1. TAL FIND TOTAL RESISTANCE: -RT. 32 32 # 2122 222 12 le the 2 FIND THE TOTAL CURRENT 222 30

Q: A two-winding transformer is rated at 60-kVA, 240/1200-V, 60-Hz. When operated as a conventional…

A:

Q: a) Two feedback configurations are shown in Figures Q1.a(i) and Q1.a(ii). Derive the closed-loop…

A:

Q: 1 Consider a periodic pressure-time record as shown in the figure below. Determine its frequency…

A:

Q: is C 1.1 A specimen of intrinsic germanium with the 1.5 In density of charge carriers of 2.5 x…

A: This problem is from basic of electronics .

Q: 0 1 0 0 1 1 0 1 1 TIT 15 14 13 12 11 1 1 K O Figure 1 1. Referring to Figure 1, predict the output Q…

A:

Q: If an npn silicon transistor is operated at VCE = 5 V and Ic= 100 μA and has a current gain of 100…

A: GIVEN             VCE = 5 V               IC  = 100 μA               β   = 100               Rin = ?

Q: Use the node-voltage method to find V and I in the circuit (write your answer on the backside if you…

A: Given: a network independent and dependent sources.  we have to determine the V0 and I0 in the…

Q: Hartley oscillator is commonly used in ...... 1. Radio receivers 2. Radio transmitters 3. TV…

A: The solution is provided in the following section.

Q: Exercise 1: Define in scilab the row vector V = [1 4 17 23 10] 1. Transform the vector V into a…

A: 1. Command for transform into column vector  V=[1 4 17 23 10]                     (This command is…

Q: Find the Thevenin equivalent with respect to the terminals a,b and determine the current across 1.5…

A: Given: A network consisting of independent voltage and current source with few resistances.  we have…

Q: 4. A series circuit is composed of a 6 V battery, a diode, and a 100-ohm resistor for a forward bias…

A:

Q: Three identical loads having an impedance of (8.66 + j5) are connected in wye across a balanced…

A: Given: Impedance, Z=(8.66 + j5)Ω Line voltage, VL=330V

Q: The power taken by an inductive circuit when connected to a 230 V, 60Hz supply is 800W and the…

A:

Q: A communications channel with a bandwidth of 4 kHz has a signal power to noise ratio of 7. The…

A:

Q: (a) Consider the circuit shown below, determine the power dissipated in the diode. R = 2 kΩ ww ID +…

A: Given data,

Q: Figure 3 illustrates a thyristor phase control circuit and associated waveforms. Describe the…

A: Thyristor:- It is a four-layer power electronics device. A gate, a cathode, and an anode are the…

Q: Find the Transfer Function of the system modele by d²y(t) dt² d³y(t) dt3 Select one: +38 OH(s) +35³…

A: Given data, Differential equation is given as, d3ytdt3+3d2ytdt2dt+2dytdt=d2xtdt+3xt

Q: A three phase star connected load has an impedance of 12 + j18 Ω per phase. A voltage of 440 V 3…

A:

Q: A 440-V shunt motor has armature resistance of 0.9 Q and filed resistance of 1800. Determine the…

A: Given, A shunt motor has, Terminal voltage, V=440 V Armature resistance, Ra=0.9 Ω Field resistance,…

Q: R(s) + E G(s) = = k G H(s) G(s) = (s+P₁) (s+P₂ (1) Find the CLTF and OLTF for the following system…

A: Given, Gs=Gs+p1s+p2Hs=1s+p3G=40.0p1=7.0p2=3.0p3=2.0

Q: In a 3-phase power measurement by two wattmeter method, both the wattmeters had identical readings.…

A: Given data, Both wattmeter has identical reading, P1=P2

Q: Hartley oscillator is commonly used in.

A: The correct option along with the explanation is provided in the following section.

Q: Complete the timing diagram for the following circuit: A B C DE ABC Full-adder CI ABC A B C…

A: Multiplexer is data selector .It select one of its input as per select line and give one output.…

Q: If an npn silicon transistor is operated at VCE = 5 V and /c = 100 μA and has a current gain of 100…

A: Given: npn transistor VCE=5VIc=100μA Current gain, hfe=100 Thermal voltage, VT=25mV

Q: Q2- A- Find the static steady-state error shown by the system of open-loop transfer function…

A: The steady state can be calculated by using the general error signal representation and by using the…

Q: Sketch magnitude and phase characteristics of the bode plot for the transfer function. Find actual…

A: Given:  Transfer function of a filter.  We have to draw the bode plot for magnitude as well as…

Q: In the circuit at right, a 100 mH inductor and a 5 N resistor are connected by a switch to a 6 V…

A:

Q: Find the inverse laplace transform  1.F(S)= 3/4s 2.X(S) =1 /s^2+4

A:

Q: Find the power absorbed by the resistor (10 Ohm) i www ΖΩ + 12 V 30 24 V + 6Q 36 V - 10 Ω

A: Given a circuit Find power absorbed by 10Ω resistor using source transformation.

Q: Ad Zeq- Bo O a. Ο b. Ο c. O d. 1 Ω -j2 Ω Zeq = 3,8 - j0,6 Ω Zeq = -3,8 - j0,6 Ω Zeq = 3,8 + j0,6 Ω…

A:

Q: The following table gives a set of 10 measurements that were recorded in the laboratory. Calculate…

A:

Q: 7. The armature of a d.c. generator has a 2-layer lap-winding housed in 72 slots with six con-…

A: Given data of DC Generator, Double layer generator,  Lap wound, No. Of slots (s) = 72 Conductors/…

Q: From the circuit shown, if the inputs A and B are both 1, Q3 is/has: a.) a collector-emitter…

A:

Q: The line to ground voltage on the high voltage side of a step-up transformer are 100 kV, 33 kV, 38…

A: Given that A Phase voltage is 100 kV. B Phase voltage is 33 kV. C Phase voltage is 38 kV. The…

Q: A bridge consists of the following elements as : Arm AB: A choke coil having a resistance R, and…

A:

Q: 15 A transformer has a primary with N₁=10,000 turns, (4.6) and a secondary with Nz = 2,000 turns.…

A:

Q: Find the number of commutator segments required in a 6-pole dc machine having s simple wave-wound…

A:

Q: Example 9.2: A residential building has following load connected in it. Incandescent lamps 100 W…

A:

Q: 3. Determine using 12 V (+) 82 fl perposition t +31 UNI D W S 1052 M 1) за ition to jefto@mapua.edu

A:

Q: Find the series equivalent indoctance and resistance at the network that causes such a bridge to…

A:

Q: The differential gain is ......... 1. very high 2. very low 3. dependent on input voltage 4. about…

A: The correct option along with the explanation is provided in the following section.

Q: The floor area of a room is 10 m x 10 m. The desired illumination level is 150 lux. Assume the…

A:

Q: An amplifier without feedback has a gain of 1000. What is the gain with a negative feedback of…

A: Given, An amplifier gain without feedback, A = 1000 A Negative feedback with feedback factor,…

Q: Briefly explain what you mean by discrete system and continuous system.

A:

Q: Find the equivalent resistance of the circuit in the Figure P18.9 3.00 Ω 10.0 Ω www 5,00 £2 www 4.00…

A: Given data, Circuit diagram is given as,

Q: Find currents 11,12, and 13 in the circuit.

A: The current through the mesh can be calculated by using the mesh analysis after applying dot…

Q: image

A: Given,  a=2m b=1m I=10A B→=x k^ μT Fon each segment = ? Fnet=?

Q: The resistance between any two terminals of balanced star connected load is 12 ohms. Find the…

A: Given that system is balanced and star connected. Resistance between any two terminals is 12 ohms…

Q: One of the disadvantages of PCM is a. It requires large bandwidth b. Very high noise c. Cannot be…

A: The correct option along with the explanations is provided in the following section.

Q: J Connect the following equation using the NaNd gate 1- x (x+y) 2- M+A(ZM) Connect the following…

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.