Read the question carefully and give me right solution. Provide detailed solution with clear calculations. The hydraulic conductivity of a soil sample, measured at 25C, was 0.005 cm/s using water as the test fluid (density = 997.2 [kg m–3 ], viscosity = 0.0008872 [kg m–1 s –1 ]. Determine the conductivity for ethanol at 10C, density = 798 [kg m–3 ], viscosity = 0.001394 [kg m– 1 s –1 ]

Read the question carefully and give me right solution. Provide detailed solution with clear calculations. The hydraulic conductivity of a soil sample, measured at 25C, was 0.005 cm/s using water as the test fluid (density = 997.2 [kg m–3 ], viscosity = 0.0008872 [kg m–1 s –1 ]. Determine the conductivity for ethanol at 10C, density = 798 [kg m–3 ], viscosity = 0.001394 [kg m– 1 s –1 ]

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter9: In Situ Stresses

Section: Chapter Questions

Problem 9.11P

See similar textbooks

Similar questions

A constant-head permeability test is performed in a laboratory where the soil sample is 25 cm in length and 6 cm2 in cross section. The height of water is maintained at 2 ft at the inflow end and 6 in. at the outlet end. The quantity of water flowing through the sample is 200 ml in 2 minutes. (a) Make a sketch of the described conditions. (b) What is the coefficient of permeability in millimeters per minute?
The SQUARE base permeameter (seen from above), has three soil layers arranged vertically as shown in the image. L is: 70cm, the difference of head h is: 105 cm. The coefficient of permeability of soil 1 K1 is 0.065 cm/sec, soil 2 K2 is 0.0030 cm/sec and soil 3 K3 is the 0.0095 Calculate the amount of water collected in a time of 10 minutes.
A constant-head permeability test is performed in a laboratory where the soil sample is 25 cm in length and 6 cm2 in cross-section. The height of the water is maintained at 2 ft at the inflow end and 6 in. at the outlet end. The quantity of water flowing through the sample is 200 ml in 2 minutes. (a) Make a sketch of the described conditions. (b) What is the coefficient of permeability? ***Please include all the units and conversions.
A falling head hydraulic conductivity test is performed on a sample of soil. The standpipe. having a diameter 0.35 cm is observed and it takes 80 seconds for the water to drop by 70 cm from an initial hydraulic head of 90 cm. The sample has a length of 22 cm, and a diameter of 5 cm. Compute the rate of flow of water in the soil (in cm³/s). Answer in 3 decimals Pls answer asap
Figure below shows layers of soil in a tube that is 100mm x 100mm incross section. Water is supplied at a constant head difference of 400 mm across thesample. The hydraulic conductivities of the soils in the direction of flow through them areas follows. Soil k (cm/sec) Porosity, n (%) A 1x10-2 25 B 3x10-3 32 C 4.9x10-4 22 a. Calculate the equivalent k in cm/sec.b. Calculate the rate of water supply in cm^3/hrc. Calculate the seepage velocity through soil C in m/sec.
For a constant head laboratory permeability test on fine sand, the following values are given: Length of specimen, L = 15inches Diameter of specimen, D = 3inches Head difference, h = 22inches Water collected in 120 seconds = 0.057cu.in Void ratio, e = 0.37 a. Determine the hydraulic conductivity (in/min) of the soil. b. Determine the discharge velocity (in/min) through the soil. c. Determine the seepage velocity (in/min) {νs=νn}. Note: Your answer must contain 5 numbers after the decimal point. (Example: 0.00504, 0.00899, 0.02345, 0.00200) these values must be used to solve succeeding questions. Please answer this asap. For upvote. Thank you very much
Calculate the coefficient of permeability in mm/s of a soil sample, 6 cm in height and 50 cm2 in cross sectional area, if a quantity of water equal to 430 ml passed down in 10 minutes, under an effective constant head of 40 cm. a.625 X 10^-2 b.5.9 x 10^-2 c.1.6 X 10^-5 d.2.15 x 10^-2
The soil sample presented in Figure below is under constant head permeability test. The soil is consist of a silty sand (SM) with k = 5×10-3cm/s and specific gravity of 2.70. The soil is fully saturated and its moisture content is determined to be 18.5%. Determine the time required for the plug of colored water to pass through the soil (i.e., from when the leading edge first enters the soil to when it begins to exit). Use seepage velocity for your calculation.
For a falling-head permeability test, the following values are given: Length of specimen = 200 mm Area of soil specimen = 1000 mm^2 Area of standpipe = 40 mm^2 Head difference at time t = 0 = 500 mm Head difference at timt t = 3 minutes = 300 mm Determine the hydraulic conductivity of the soil in ×10−4cmsec Please answer this asap. For upvote. Thank you very much
A soil sample whose specifications were in the field, the total volume was 1150 cubic centimeters, the total mass was 2290 grams, and the density of the solid was 2540 kg / cubic meter, it was brought to the laboratory and dried in the oven, its mass became 2035 grams, calculate the real characteristics of the model 1- degree of saturation, 2- vacuum ratio, 3- Moisture content, 4- Porosity
The given values are as follows: The specimen's e=0.46 length of soil specimen=450mm constant head difference=700mm Water collected in 3 minutes =3.54x10-4 m3 Area=2.26x10-3 m2 1) Find the coefficient of permeability (Ans. 2.012 m/hr) 2) Find the discharge velocity (Ans. 0.052 m/min) 3) Find the interstitial velocity (Ans. 0.165 m/min)
Please explain part 1 (ii) of the question given. 1) i) A 6 inch diameter well that fully penetrates a 40ft thick open aquifer is pumped at a rate of 100 gpm. The drawdown in the well is 22ft when a steady water level is established. The drawdown in a well 152ft distant is 12ft. Estimate the coefficient of permeabiliity of the soil deposit. Answer of permeability is K= 9.88 x10-4 ft/sec. ii) Discuss the validity of the answer obtained in 1( i ) and suggest how would you improve the test data obtained to produce a better value of k. Why?