Porous stone h Soil specimen Porous stone . Graduated flask Refer to the constant head permeability test shown in the figure above. For a test, these values are given: L = 280 mm Area of the specimen A = 175 cm? Constant head difference h = 500 mm Water collected in 3 min Q = 600 cm³ Calculate the hydraulic conductivity in cm/s. (Enter your answer to three significant figures.) k = cm/s

Porous stone h Soil specimen Porous stone . Graduated flask Refer to the constant head permeability test shown in the figure above. For a test, these values are given: L = 280 mm Area of the specimen A = 175 cm? Constant head difference h = 500 mm Water collected in 3 min Q = 600 cm³ Calculate the hydraulic conductivity in cm/s. (Enter your answer to three significant figures.) k = cm/s

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.23P

See similar textbooks

Similar questions

Solve for the ratio of equivalent hydraulic conductivity with the following given: h1 = 2 m h2 = 2.5 m h3 = 1.8 m h4 = 0.9 m k1 = 1.5E-3 cm/sec k2 = 2.2E-4 cm/sec k3 = 1.6E-4 cm/sec k4 = 4.0E-4 cm/sec What is the equivalent coefficient of permeability if the water flows perpendicular to the layer of soil (KeqV) in cm/sec?
Solve for the ratio of equivalent hydraulic conductivity with the following given: h1 = 2 m h2 = 2.5 m h3 = 1.8 m h4 = 0.9 m k1 = 1.5E-3 cm/sec k2 = 2.2E-4 cm/sec k3 = 1.6E-4 cm/sec k4 = 4.0E-4 cm/sec What is the equivalent coefficient of permeability if the water flows parallel to the layer of soil (KeqH) in cm/sec?
A sample of sand, 5 cm in diameter and 15 cm long, was prepared at a porosity of 60% in a constant-head apparatus. The total head was kept constant at 30 cm and the amount of water collected in 5 seconds was 40 cm^3. The test temperature was 20 deg C. Calculate the hydraulic conductivity. Provide a diagram a.5.0 x 10^-2 b.3.47 x 10^-2 c.2.0 x 10^-1 d.6.7 x 10^-1
Refer to the constant-head arrangement shown in Fig 5. For a test, the followingare given:• L =18 in.• A = area of the specimen = 3.5 in.2• Constant-head difference = h = 28 in.• Water collected in 3 min = 21.58 in3Calculate the hydraulic conductivity (in./sec).
For a constant head laboratory permeability test on fine sand, the following values are given: Length of specimen, L = 15inches Diameter of specimen, D = 3inches Head difference, h = 22inches Water collected in 120 seconds = 0.057cu.in Void ratio, e = 0.37 a. Determine the hydraulic conductivity (in/min) of the soil. b. Determine the discharge velocity (in/min) through the soil. c. Determine the seepage velocity (in/min) {νs=νn}. Note: Your answer must contain 5 numbers after the decimal point. (Example: 0.00504, 0.00899, 0.02345, 0.00200) these values must be used to solve succeeding questions. Please answer this asap. For upvote. Thank you very much
For a falling head permeability test, these valueare given: Length of the soil specimen = 200 mm Area of the soil specimen = 1000 mm2 Area of the standpipe = 40 mm2 Head difference at time, t = 0 min is 500 mm Head difference at time, t = 3 min is 300 mm1. Determine the hydraulic conductivity of thesoil in cm/sec.2. What was the head difference at time, t =100 sec?
In a falling head permeameter test the initial head at t = 0 is 40 cm. The head drops by 5 cm in 10 minutes. Determine the time required to run the test for the final head to be at 20 cm. Given: Height of sample = 6 cm; cross sectional areas of sample = 50 cm2 and stand pipe = 0.5 cm2. Determine the hydraulic conductivity in cm/sec.
Solve for the ratio of equivalent hydraulic conductivity with the following given: h1 = 2 m h2 = 2.5 m h3 = 1.8 m h4 = 0.9 m k1 = 1.5E-3 cm/sec k2 = 2.2E-4 cm/sec k3 = 1.6E-4 cm/sec k4 = 4.0E-4 cm/sec What is the ratio of equivalent hydraulic conductivity?
/ 2.8 If the specific weight of a sludge can be expressed as gamma(y) = 10200 + 105h, determine the pressure in N/m^2 at a depth of 4.5 m below the surface. Gamma(y) is in N/m^3 , and h in m below surface
A sample of sand, 5 cm in diameter and 15 cm long, was prepared at a porosity of 60% in a constant-head apparatus. The total head was kept constant at 30 cm and the amount of water collected in 5 seconds was 40 cm^3. The test temperature was 20 deg C. Calculate the hydraulic conductivity. a. 6.7 x 10^-1 b. 3.47 x 10^-2 c. 5.0 x 10^-2 d. 2.0 x 10^-1
Estimate the ratio of equivalent hydraulic conductivity
If the specific weight of a sludge can be expressed as y = 10200 + 105h, determine the pressure in N/m? at a depth of 4.5 m below the surface. y is in N/m?, and h in m below surface