Problem 2 Consider a poly interconnect that is connected to the CMOS inverter as shown in Figure below. The length of the Poly interconnect is 400 micrometers and the width is 15 micrometers. The insulator capacitance of the NMOS and PMOS are Cox=5fF/um². Vin 15um 400um Poly Interconnect Cin CGn Vdd Mp, W/L=44nm/22nm F Mn, W/L= 22nm/22nm (A) If the sheet resistance of Poly is 400/□, calculate the resistance of the Poly interconnect. (B) Given two gate capacitances with values of CGn=80fF and Cop=120fF for NMOS and PMOS transistors, respectively, calculate the total input capacitance (Cin) of the inverter. (C) Calculate the time constant (t=RC) at the output of the inverter with Rpoly computed from part (A) and assuming Cin=15pF.

Problem 2 Consider a poly interconnect that is connected to the CMOS inverter as shown in Figure below. The length of the Poly interconnect is 400 micrometers and the width is 15 micrometers. The insulator capacitance of the NMOS and PMOS are Cox=5fF/um². Vin 15um 400um Poly Interconnect Cin CGn Vdd Mp, W/L=44nm/22nm F Mn, W/L= 22nm/22nm (A) If the sheet resistance of Poly is 400/□, calculate the resistance of the Poly interconnect. (B) Given two gate capacitances with values of CGn=80fF and Cop=120fF for NMOS and PMOS transistors, respectively, calculate the total input capacitance (Cin) of the inverter. (C) Calculate the time constant (t=RC) at the output of the inverter with Rpoly computed from part (A) and assuming Cin=15pF.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Design an asymmetrical inverter to meet the delay of 250 ps for a load capacitance of 120 fF. Use VDD =1.5V, VTN =0.50 V, and VTP =−0.50 V. with (W/L)P = (W/L)N .
Given Vdd=3.3V, Kn=100uA/V2 , Kp=20uA/V2,Vtn = 0.6V, and Vtp = -0.6V. Determine the Voltage Transfer Characteristics points indicated by the pseudo-NMOS inverter circuit.
(a) What is the power-delay product for a symmetrical CMOS inverterwith (W/L)N =2/1, (W/L)P =5/1, C =0.25 pF,VDD =3.3 V, VTN =0.75 V, and VTP =−0.75 V? (b) Estimate the maximum switchingfrequency for this inverter. (c) Howmuch powerdoes the inverter dissipate if it is switching at thefrequency found in (b)?
What is the power-delay product for a symmetrical CMOSinverter with (W/L)N = 2/1, (W/L)P = 5/1,VDD = 2.5 V, and C = 0.3 pF? (b) Repeat forVDD = 2.0 V. (c) Repeat for VDD = 1.8 V.? How much power does the inverter dissipate if it is switching at a frequency of 100 MHz?
Suppose the ECL inverter as shownmust operate at a power of 20 W. If the currentsources are scaled by the same factor, and the capacitancesand voltage levels remain the same, whatis the new propagation delay of the inverter?
Find the ratio of hole mobility to electron mobility of a CMOS inverter given that the beta ratio of pull-up network to pulldown network is 1.5 (Assume that W/L ratio of pMOS is 3 times greater than that of nMOS and all other parameters are same for both) Assuming the supply voltage to be 3V draw a suitable DC transfer characteristic curve of the CMOS inverter.
1. An NMOS inverter must drive a load capacitance of 100 fF while drawing a supply current of less than 1 mA when the output is low. What is the fastest risetime that the circuit can achieve? Assume the output low level is nearly zero. 2. In a CMOS inverter, (W/L)1 = 2/0.18 and (W/L)2 = 3/0.18. Determine the trip point of the circuit and the supply current drawn at this point.
Design an NMOS depletion load inverter (VDD =3.3 V, VL = 0.20 V, VTNS = 0.75 V, VTNL = −2 V,γ = 0) to have an average propagation delay of 1 nswith a capacitive load of 0.2 pF. What is the averagestatic power dissipation of this gate?
The graph gives the results of aSPICE simulation of an inverter. (a) What are therise and fall times for vI and vO ? (b) What are thevalues of τPHL and τPLH ? (c) What is the averagepropagation delay for this gate? (d) What will be theaverage propagation delay if the load capacitanceis doubled?
What are the rise time, fall time, and average propagation delay for a symmetrical CMOS inverter with (W/L)N =2/1, (W/L)P =5/1, C =0.25 pF, VDD =3.3 V, VTN =0.75 V, and VTP =−0.75 V?
'Home work (4) If the bridge inverter is loaded by an R-L laod with R=20 ©, L=30 mH. The inverter frequency, f,=50 Hz and the de input voltage, Vs=200 V. (@) Express the instantaneous load current in fourrier series. (b) Caleulate : i The rms load current at the fundamental frequency fi il The THD of the load current. iii. The power obserbed by the load (Po) and the fundamental power (Pol). Draw the waveform of the fundamental load current and show the intervals of transistors and diodes conduction.
For an inverter circuit where the load is RL circuit, the value of Zn, and In increase as n increase. True or False ?