Please can someone assist with this? Sketch circuit diagrams showing field connections
Q: 1.2 If for intrinsic Silicon at 27°C, the charge concentration and mobilities of free-electrons and…
A: Given: For intrinsic silicon the charge concentration, n=p=ni=1.5×1016m3 Mobility of free electron,…
Q: The complex number z can also be written in polar or exponential form as z = r< = re^(jo) where r is…
A: Complex number: r=x2+y2ϕ=θ=tan-1yx
Q: Q3: A static electrical device has 2000 turns uses 4000 mA from the supply connected to a laptop…
A: Since the ratings of the laptop are known, the amount of the current used by the laptop is…
Q: 19. A factory draws an apparent power of 300 kVA at a lagging power factor of 0.65. The active power…
A: Given: A factory draws an apparent power, S=300 kVA Lagging power factor, cosϕ=0.65
Q: Calculate the percentage slip of an induction motor having 6 poles fed with 50 cycles supply…
A: Given here a induction motor has 6 poles fed with 50 cyclessupply with actual speed of 980 rpm.here…
Q: half-wave rectifier circuit
A: Given- Power rating= 100 W Voltage rating = 110 V Firing angle = 60 degree
Q: An oscillator employs 1. Positive 2. Negative 3. Neither positive nor negative 4. Data insufficient…
A: The solution is provided in the following section.
Q: When a 5 A current is made to flow through a coil of 20 turns produce a flux of 10 Wb. Find the…
A:
Q: Identify the correct nodal equation that applied to the circuit below. 투 a +1 R₁ ww V C R₂ ww V₂( V₂…
A: Given circuit,
Q: When a 5 A current is made to flow through a coil of 20 turns produce a flux of 10 Wb. Find the…
A: Given data, Current i = 5 A Number of turns N =20 Flux ϕ=10 Wb Rate of change of current didt=8…
Q: Briefly explain what you mean by discrete system and continuous system.
A:
Q: A two-winding transformer is rated at 60-kVA, 240/1200-V, 60-Hz. When operated as a conventional…
A:
Q: One of the disadvantages of PCM is a. It requires large bandwidth b. Very high noise c. Cannot be…
A: The correct option along with the explanation is provided in the following section.
Q: For the circuit shown, calculate power at W1.
A: It is given that:
Q: The equation for 25Hz current sine wave
A: Given- Frequency= 25 Hz RMS value of wave= 30 A To find- Equation of sine wave= ?
Q: V R ww 2₁ + Vcc Vo - ↓ A ww Q2 R V+ -VEE 1. Show that the voltage VO has the form: Vo = R*IA*tanh(Vd…
A:
Q: 1.2 mA 77 3 ΚΩ ww NE Given the current to voltage converter, determine the load voltage.
A: For the given current to voltage converter calculation of load voltage. It is an inverting type…
Q: liberated by thermionic emission provide the conduction currents of vacuum tubes.
A: A vacuum tube is mainly composed of two elements:- 1. Cathode 2.Metal plate Cathode is the…
Q: A three phase, 13 kV transmission line delivers 8 MVA of load. The per phase impedance of the line…
A: Given data: The voltage =13 KV The volt-amp =8 MVA=8×106 VA The expression for per unit impedance…
Q: Find the equivalent capacitance between points A and B of the given circuit 3.5 uF 5.0 μΕ 8.0 µF 1.5…
A: The equivalent capacitance can be calculated by reducing the parallel and series connected capacitor…
Q: A voltmeter having a sensitivity of 11000 n/V reads 100 V on its 150. V scale when connected across…
A:
Q: The quantum efficiency (n) and responsivity (R) at a wavelength 2 (in µm) in a p-i-n photodetector…
A: Given Responsibility Quantum efficiency wavelength
Q: If an AC signal has a peak voltage of 55V, what is the average value voltage?
A: Given thatPeak voltage of AC signal (Vm)=55VWe have to find the average voltage.
Q: Hartley oscillator is commonly used in.
A: The correct option along with the explanation is provided in the following section.
Q: If the input voltage to a voltage tripler has an rms value of 117.3V, the average output voltage (in…
A: Input voltage of a tripler circuit is Vi = 117.3 V (RMS) Average output voltage Vo = ?
Q: (1) Ra M - elle N₂=1000 J = 5 kg-m² D = 2 N-m s/rad |N₁ = 100 0(0) = 700 kg-m² BEHARD DL= 800 N-m…
A:
Q: What is the maximum transmission efficiency of an AM signal?
A: The correct option along with the explanation has been provided in the following section.
Q: Solve the IT, IE, Vc. The beta for 2N2222 silicon transistors is 10
A:
Q: Consider power factor PF=0.85 if needed Building Size: 3,800 square feet (exclusive of an…
A: Given Water heater rating =28 kVA HVAC system : 240 V, 17.9 A with air handler = 3.3 A
Q: Find 12 in the circuit shown below. 13 3Q 50L0° 712 a) 8.72-1.37⁰ b) 32-48.7° 5+j6 30/90° 6-j5 c)…
A:
Q: ) Two feedback configurations are shown in Figures Q1.a(i) and Q1.a(ii). Derive the closed-loop gain…
A: Here Given two figures having feedback.
Q: The quantum efficiency (n) and responsivity (R) at a wavelength λ (in um) in a p-i-n photodetector…
A: Given: quantum efficiency=η Responsivity=R Wavelength=λ
Q: A delta-connected unbalanced load is connected across a three-phase balanced source. The sequence…
A:
Q: image
A:
Q: 2. Determine I using superposition theorem. Show circuit with each independent source acting alone…
A:
Q: An oscillator employs ...... 1. Positive 2. Negative 3. Neither positive nor negative 4. Data…
A: The correct option along with the explanation is provided in the following section.
Q: In a torsion head type electrodynamometer a current of 25 A requires a deflection of 90° in the head…
A: We have been given an electrodynamometer with, I = 25 and θ = 90° and We have been asked to find,…
Q: In case of a 4-pole machine, 1 mechanical degree corresponds to (i) 2 (ii) 4 (iii) 8 electrical…
A: Given a machine having, Total number of pole, P = 4 Mechanical degree, θm=1° Electrical degrees,…
Q: One of the disadvantages of PCM is
A: The correct option along with the explanation is provided in the following section.
Q: 1. TAL FIND TOTAL RESISTANCE: -RT. 32 32 # 2122 222 12 le the 2 FIND THE TOTAL CURRENT 222 30
A:
Q: The modulation techniques used to convert analog signal into digital signal are a. Pulse code…
A: The correct option along with the explanation is provided in the following section.
Q: Problem 1: Suppose voltmeter is used to measure the voltage across the 40 resistor. for the circuit…
A: Given circuit:
Q: Calculate the percentage slip of an induction motor having 6 poles fed with 50 cycles supply…
A:
Q: 1. Discuss the functions and application of at least 3 protective relays that are being used in 13.2…
A: The protective relays in an Electrical distribution system are used for preventive management of…
Q: Problem 11. An underground cable has the follow- ing primary constants: resistance R = 10 22/loop…
A: Given: An underground cable has the following primary constants: Resistance, R=10 Ωloop km…
Q: The phase A sequence components of three-phase current are: lao = 0; la1 = 90+j5.8; la2 = 10- j5.8.…
A:
Q: A coil of inductance 85 mH and negligible resistance is connected in series with a capacitance of…
A:
Q: A wave traveling in free space with parallel polarization is incident upon a pefectly conducting…
A:
Q: 3. Determine using 12 V (+) 82 fl perposition t +31 UNI D W S 1052 M 1) за ition to jefto@mapua.edu
A:
Q: The voltage sensitivities of Barium Titanate and Quartz are respectively 12 × 10-³ Vm/N and 15 ×…
A: Given, For Barium Titanate: Voltage sensitivity = 12×10-3 VmN Permittivity = 12.5×10-9 Fm For…
5
Step by step
Solved in 2 steps with 1 images
- Q16/ choose the correct answer DC Compound generator has only shunt field winding?. Select one: True False50 KW, 240 V enduvi resistance of a generator with foreign excitation is 0.02 ohms. Generatorproduces rated voltage at rated load. Endüvi voltage and endüvi current at rated loadcalculate? If the output voltage is kept constant at 240V and the output power is reduced to 45 KWfind the enduvi tension necessary for this?A compound dc generator is supplying a load of 120A and 120V. The shunt field,series field and armature resistances are 32 ohms 0.07 ohms and 0.1 ohms respectively. Find the generated voltage in LONG SHUNT CONNECTION and SHORT SHUNT Connection NOTE: DRAW THE EQUIVALENT CIRCUIT DIAGRAM
- Load characteristic of DC generator is a graph between Il and Vt. True or FalseA long shunt compound de generator delivers a load current of 70 A at 384 V and has armature, series field and shunt field resistances of 0.098 ohms, 0.026 ohms, and 264 ohms, respectively. Calculate the armature current in ampere.A short shunt compound generator has an armature, shunt field and series fieldresistances of 0.02 ohm, 80 ohm and 0.03 ohm respectively. The generator’s induced emfis 510V when the terminal voltage is 500V. How much load current is delivered underthis condition? Answer: 197.47A
- A polyphase system is generated by______? a.Both a and c b.Having two or more generator windings separated by equal electrical angle c.Having generator windings at equal distances d.None of theseA d.c. shunt-wound generator running at 10rps generates a voltage of 150V at a certain value of field current. Determine the change in the generated voltage of same generator when running at 5rps, the field current is reduced by 50 percent, assuming the flux is proportional to the field currentNeatly please 3. Draw the block diagram of a DC Generator?
- The DC generator in Figure 4 on Worksheet 4 is a_______a) cumulatively connected short-shunt compound DC generator b) differentially connected long-shunt compound DC generator c) differentially connected short-shunt compound DC generator d) series DC generator1. A) What is a compound DC generator? a) a generator which utilizes a shunt or a series field b) a generator which utilizes both a shunt and a series field c) a generator which utilizes both separate and self excitation d) none of the above B) What is a cumulative-compound generator? a) a generator where the series and shunt fields work together in the same direction b) a generator where the series and shunt fields work against each other c) a generator where the series and shunt fields are not energize at the same time d) none of the aboveDC Shunt Generator No-Load Characteristics Please draw the curves for both cases and mention the scale for each on a graph paper. Please use graph paper only.