Pitch factor depends onSelect one:Oa mechanical angle of coilO b. full-pitch coilOc. fractional- pitch coilOd electrical angle of coil

The explanation and answer are as follows.

Answered: Pitch factor depends on Select one: Oa…

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter9: Components For Electric Motors

Section: Chapter Questions

Problem 12RQ

See similar textbooks

Similar questions

A commutator has 456 segments. Indicate whether or not the windings are possible a. Duplex-wave, eight poles b. Simplex-wave, 10 poles
what is the use of DC/DC tension converter DC/DC booster MT3608
(a) Show the voltage waveforms across each half of the secondary winding and across RL when a 100 V peak sine wave is applied to the primary winding in Figure. (b) what is Vavg and fout if fin = 50 Hz?
The uniform scle of a moving coil (PMMC) instrument is due to O a. more number of turns O b. currnet O c. control spring O d. Permanent magnet
1- For Buck type DC-DC converter, the occupancy-void ratio is 0.5, the input voltage is 12V, the current of the coil is 11 = 2A. So what is the average output current? a) 16A b) 32A 8A 4A
A single phase full wave AC voltage controller has a resistive load of 5 ohms and an input voltage of Vs = 240 V (RMS), 50 Hz. The delay angles of both thyristors are set to 45 degrees. The maximum RMS and average current ratings of the thyristor are equal to: Select one: O a. 33.94A and 21.6A O b. None of these O c. 24A and 10.8A O d. 48A and 26.09A Clear my choice
Q9 / What are the function of brushes , pole and commutator in DC machine
In DC generators, lap winding is suitable for ) high voltage, high current O low voltage, high current O high voltage, low current O ) low voltage, low curren O
In DC generators brushes are used for O Collecting Current O Collecting eddy current loss O reduce eddy current loss O convert ac armaturê current in to dc
LVDT produces an rms output voltage of 5.0 V for displacement of 3.5 mm. Calculate the sensitivity of LVDT please explain me
Damping ratio quettion.
Q5. For the following center tapped transformer, show the waveform across each half of the secondary winding and across Ri, when a 100 V peak sine wave is applied to the primarywinding. What is the PIV rating must the diode have? (Use constant voltage drop model for the Silicon diode) D1 IN4001 RL out OV 10 kN IN4001 alll

SEE MORE QUESTIONS

Recommended textbooks for you

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

Pitch factor depends on Select one: Oa mechanical angle of coil O b. full-pitch coil Oc. fractional- pitch coil Od electrical angle of coil