Problem 2: A metal rod 0.4 m long & 0.04 m in diameter has one end at 373 K & another end at 273 K. Calculate the total amount of heat conducted in 1 minute. (Given K = 385 J / m s °C)

Q: s the volumetric flow

A:

Q: The lowest temperature at which auto-ignition of the joil vapor occurs above the heated oil sample…

A: Cloud point is the temperature at which the solution forms an emulsion by liquid-liquid phase…

Q: The time it takes to bake a bread at 120°C is 25 min. The same bread can be baked only in 360 s in…

A:

Q: & O 1,2-Epoxyl-2-methylpropane or 1,1-Dimethyloxirane O 2-Methyl-1,2-epoxypropane or…

A:

Q: 6. An ideal gas initially at 600 K and 10 bar undergoes a four-step mechanically reversible cycle in…

A:

Q: Peng/Robinson equation of state

A:

Q: 2) For the reactions A B, and 3A +2B C +5D → a) Write the rate of the reaction (-rA). What…

A:

Q: The percentage of MnO₂ in a 500 mg sample which after the addition of 80.00 mL of 0.1056 M FeSO4…

A: The given sample contains impurities and MnO2. A FeSO4 solution is therefore used to titrate the…

Q: How much finished paint (in kg/d) can the plant produce

A:

Q: In the photosynthesis assuming an elementary reaction: a. Give the rate equation for the depletion…

A: The photosynthesis reaction assuming it is an elementary reaction is as follows: 6CO2 + 6H2O + light…

Q: Explain what are the application of diffusion with each the following: Food Industry Food…

A: The process of diffusion in mass transfer refers to the movement of solute molecules in a solvent…

Q: Derive the Kremser equation for a stripper with three equilibrium stages

A: Kremser equation for stripping section is to be derived.

Q: and CH

A: please find answer attached below

Q: Water contained in a piston-cylinder assembly, initially at 300°F, a quality of 70%, and a volume of…

A: The internal energy is calculated at each state. The amount of mass is obtained from volume and…

Q: FR&B 3.49. The great Boston molasses flood occurred on January 15, 1919. In it, 2.3 million gallons…

A:

Q: Jatropa oll, are obtained in the conversion of triglyceride to diglyceride: T, °C 35 65 k, L/mol-min…

A: Given that:-T1 =35 C =308.15 K T2 =65 C = 338.15 K k1 =0.057 l mol mink2 =0.382 l mol min

Q: Given the figure below, If the barometric pressure is 1.07 bar and the gauge pressure at the bottom…

A: Given data: Barometric pressure = 1.07 bar Gauge pressure at the bottom of tank = 138.52 kPa…

Q: One mole of gas in a closed system undergoes a four-step thermodynamic cycle. Use the data given in…

A:

Q: W The wall of a spherical steel tank k, = 17. m. K thick contains hot oil at 100°C. On the outside…

A:

Q: A gas mixture containing 3.0 mol H2, 4.0 mol N₂ and 2.0 mol He at 273.15K has a total pressrue of…

A: mole fraction of nitrogen = moles of nitrogen / total moles mole fraction of nitrogen =  (4 mol N2)…

Q: Determine at what time the tank starts to overflow and the acid concentration in the tank

A:

Q: Take the wholesale price of refined sugar (containing 0.1% water) to be 42 cents/lbm. Assume that…

A: For a detailed solution, please see the attached files.

Q: As shown in the figure, an exterior wall of a building has an average thermal conductivity of 0.32…

A:

Q: What are the independent equations used and the volume of the second

A:

Q: The heat capacity of sulfur is Cp= 15.2 + 2.68T where Cp is in J/(g- mol K and T is in K, Convert so…

A:

Q: When estimating the specific entropy of compressed water at a given pressure and temperature, it is…

A: Solution:- False We know that entropy =  ∆Q/T Here T is different for compressed liquid and…

Q: What are the 5 independent euquations I need? You didn't answer the question

A: 5 independent equations need - To solve the volume of second feed solution

Q: Solid calcium fluoride (CaF2) reacts with sulfuric acid (H2SO4) to form solid calcium sulfate…

A: It is given that calcium fluoride (CaF2) reacts with sulfuric acid (H2SO4) to form solid calcium…

Q: A central power plant, rated at 800 000 kW, generates steam at 585 K and discards heat to a river at…

A: The maximum possible efficiency is given by Carnot's equation as follows: ηmax = 1 - TCTH TC = 295 K…

Q: Normal human plasma contains cations in the following concentrations: Na", 143 mmol/L; Ca2+, 2.38…

A: To find The total mass of chloride salts of the given four cations in 10 mL of human plasma

Q: Air entering the duct at td-20 c, Q-39% for heating by heater to td-24c.. you know the flow rat of…

A: Specific humidity and enthalpy values are estimated from the psychometric chart. Latent heat load is…

Q: 1.6 1.2 + 0.8 0.4+ O -0.4 -0.8 -1.2 - -2 Fe3+ 2 1 4 Fe²+ 0 3 Fe(s) 4 Fe₂O3(s) 5 FeOH+ Fe3O4(s)…

A:

Q: -3 The purchased and installation costs of some pieces of equipment are given as a function of…

A: Given that the cost of the equipment is a function of weight rather than capacity.  The cost of the…

Q: The heart is effectively made up of two pumps that create flow through the human circulatory system…

A: Introduction  A pump is a tool that moves fluids (drinks or gases), or occasionally slurries, via…

Q: In an herbal medicine manufacturing line, technicians are tasked to produce Moringa (malunggay)…

A: Given: The moisture content of fresh moringa is xfW = 0.81 and the rest, xfm = 0.19 is the medicinal…

Q: Choose a pair of state functions below: O q and U O w and H O q and w OU and H

A: A state function is a property that describes a particular state, without depending on the path…

Q: 3. The volume of a certain liquid varies with temperature as V = V(0.75 +3.9 × 10−4T + 1.48 ×…

A:

Q: 3. The heat capacity of sulfur is Cp= 15.2 +2.68T where Cp is in J/(g- mol K and T is in K, Convert…

A: Given that Cp=15.2+2.68T here Cp is in J/(g-mol K) then Cp can be written as  Cp=15.2Jg-mol…

Q: You have three CSTRS you can place in series to carry out a liquid phase reaction at constant…

A:

Q: percent oil lost in the process.

A:

Q: What is the pH of the solution if 100.0 ml of 0.100 M HCl is titrated with 99.9 ml of 0.100 M KOH?

A: Given that- Volume of HCl (strong acid)=100 mL= 0.1 L Concentration of HCl= 0.100 M Volume of KOH…

Q: For ammonia at 310 K, estimate the density of the saturated liquid using the Rackett method

A: Given that- For saturated liquid ammonia, Temperature, T=310 K Molecular weight of ammonia= 17 g/mol…

Q: For n-heptane calculate: (1) The vapour pressure of n-heptane at 325 K (2) The normal boiling point…

A:

Q: Air, initially at 389 K and 8 bar is expanded reversibly and isothermally to such a pressure that…

A: The heat capacity at constant volume is obtained from the heat capacities ratio for ideal gas. The…

Q: 6. The following information was obtained on another substance a. Triple point: 60°, 10 atm b.…

A: A phase diagram consists of three phases. They are solid, liquid and vapor phases under different…

Q: A saturated solution containing 1000 kg of potassium chloride at 360 K is cooled in an open tank to…

A: Given: At T = 360 K, a saturated solution containing 1000 kg of potassium chloride is cooled in a…

Q: Which reagents will achieve the following transformation? OH O 0 conc. H₂SO4 heat PCC conc. H₂SO4…

A:

Q: 9 What is the composition for the point labelled e? (2 Points) 1 0.8 xc 0.6 0.24 0.44 0.2 A (b) 0.8…

A: In the given image, the maroon line is the line consisting of A and B, the turquoise line is…

Q: Production target : 60 wt% nitric acid at 280 ton/day Raw material : Ammonia, Water, Oxygen from…

A: Given, The mass of air is 36000 kg. The mole% of air is 78% N2, 21% O2 and 1%Ar. Here Ar acts as…

Q: Determine the value of Kc in Figure Q2(b) for a regulator case in which the closed-loop response has…

A: