PROBLEM 2: An electric circuit has a battery with an EMF of 1.50 V. Its positive terminal is connected to its negative terminal by a copper wire in a circular loop having a radius of 0.500 m. Solve for the drift velocity in the wire if there is one free electron per copper atom. Detailed assumptions: - The size of the cell is negligible compared to the length of the circuit. - Copper resistivity: p = 1.80x10-8n-m - Copper density: D = 8.96x 10° kg-m-3 - Copper relative atomic mass: m, = 63.5 g/mol

PROBLEM 2: An electric circuit has a battery with an EMF of 1.50 V. Its positive terminal is connected to its negative terminal by a copper wire in a circular loop having a radius of 0.500 m. Solve for the drift velocity in the wire if there is one free electron per copper atom. Detailed assumptions: - The size of the cell is negligible compared to the length of the circuit. - Copper resistivity: p = 1.80x10-8n-m - Copper density: D = 8.96x 10° kg-m-3 - Copper relative atomic mass: m, = 63.5 g/mol

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter27: Current And Resistance

Section: Chapter Questions

Problem 27.11OQ: Two conducting wires A and B of the same length and radius are connected across the same potential...

See similar textbooks

Similar questions

Explain why R=R0(1 + a?T) for the temperature variation of the resistance R of an object is not as accurate as P=P0(1 + a?T) which gives the temperature variation of resistivity P.
Two conducting wires A and B of the same length and radius are connected across the same potential difference. Conductor A has twice the resistivity of conductor B. What is the ratio of the power delivered to A to the power delivered to B? (a) 2 (b) 2 (c) 1 (d) 12 (e)12
Review. When a straight wire is warmed, its resistance is given by R = R0,[1 + a(T T0)] according to Equation 27.20, where a is the temperature coefficient of resistivity. This expression needs to be modified if we include the change in dimensions of the wire due to thermal expansion. For a copper wire of radius 0.100 0 mm and length 2.000 m, find its resistance at 100.0C, including the effects of both thermal expansion and temperature variation of resistivity. Assume the coefficients are known to four significant figures.
Show that the power dissipated by the load resistor is maximum when the resistance of the load resistor is equal to the internal resistance of the battery.
The potential difference across the filament of a light-bulb is maintained at a constant value while equilibrium temperature is being reached. The steady-state current in the bulb is only one-tenth of the current drawn by the bulb when it is first turned on. If the temperature coefficient of resistivity for the bulb at 20.0C is 0.004 50 (C)-1 and the resistance increases linearly with increasing temperature, what is the final operating temperature of the filament?
The student engineer of a campus radio station wishes to verify the effectiveness of the lightning rod on the antenna mast (Fig. P21.71). The unknown resistance Rx is between points C and E. Point E is a true ground, but it is inaccessible for direct measurement because this stratum is several meters below the Earths surface. Two identical rods are driven into the ground at A and B, introducing an unknown resistance Ry. The procedure is as follows. Measure resistance R1 between points A and B, then connect A and B with a heavy conducting wire and measure resistance R2 between points A and C. (a) Derive an equation for Rx in terms of the observable resistances, R1 and R2. (b) A satisfactory ground resistance would be Rx 2.00 . Is the grounding of the station adequate if measurements give R1 = 13.0 and R2 = 6.00 ? Explain. Figure P21.71
2 . An electric circuit has a battery with an EMF of 1.50 V. Its positive terminal is connected to its negativeterminal by a copper wire in a circular loop having a radius of 0.500 m. Solve for the drift velocity in the wireif there is one free electron per copper atom.Detailed assumptions:- The size of the cell is negligible compared to the length of the circuit.- Copper resistivity: ρ = 1.80x10!"Ω − m- Copper density: D = 8.96x10# kg − m!#- Copper relative atomic mass: ma = 63.5 g/mol
An electric circuit has a battery with an EMF of 1.50 V. Its positive terminal is connected to itsnegative terminal by a copper wire in a circular loop having a radius of 0.500 m. Solve for thedrift velocity in the wire if there is one free electron per copper atom. Detailed assumptions:- The size of the cell is negligible compared to the length of the circuit.- Copper resisitivity: { = 1.80×10−8 Ω-m- Copper density: D = 8.96×103 kg-m−3- Copper relative atomic mass: ma = 63.5 g/mol
A 60 W fluorescent bulb has resistance of about 12 Ω when cold (30˚C) and 120 Ω when on (hot). Estimate the temperature of the filament when hot assuming an average temperature coefficient of resistivity α = 0.0080(C˚)-1.
What resistance, R, should be placed in series with the galvanometer, G, if it is to show a full deflection when the potential across the resistor is 6 V. The maximum current through the galvanometer is 250 mA and its internal resistance is 3 Ω. (a) 24 Ω (b) 23 Ω (c) 3 Ω (d) 5.25 Ω (e) 21
A capacitor charging circuit consists of a battery, an uncharged 20 μF capacitor, and a 5.6 kΩkΩ resistor. At t = 0 ss the switch is closed; 0.15 s later, the current is 0.46 mA . What is the battery's emf?
An initially uncharged 4.39 μF4.39 μF capacitor and a 7.65 kΩ7.65 kΩ resistor are connected in series to a 1.50 V1.50 V battery that has negligible internal resistance. What is the initial current in the circuit, expressed in milliamperes? Calculate the circuit's time constant in milliseconds. How much time, in milliseconds, must elapse from the closing of the circuit for the current to decrease to 2.77%2.77% of its initial value?