Answered: Problem 1: There are 12 vehicles…

Problem 1: There are 12 vehicles observed in a 400 m section of N. Bacalso Avenue. Given that the average time headway is 5 seconds, compute the space mean speed, in kph.

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter8: Intersection Control

Section: Chapter Questions

Problem 23P

See similar textbooks

Related questions

Q: 4.12. Show that the pattern due to a two-dimensional sink at the orig d sources at (0-5, 0) and (2, ...

A: The pattern due to the two dimensional sink at the origin and source are given in the above question...

Q: DETERMINE THE INTERNAL FORCE OF MEMBER DE FROM THE FIGURE BELOW.

A: Consider the figure, Here, T is the tension and C is the compression.

Q: 2. Given the surcharge load shown below, determine (a) magnitude of consolidation settlement, (b) ti...

A: given data Cy=0.131ft2/day also γ=97pcf also time in 60%consolidation also at 30% at finally at time...

Q: Solve the problems neatly and show your complete solution with FBD. Write all numerical answers with...

A: The slab is generally an essential structural particle that is constructed to create flat and useful...

Q: ticity of the Wood if the Clear Span Length is 2300 mm, applied load is 10lbs and the deflection of ...

Q: In a dilatancy test on site water slowly showed up on the surface of the sample, this sample possibl...

A: True

Q: kindly help me with this simple problem hope you could help me thank you! Illustrate label and des...

Q: AT-Shaped beam has a length of L- 35 m is acted upon by the distributed load as shown which has a ma...

Q: permeability

A: The two laboratory methods for determining permeability are constant head permeability method and va...

Q: A cylindrical container whose weight is titet Ibf is inverted and pressed into the water, as shown i...

Q: The feüction Sance ualue is and ualue a coesficient d friction to 0.22. Fid the naemal Sarce 30 N

Q: 2. Refer to the figure. Assume unit weight of concrete to be 23.5 kN/m. Hydrostatic uplift varies fr...

A: As per bartleby guidelines experts are allowed to solve only first three parts. Please post other pa...

Q: Active earth pressure per meter length on the retaining wall with a smooth vertical back as shown in...

Q: find Gs If e =0.75, hc =2.81 m, Z= 3m Where: Z: soil thickness hc: Critical hydraulic gradient e: vo...

Q: After two years of traffic, cores were recovered from the roadway which has severe rutting and bleed...

A: Given, Bulk specific gravity, Gt = 2.561Maximum theoretical specific gravity, Gm = 2.487

Q: What is the slope of EH if distance between them 300m.and R.L of * E=30.09and R.L of H=29.25 _0.0028...

A: Given, Distance between EH =300 mR.L of E=30.09R.L of H= 29.25

Q: When the 150-lb skier is at point A he has a speed of 5 ft/s. When the skier reaches point B on the ...

A: Part A: Determine the skier's speed when he reaches point B on the smooth slope. Part B: Also, what ...

Q: The cost of grading and spreading gravel on a curvy rural road is expected to be $300,000. The road ...

A: B/C Ratio = PW of benefit / (First cost + PW of annual cost) = (900,000 x 150%) / [300,000 + 25,000 ...

Q: 2. Using the conjugate beam method, determine the rotation at A, the rotations(s) at B, and the defl...

A: Conjugate beam method The conjugate-beam method is an engineering technique for determining a beam's...

Q: A pair of overlap aerial photographs was taken with a camera from an altitude of 3000 m above datum ...

Q: Determine the pressure at depth of 12.3 m from top of water level

A: The given question is related with fluid mechanics . In this question we are provided with value of ...

Q: 4 m 1.92 kN B 3 m- -4.5 m

Q: A rectangular scow 30 ft wide, 50 ft long and 12 ft high has a draft in sea water (s = 1.03) of 8 ft...

A: step 1-

Q: is supported by a ball-on-socket jo am. The height of the pole is H = 20 vind force F = 5 kN, what i...

Q: a. A sample of granule formed a height of cone of 7 cm with a diameter of 14.5 cm. Compute for the A...

A: Following are required answer :

Q: A ship has a displacement of 6000 metric tons. An additional body of 30 metric tons mass is moved la...

Q: What is the usefulness of viewports Allows us to see the screen or on paper different views of the s...

A: Ans = A (allows us to see the screen or on paper different views of the same project). Viewports all...

Q: H.W 1 A beam is subjected to equal bending moments of M, = 45 kip- ft, as shown in Figure 1 a. sions...

Q: An aluminum bar of cross-section 450 mm2 is acted upon by the forces as shown in the figure. Determi...

Q: your own words, Explain and Define each terms, Traffic Signals, Roadways and Road safety. Write in

A: Traffic Signals Traffic signals are the indication for the driver, pedestrian, cyclists to follow t...

Q: what lo the cothtal gradient far coarse gnained doil which han voidratio Shecilic rauity 2-67 & o-8 ...

A: The given question is related with geotechnical engineering . In this question we are provide with v...

Q: Baseline 4 Principal T Meridian 1. Given the Baseline and Principal Meridian, Identify Township T3N-...

A: We have to determine baseline and principal Meridian, Identify Township T3N-R2W and the Baseline and...

Q: Answer the following questions: 1. Describe the behavior of RC beams considering shear and torsion....

A: Introduction Reinforced concrete beams are structural elements that designed to carry transverse e...

Q: The rigid pipe is supported by a pin at C and steel guy wire AB 10 mm in diameter E = 200 GPa and v ...

Q: eter of the sample is 6”. a 31.1 MPa b 30.1 MPa

A: Average strengthC=55100+54800+552003=55033.3kgStrength in 'N'=55033.3kg×10=550kNso,

Q: Active earth pressure per meter length on the retaining wall with a smooth vertical back as shown in...

Q: Two aluminum rods AB and BC, hinged to rigid supports are pinned together at B to carry a vertical l...

A: Given data load P = 20 KN Crossection area of rod = 400 mm2 modulus of elasticity E = 70,000 MPa = ...

Q: USE THE METHOD OF VIRTUAL WORKand determine the horizontal deflection at C. EI is constant.There is ...

Q: A pipe 300 m long has a slope of 1 in 100 and tapers from 1.2 m diameter at the high end to 0.6 m di...

A: Given:- The length of the pipe = 300 m The slope of the pipe = 1 in 100 The diameter at the high e...

Q: A rectangular beam has b=300mm and d=540mm. It’s reinforced with tension only with 8-25mmø bars with...

A: step 1-

Q: THIS TOPIC IS RELATED TO GEOTECHNICAL ENGINEERING Reduction in void ratio is a measure of the effect...

A: To prove :- reduction in voide ratio is a measure of effectiveness of compaction.

Q: 10 kN 5 kN 15 kN +++ -1 m - 2 m

Q: A uniform bar is acted upon by different forces as shown. R = 21.75 Ibx 3 ft 1.5 ft 4.5 ft • A • B •...

Q: 2. Given the surcharge load shown below, determine (a) magnitude of consolidation settlement, (b) ti...

A: given data γ= 97 psfcc= 0.28e∘=0.37cv=0.131 ft3/daywe have to calculate time to 30% consolidation

Q: Explain the fundamental canons of ethical relations of an engineer with fellow professional, clients...

A: There are following canons of ethical relation of an engineer with fellow professional , clients and...

Q: If the posson ratio of elastic material is 0.453 the ratio of modulus of rigidity to Young modulus

Q: Polar coordinates are mostly used for drawing O Arc O Ellipse O Angular lines O None of the above

A: step 1-

Q: A retaining wall with a vertical smooth back is 8 m high. It supports a cohesionless soil (y = 19 kN...

Q: IV. Determine the reactions for the continuous beam shown by the three-moment equation. Draw the she...

Q: The frame has dimensions H1 = 4 m , H2 = 3 m , and L1 = 6 m , and supports two lateral loads P1 = 10...

A: Given, Area of AE=40 cm2 Area of BF=80 cm2 H1 = 4 m H2 = 3 m L1 = 6 m The two lateral loads P1 = 10 ...

Question

Problem 1: There are 12 vehicles observed in a 400 m section of N. Bacalso Avenue. Given that
the average time headway is 5 seconds, compute the space mean speed, in kph.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine the approximate center to center spacing of vehicles in a certain lane if the average speed of the cars using that particular lane is 40 kph and the volume of traffic is 800 vph
In a 500 m section of highway, there are 10 vehicles observed. The time headway is 4 sec. Determine the space mean speed of the vehicles in kph.
There are 3 vehicles observed in a 100 m section of McArthur highway. If the average time headway is 4 sec., compute the space mean speed of the vehicles in kph. thank you
During peak hours, 3800 vehicles pass through a certain highway from 9:00 AM to 11:00 AM, withspace mean speed of 20 kph. What is the average space headway per vehicle in meters?
A portion of the extension of SLEX has a free flow speed of 60kph and a capacity of 3600 veh/hr. If in a given hour, 3344 vehicles were countered at a specified point along this highway, determine the traffic density of these 3344 vehicles.
There are 9 vehicles observed in a 300 m section of McArthur highway. If the average time headway is 4 sec., compute the space mean speed of the vehicles in kph.
The rate flow at a point in the highway is 1200 vehicles/hour. Find the space mean speed in mph if the density of traffic is 25 vehicles per mile
Compute the rate of flow in veh/hr if the space mean speed is 35 mph and the density of traffic is 17 veh/km a.959 veh/hr b.956 veh/hr c.957 veh/hr d.958 veh/hr
Observation post reveals that 8 vehicles passed through at intervals of 4.6 s, 6.23 s, 5.9 s, 7.1 s, 4.9 s, 3.8 s, 12.6 s, and 13.0 s, respectively. If the total distance travelled by the vehicles is 200 meters, i. If the density of traffic is 20 vpk, compute the rate of flow of traffic in vph. ii. If the speed limit imposed along the roadway is 100 kph, determine the percentage of speed limit violators.
If the density of traffic in Aurora Blvd. is 25 veh/km and the average headway is 4 sec., compute the space mean speed in kph.
Six vehicles were observed passing a point for every 25 sec. the density of traffic is 30 veh/km. Find the space mean speed.
The traffic intensity of a certain freeway is 0.833. The arrival rate of vehicles at a certain intersection (stop sign) is 200 vehicles per hour. Compute the service rate in vehicles/hr. *