6. The following information was obtained on another substance a. Triple point: 60°, 10 atm b. Critical point: 180°C, 16atm c. melting point at 18atm is 10°C Sublimation point at 1atm is 20°C Boiling point at 15 atm d. e. is 160°C On the graph to the right sketch a phase diagram

Q: Consider 2 kg of air has a decrease of internal energy of 25 kJ during a reversible non flow…

A: Write the expression for internal energy change for reversible isobaric process as follows: ∆U =…

Q: A furnace burns 10 kg/s of fuel oil (C = 86%, H = 10%, S = 4%). Measurements carried out at the base…

A: Given, The mass flow of fuel oil is 10 kg/s. The mass% of C, H and S are 86%, 10% and 4%…

Q: Applied load on the steel ball: Diameter of the steel ball: Pb (gram) 10 1 9.8 9.6 Hardness (BHN)…

A:

Q: 10 moles of an ideal gas at 37°C are allowed to expand isothermally from an initial pressure of 15…

A:

Q: An industry wants to reduce the concentration of contaminant X in their waste stream. They have…

A: Given, The permit level of discharge is, Cmax = 1.0 μgL = 0.001 mgL The initial concentration of X,…

Q: Q3: Answer only one of the following: A- The heat capacity of carbon monoxide is given by the…

A: For a detailed solution, please see the attached files.

Q: Can you please show the complete solution for these

A: The atmospheric pressure is considered to be entering from the right side pipe. The pressure can be…

Q: Note that if the % carbon and net hydrogen lost in the refuse is around 7%, a. Determine the orsat…

A: The moles of components are calculated by assuming a basis. The loss percent is considered and the…

Q: Example (2): - Nicotine (C) in a water (A) solution 1% is to be extracted with kerosene B at 20°C,…

A:

Q: Sphere Size Small Medium Large Mass Present in Mixture (g) 177.92 186.49 266.84 Price ($/g) 3.19 see…

A:

Q: There is a laminar flow of petroleum with Reynolds number equal to 1900 (s = 0.895; μ = 8.3x10-4…

A:

Q: Assuming the validity of Raoult's law, do the calculations for the acetic acid(1)/2-propanol(2)…

A:

Q: 4. The turbines in a hydroelectric plant are fed by water falling from a 150 ft height. Assuming 15%…

A: For a detailed solution, please see the attached files.

Q: A large spherical storage tank, 2 m in diameter, is buried in the earth at a location where the…

A:

Q: 1) CI and Kw are among the most important classifications adopted in the classification of crude oil…

A: Part 1: CI of the crude oil is the correlation Index for the crude oil. This index tells about the…

Q: ENGCB323-22A: Assignment 4 Binary Distillation Due date: 5pm Friday 20st May 2022 A distillation…

A: Given data are as follows: F=10kmol/s, Beneze and o-xylene are in the molar ratio of 60:40, So…

Q: Acidic gases, such as CO₂ and H₂S, must be removed from natural gas prior to use. You want to remove…

A:

Q: A certain fluid at 10 bar is contained in a cylinder behind a piston, the initial volume being 0.05…

A:

Q: a. 1. For the reaction: C(s) + CO2(g) →2CO(g) .Drive the relationship between Kp and Kc. b.…

A: Since we only answer up to 3 sub-parts, we'll answer the first 3. Please resubmit the question and…

Q: A 40-foot "fiberglass" boat hull weighs 2000 kg. 45% percent of that mass is a fully cured…

A:

Q: Problem 1: In thermodynamics, any region that occupies a volume and has a boundary is called a…

A:

Q: Right now, Malampaya is the only sizeable source of natural gas in the Philippines. A certain sample…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Give the major product(s) of the following reactio NaCN ㅁ H CN OH Br OH OH Br OH CN

A:

Q: B:- Determine the M,, and Mw for each concentration of polystyrene sample, which has an a value of…

A: The time by time of descent ratio is obtained. The values of this ratio are subtracted from the…

Q: you do it in another way especially the F and K part

A: The unit conversion is changing one set of units to an equivalent set of units. Both sets of units…

Q: Kerosene is pumped into a tank at rate between 0 and 1000 Litres per minute. The inlet temperature…

A: Given that- Kerosene is pumped into tank at rate between 0 to 1000 L. Hence, inlet flow rate= Fi…

Q: T (°C) 80 75 70 65 60 55 0.0 0.1 0.2 Txy Plot for Acetone/Ethanol 0.3 0.4 0.5 x, y (Acetone),…

A: Given  Total mole = 50  Composition of acetone at feed = 40%            Mole fraction of acetone…

Q: Three perfect gases, all at a temperature of 25°C, are placed into a box with sides of length 1m,…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: Give an insight and reflection about "The Legend behind Dado Banatao" it is about the life story of…

A: Dado Banatao was regarded as the Bill Gates of the Philippines since both came from technical…

Q: A ball with diameter D = 5 cm and with initial temperature 0 °C is to be exposed to air at 33°C, h =…

A: Given that, Diameter of the ball D = 5 cm = 0.05 m Initial temperature of ball To = 0oC  Temperature…

Q: 1. A 300 mole mixture that is 30.0 mol% acetic acid at 0.4 bar is compressed isothermally. At what…

A: Given  Total mole = 300  Composition of acetic acid in feed = 30%  Composition of chloroform in feed…

Q: Question: C) The Antoine Constant For N-Heptane Are A = 13.8587, B = 2911.32 And C = 56.56.…

A: Given details: for n-heptane Antoine constants, A=13.8587 B=2911.32 C=56.56 we have to determine,…

Q: 2. At 80°F, we mix 10 lb of sulfuric acid with 20 lb of water. What is the resulting heat of mixing…

A:

Q: here. The fraction recrystallized-time data for the recrystallization at 350°C of a previously…

A: The solid's transformation from one phase to another phase is described by the Avrami equation. This…

Q: saturated steam is needed in kg per min to heat up

A:

Q: oblem: A furnace wall is constructed of fire brick, insulating brick and common brick, h of 10 cm…

A: Given, The area of the wall, A = 50 m2 The thermal conductivity of the fire brick, k1 = 1…

Q: A brine solution containing 23.67% NaCl by mass is mixed with a weaker solution containing 2.81%…

A: Given  Mass flow rate of 23.67% solution (A) = 20.2 kg/h Weight fraction of 23.67 solution = 0.2367…

Q: Two isomeric forms of a saturated hydrocarbon Have a different content of the isotopes of hydrogen.…

A: Given that there is two isomeric forms of a saturated hydrocarbon then we have to identify which…

Q: Can you show that, for the Dieterici equation of state: P = [RT ∙ e^ (−a / RTVm)] ⁄ (Vm − b) where…

A:

Q: Calculate the amount of crystal E coming out as product from the precipitator in kg/min

A: The overall mass balance is considered at junctions one and two. Component balance of E at junction…

Q: A plate column is used to absorb SO2 from a gas stream with air, using pure water at 20 o C. 6.48…

A: As per the given  data, the flow diagram of the scrubber is given as : To Find

Q: The rate at which a substance passes through a semipermeable membrane is determined by the…

A:

Q: A nitrogen gas has a molar volume 0.8L at 281K and 30atm. What is the z factor? Please write your…

A: Z factor is defined as the ratio of molar volume of a gas to the molar volume of an ideal gas. The…

Q: A hydrocarbon system is flashed in a drum at 325 psig and 300 K. Assume that the system obeys…

A: First, calculate the vapor pressure of each of the components using the Antoine equation given, For…

Q: At 86 F and a total pressure of 730 mm Hg, the absolute humidity percent of air is 30%. Calculate…

A: Given Data  The temperature  of air (T) = 860FThe total pressure (PT) = 730 mm Hg The absolute…

Q: Determine how the chemical potential of each gas changes due to the reduction in pressure.

A: Given that- Pressure of each component is reduced to 4 times than the original pressure so as-…

Q: Consider a 1000 mL chemostat (continuous reactor) operating with cellular recycling. The bioreactor…

A: Volume of chemostat = 1000 mL Volumetric flow rate = 100 mL/h µmax = 0.2 h-1 kS = 1 g/L…

Q: 3

A: Given data are as follows: Diameter of steam carrying pipe = 10cm=0.1m Length of pipe = 50m Mass…

Q: A. Using the Van der Waals parameters for chlorine gas, calcu values of the (1) Boyle temperature…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: B:- Calculate Dp, Mw, My, for polystyrene, if a-1, Then Show practical method to determine molecular…

A: