Answered: Probability density function defines a.…

Probability density function defines a. Density of signal b. Amplitudes of random noise c. Probability of error d. All of the mentioned

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

ChapterS: Safety, Basic Electricity And Ohm's Law

Section: Chapter Questions

Problem 8RQ: What is an MSDS?

See similar textbooks

Related questions

Q: 6.1 A1 kHz sine wave is sampled at frequency of 5 kHz. (a) What is the Nyquist frequency of the…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: a. A Gaussian noise voltage with a mean value of 0 V has an RMS noise voltage of 25 mV. For what…

A: I used the concept of Q function and its table to solve this . To obtain percentage , multiply with…

Q: c) Consider a speech signal with spectral components limited to the frequency band 200 to 3500 Hz.…

Q: What is the maximum signal frequency which can be recovered with sampling frequency of 9KHz? If for…

A: Sampling Frequency given by Fs=2× fmax Here fmax we have to find for 1st que and Fs is given as…

Q: Consider a (10,6) single error correcting code for which code polynomial is x8 + x6 + x5 + x³ + x…

A: The polynomial is given as:

Q: A specific waveform of EEG signal comprises a frequency range up to 200 Hz. What is the minimum…

Q: Explain information regarding Discrete Signal

A: A discrete sign or discrete-time signal is a period series comprising of a grouping of amounts.…

Q: Q1/ Consider the analog signal Xa(t) = 3 cos 100n t (a) Determine the minimum sampling rate required…

A: a) sampling rate = 2×fmax Fmax= w/2π w= 100π Fmax = 50Hz Fs= 100Hz

Q: Find the binary transmission rate takdirde if a continuous time signal with a bandwidth of 20 KHz is…

Q: A digital communication link carries binary-coded words representing samples of an input signal…

Q: 1. Find the mean and variance of full amplitude modulated (m-0.75) and double side band suppressed…

A: m=0.75Ac=−0.5 to 0.5fc=100 Hzfm=20 Hzt=100 ms

Q: A base band signal used in European standard voice grade communication is represented by a band…

Q: (b) In a junction of road installed with traffic light, the sensor circuit with capablities to…

A: Given: In a junction of a road installed with a traffic light, the sensor circuit with capabilities…

Q: We use the DFT to compute the amplitude spectrum of a sampled data sequence with a sampling rate fs…

A: The sampling rate is the number of data points acquired per second or the number of samples of audio…

Q: If the analog signal travels over a transmission medium and its input voltage is 5 volts and output…

A: Given : Vin=5 V Vout=2.5V ANEXT=37dB

Q: What are the similarities and differences between Hartley's and Shannon's information measures?

A: The Information measures have the given number of desired properties, the Shannon and Hartley…

Q: An analog signal having a maximum frequency of 10 kHz is sampled using instantaneous sampling…

A: Sampling is the process using which a continuous time signal is converted into a discrete time…

Q: We use the DFT to compute the amplitude spectrum of a sampled data sequence with a sampling rate fs…

A: fs=3kHz (sampling-frequency)∆f=frequency resolution∆f< 0.5Hz

Q: Identify and draw the odd and even parts of the signal given below. ?(?) = ?(? + 2) − 2?(? − 1) +…

A: Identify the given signal draw the odd and even parts of the signal given ?

Q: Problem-1 Consider a low-pass analog signal of 8 kHz. What is minimum bandwidth, assuming 4 bits per…

A: Given:Low- pass analog signal of 8 kHz.To find:Minimum bandwidth for 4 bits per sample.Minimum…

Q: Problem#3: A television signal (video and audio) has a bandwidth of 4.5 MHz. This signal is sampled,…

A: Given that Signal bandwidth=4.5MHz L=1024 level

Q: We use the DFT to compute the amplitude spectrum of a sampled data sequence with a sampling rate fs…

Q: The subject is Communication Systems ( A RANDOM SIGNAL GENERATION AND ANALYSIS ) Please send the…

A: Explain SNR SIGNAL TO NOISE RATIO

Q: Draw the waveform of the transmitted signal in QPSK and OQPSK if the binary data is given as bk =…

A: Given data: A binary signal, bk - "11000111" To find: The question demands the waveform…

Q: How did he get the value inside the circle, can you explain step by step? ratio of SNR value over…

Q: Find the mean and variance of full amplitude modulated and double side band suppressed carrier…

A: m=0.75 Ac=−0.5 to 0.5 fc=100 Hz fm=20 Hz t=100 ms

Q: 1. х(п) 8(п - k) 3 a) x(n) b) x(k) c) x(k) • 8(n – k) d) x(k) + 8(k) 2. What is the condition for a…

Q: Give detailed information about Nyquist–Shannon sampling theorem. Explain what Aliasing is in…

A: The Nyquist–Shannon sampling theorem is a theorem which serves as a fundamental connection between…

Q: Consider the analog signal Description (optional) Image t.. x(t) = 3cos100 zt (a) Find the minimum…

A: We will find out sampling frequency to avoid aliasing . We will also find discrete time domain…

Q: Draw the waveforms for the following data stream corresponding to NRZ-I, RZ, Manchester and…

A: We need to draw the waveforms for the following data stream corresponding NRZ, RZ, Manchester and…

Q: 8 The variance(0) of a random signal represent: a- The total signal power. b- The AC signal power c-…

A: We need to tell about variance .

Q: A Digital camera captures an image and sampled for 4 seconds by a 16-bit ADC at a sampling frequency…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Consider a continous time signal given below. The signal is digitized and carried via the link…

A: "According to the company's policy we will provide solution for the first three parts of the…

Q: Write the mathematical expression of the m (t) signal whose graph is given below.

A: Any time domain signal can be sinusoidal, DC signal or any curve signal. Sinusoidal signals are…

Q: a- When we simulate a continuous system we use an ADC in the output of the analog plant. If the…

Q: (a) ider a quaternary random variable X over signal space {1, 1{. Assume that the probability of X =…

Q: Problem-4 If the Nyquist samples are quantized into L = 16384, levels and then binary coded,…

Q: State Nyquist's sampling theorem

A: Nyquist sampling theorem state that

Q: When should a dense index be preferred over a sparse index? Your response should be explained.

A: Dense index : Index is related to data base system in any data base system if index will be dense…

Q: Suppose that a random signal with mean my =3 and power spectral %3D 1 density S,)= is applied to a…

Q: 7) Suppose we have a message signal that is a sinusoid and we quantize it using a quantizer of L…

A: We need to find out the SNR for given system.

Q: A simple binary communication system model, with additive Gaussian noise, is the following: S is a…

A: Given : S : binary random variable taking the values S € { -1 ,1 } with the equal probability…

Q: A digital communication link carries binary-coded words representing samples of an input signal,…

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you…

Q: Q2] A digitizing system specifies 55 dB of dynamic range. Howmany bit rate required to satisfy the…

A: Here the dynamic range is L L in db 20 log (L) = Dynamic range . First we need to calculate the…

Q: Time 1 signal i 1 signal į 1 signal i 1 signal i 1 signal i 1 signal element element element element…

A: Binary FSK signal

Q: Determine the saving, in signal power, in the case of 50% modulated AM signal, if the carrier is…

A: The solution can be achieved as follows.

Q: number of bits if frequencies of A=0.15 and B=0.23 ?

Question

Q20)

This multiple choice question from DIGITAL COMMUNICATIONS course.
just write for me the final answer.

Probability density function defines

Density of signal

Amplitudes of random noise

Probability of error

All of the mentioned

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Write a VHDL code for 4:1 multiplexer using conditional concurrent signal assignment
Every DT signal can be described by a linear combination of scaled and shifted unit samples. True or false? Explain.
In this signal flow diagram, kindly please show me how to get the given answer by detailed solution. Thank you.
Using Verilog continuous assignment statements or VHDL signal assignment statements, write a description of the circuit shown in
Show that the distance between two signal points of BPSK scheme is 2√??
Write a Verilog code for multiplexer using the following case Using pure behavioral modeling
Explain the difference between Random Error and Systematic Error and give examples
A four bit 1’s complement binary representation of a number is given as 1110. What would be an eight bit representation of this number using the sign and magnitude method?
For question 1, The instructor asked what is an approach to modulate a PWM signal and what is an approach to demodulate a signal. Thank you. Explain one approach for PWM modulation and detection (demodulation). Please draw the required circuits and diagrams.
What is meant as baud rate? I don't understand explain in bit details and what's the difference between baud rate and bit rate?
A PCM system is used to transmit base4 signal of 512 level, the input signal works in the range between (30 to 70) MHz. Find the bit rate and signal to noise ratio in dB? Note that: the step size is considered to be double of system levels? *
Qَ\ discuss a conversion of an analogue signal to digital bits Please I need to resolve the question quickly