Plz solve both , i vll share positive feedback and vll upvote....ASAP PLZZ 3. Determine the total current (Itotal) given the forward voltage drop of the diode is 0.7V, the forward voltage drop of theLED is 2.1V, R1=50 , and R2=100'#Itotal+9V100 Q R2www50 QR1 4. The forward voltage drops for the three diodes are all 0.7.VR1=1,000 2. R2=2,000 2. R3=3,000.Determine the value of I₁, I₂, I3, and Ip. Show your calculation process.1 ΚΩR₁13 3 kn R3MIDKK2 KQM+9VR₂

The given questions require finding the current drawn by diode and LED when operating in forward…

Answered: Plz solve both , i vll share positive…

Engineering

Electrical Engineering

Plz solve both , i vll share positive feedback and vll upvote.... ASAP PLZZ

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 3RQ: Diodes and rectifiers allow current to _________. flow in one direction only flow in both...

See similar textbooks

Related questions

Q: TOPIC: Transmission Lines, Power Systems, and Powerplants: INSTRUCTIONS: - Answer in this format:…

A: Introduction Three-phase Short Transmission Line: A three-phase short transmission line is a power…

Q: Try to solve both the parts Q57)

A: Given: Resistor is Rx=12 kΩ Other resistors are R1=3kΩ, R2=7 kΩ, R3=3 kΩ

Q: 3. Two adjacent regions decide to interchange power with each other to reduce their costs. The…

A: Given data The incremental cost IC and total general cost for two systems (System-1 & System-2)…

Q: 6. Use nodal analysis to find various branch currents in the circuit of Fig. 2.88. [Hint: Check by…

Q: In the circuit in (re), svetch has been in position and swich 2 has been closed for a long time. Att…

A: It is given that:

Q: 1. The no-load voltage of a 50 kW, 220 Volts, shunt generator in the CIT Lab is 232 volts and rated…

Q: mnsider the circuit in (Figure 1). Assume that v, = 640 V and i, = 12.8 Α. re Us 3Ω www www 2Ω + U1…

Q: A point in Cartesian coordinate is represented as P (1, 3, 5). The point P in spherical coordinate…

A: Given: Points in cartesian coordinate, Px, y, z=P1, 3, 5 The points in spherical coordinates, Pr,…

Q: Two storage batteries, A and B, are connected in parallel to supply a load the resistance of which…

Q: Refer to the circuit below 3 V 2 kn www 7 mA+ I kn www. a 5 kn what is the open-circuit voltage…

Q: 1 In 1 一 S+1 Transfer Fcn s+3 Transfer Fcn1 1 s+ 2 Transfer Fcn2 Determine the transfer function for…

A: A transfer function is a useful tool for visualizing the input-output connection of a linear,…

Q: 5- Find the input x(n) that will produce a response, y(n) = 6(n), for a system described by the…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: A power system has two synchronous generators. The Governor-turbine characteristics corresponding to…

A: Given: A power system has two synchronous generators, the governor turbine characteristics…

Q: b) Consider a MOSFET circuit with transistor parameters VTN=0.8V, KN=0.85 mA/V² and A=0.02V-¹.…

A: We need to find out the value of unknown resistance and small signal parameters and Gain for given…

Q: stion In a series R-L-C AC circuit, the total impedance Ztot will always be larger (or equal) in…

Q: What is the voltage VCE, and the collector current Ic in Fig. below? R₁ 10 ΚΩ R₂ 2.2 ΚΩ Vcc +25 V Rc…

Q: Refer to the circuit below 3 V 2 kn www 7 mA + 35kn IkQ ww what is the thevenin's resistance across…

Q: 23. State and explain Kirchhoff's current law. Determine the value of R, and R₁, in the network of…

Q: The per-unit impedance of a system is 0.7 pu. The base KVA is 300 kVA, and the base voltage is 11…

Q: Calculate the upper and lower expected resistance values for a red-green-orange-silver resistor.

Q: Given: IA = 51 amperes, VB = 25 volts, R1 = 1/2 ohm, R2 = 1/3 ohm, R3 = 1/4 ohm, R4 = 1/4 ohm, and…

A: answer: given that current IA =51 A resistances are R1= 1/2 ohms, R2=1/3 ohms, R3=R4=1/4 ohms, R5…

Q: The positive, negative-, and zero-sequence reactances of a 20-MVA, 13.2-kV synchronous generator are…

Q: TOPIC: Transmission Lines, Power Systems, and Powerplants: INSTRUCTIONS: - Answer in this format:…

A: Given the information, The per-phase constants Voltage (Vt )=345-kV 3-phase Line of length…

Q: 1. (a) Write a function file that can be used to calculate the equivalent resistance of n…

A: According to the bartleby's guidelines we have to solve only one question posted by students so…

Q: A. Condition 1 You have 2 push buttons and 1 lamp. The lamp will turn "ON" if either of the 2 push…

A: We need to create a PLC program for the following conditions The lamp will be turn ON if either of…

Q: 9.57 Use the node-voltage method to find V, and I, in the circuit seen in Fig. P9.57. Figure P9.57…

A: Given: Here, use the node-voltage method to find Vo and Io in the circuit. And the given circuit is,

Q: For the system shown below, a) Determine the system type. b) Prove that the system is stable. c)…

A: Introduction Stability of the control system: Stability is an essential property of a control…

Q: For the circuit of Figure Q2, calculate; Iz. IB. Ves and le 8-100 and Vag=0.7V R1 10K *2 0+20V R3 1K

A: We need to find out the current and voltage for given circuit.

Q: Refer to the circuit below and use nodal analysis 2A(+ 202 Va 40 www 3V Vb 892 ww What is the…

A: There is a voltage source between nodes a&b, so both nodes are considered as a SUPERNODE . The…

Q: Draw the output wave Vrms across the lamp RL

A: Given a light is connected across scr circuit as shown below. The output voltage waveform is drawn…

Q: a + V1 122 www 223 b 221 For the circuit shown in Figure (V₁-15.5 V, V₂=8.4 V, ₁=6.36 , ₂=2.262,…

A: We need to find out current and potential difference for given circuit

Q: Draw the circuit using NOR gate ONLY : 3- input NOR gate can be used. (E+B) . (E+D+A) . (E+D+C)

A: We need to design the given Boolean expression by using of NOR gate ..

Q: The following are data pertaining to three units in a plant: Unit 1: Min: 150 MW Max: 600 MW C(1) =…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: Explain in detail how we get the boolean expression from this kmap plz with all the steps

A: The given K-MAP table is shown below, From the given table, The minterms function is given…

Q: When the winding c-d of the single-phase, 50 Hz, two winding transformer is supplied from an AC…

A: Given data- Rated voltage E=200 V, Area A=5000 mm2, Length l=500 mm, Relative permeability- μr=5000,…

Q: E www R

A: We need to find out voltage across resistor for given circuit .

Q: Using Boolean algebra techniques, simplify the following expressions as much as possible AB'C + A'BC…

A: Given data, Function is given as, F=AB'C+A'BC+A'B'C.

Q: refer to the circuit below, if R = 5 ohms, V1 = 10V, V2 = 4V and Is = 2A. Is R V₂ what is the total…

A: given circuit. we have to calculate total current through the resistor

Q: -) In the following circuit using Kirchhoff's find: a) The current in each branch of the circuit. b)…

Q: An Intel 8085 processor is executing the program given below. MVI A, 10H MVI B, 10H BACK NOP ADD B…

A: In given code meaning of instructions are: ADD B: This instruction adds the contents of register B…

Q: 17. Two storage batteries are connected in parallel to supply a load having a resistance of 0.12 The…

Q: Determine current in 10-Q resistor using Norton's theorem in the circuit shown in the figure below.…

Q: A half-wave thyristor converter supplies a purely inductive load, as shown in Fig. If the triggering…

A: Given: Half wave thyristor converter supplies a purely inductive load. The triggering or firing…

Q: Problem 3- Using superposition to find the voltage V2 for the network. EQ 36 V R₁12K0 V₂ R₂6.8 k 9…

Q: A voltage using a 20 microamp meter movement has a sensitivity of O 20,000 ohm/volt O 20 micro…

A: Given data: A voltage using a 20 microamp meter. Full scale deflection current, Ifs=20 μA.

Q: Us +1 Γι' Μ 6Ω 8Ω 8 Ω

Q: For the quad system shown below, calculate the improvement factor over a single diode The following…

A: Given a quad system, all diodes are identical. Probability of the normal operation of the diode…

Q: The op amp in the figure is ideal. (Figure 1). Figure 60 kn w 20 kn w 36 kn w 270 kՈ Հ 180 kn w va…

Q: i dont understand where va and vb came from and even if ib=0 how did u get the formula following it,…

Q: For the electrical system find the state equation between the input x(t) and the output y(t) 0.5 F *…

A: 'Since you have asked multiple questions, we will solve the first question for you. If you want any…

Question

100%

Plz solve both , i vll share positive feedback and vll upvote....

ASAP PLZZ

3. Determine the total current (Itotal) given the forward voltage drop of the diode is 0.7V, the forward voltage drop of the
LED is 2.1V, R1=50 , and R2=100'
#
Itotal
+9V
100 Q R2
www
50 Q
R1

4. The forward voltage drops for the three diodes are all 0.7.V
R1=1,000 2. R2=2,000 2. R3=3,000.
Determine the value of I₁, I₂, I3, and Ip. Show your calculation process.
1 ΚΩ
R₁
13 3 kn R3
M
ID
KK
2 KQ
M
+9V
R₂

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the difference between a diode and rectifier?
Diodes and rectifiers allow current to _________. flow in one direction only flow in both directions divide paths of flow none of the above
What is CEMF?
Determine the output waveform of the biased clipper below using the simplified diode model.a.) Analyze the behavior of the circuit and fill up the table below. Vin Diode State (Forward Biased or Reversed Biased) Vout 5V 7V 0V -3V -6V b.) Draw the output waveform.
Determine the diode current (in Ampere) at 70°C for a silicon diode with reverse saturation current 70 nanoAmpere and an applied forward bias of 0.8 volts. The constant k value is: The Temperature (in Kelvin) is: The Diode current (in Ampere) is:
How can you use a zener diode? Please choose one: a. Voltage reference b. both of the above c. constant current source D. none of the above
What are the values of IS and n for the diode in the graph shown? Assume VT =0.0259 V.
1. Draw the output voltage waveform for each circuit in Figure below and include the voltage values. N +5V +50V Vin R Va R o 0% Y 9 33k 5 Vo -5V -50v I I (@ () a. Whatis the peak inverse voltage across each diode in Figure above? b. What is the peak forward current through each diode in Figure above?
A diode is operating with iD = 300 μA and vD =0.75 V. (a) What is IS if n =1.07? (b) What is the diode current for vD =−3 V?
The saturation current for diodes with the same part number may vary widely. Suppose it is known that 10−14 A≤ IS ≤10−12 A. What is the range of forward voltages that may be exhibited by the diode if it is biased with iD =2 mA?
one of the following is the configuration of power diode. a. PNP b. PIN c. PN d. PNPN
A diode has IS = 20 fA and n = 1. (a) What is the diode voltage if the diode current is 100 μA at T = 25◦C? (b) What is the diode voltage at T = 50◦C? Assume the diode voltage temperature coefﬁcient is −1.8 mV/K at 0◦C.