = 150 mm 30°
A pipe conveys water with velocity 360 m/min and pressure gauge shows 5 bar pressure under which the water is following. The pipe is located at 5 metre above the datum line. The sum of total head and stagnation head is m. (g = 10 m/s?). (assume 1 bar = 105 Pa) %3D
Include a free body diagram. A 12′′ pipe is being tested to evaluate the lost head. When the flow of water is 6.31 cfs, the pressure at point A in the pipe is 40 psi. A differential gage is attached to the pipe at A and at a point Bdownstream that is 10 ft higher than A. The deflection of mercury in the gage is 3.33 ft, indicating a greater pressure at A. What is the lost head A to 5?
Draw elevation head, pressure head, and total head for the system shown and then find the velocity of the seepage in soil, if k = 0.005 m/sec and n = 0.33 3.6 3.0 2.4 1.8 1.2 0.6 -0.0 Elevation (m) Datum
1. For the setup shown, calculate the pressure difference between points 1 and 2. 2 Oil Oil sg = 0.8 sg = 0.8 1m 2.3т »Hg Hg 0.7m 0.4m 0.8m