Problem 2: Determine the NPSH available when a pump draws gasoline at 110°F (sg = 0.65) from an outside storage tank whose level is 4.8 ft above the pump inlet. The energy losses in the suction line total 0.87 ft and the atmospheric pressure is 14.28 psia.

Problem 2: Determine the NPSH available when a pump draws gasoline at 110°F (sg = 0.65) from an outside storage tank whose level is 4.8 ft above the pump inlet. The energy losses in the suction line total 0.87 ft and the atmospheric pressure is 14.28 psia.

Name: Problem 2: Determine the NPSH available when a pump draws gasoline at
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Problem 2: Determine the NPSH available when a pump draws gasoline at 110°F (sg = 0.65) from an%3Doutside storage tank whose level is 4.8 ft above the pump inlet. The energy losses in the suction linetotal 0.87 ft and the atmospheric pressure is 14.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter45: Domestic Refrigerators And Freezers

Section: Chapter Questions

Problem 25RQ

See similar textbooks

Similar questions

The seasonal energy efficiency ratio (SEER) includes the energy used in the _____and _____cycles.
Three disadvantages of parallel compressor systems are _____, _____, and ____.
Task (4) Critically compare how the changes of the heat transfer efficiency will affect the lifetime of the turbine.
A centrifugal pump has NPSH required of 21 ft. The water temperature is 90oF and the friction loss at suction is 1.2 ft. The pump takes water from an open tank below the pump centerline. Determine the maximum static elevation at suction. (Note: @90oF: Psat = 0.69 psia and  = 0.01608 ft3/lb).
What work must be done by a pump that is 60 percent eficient?
Find the available NPSH when a pump draws water at 140°F from a tank whose level is 4.8 ft below the pump inlet. The line losses are 2.2 lb-ft/lb and the atmo- spheric pressure is 14.7 psia.
Figure shows two possible locations for a water pump in a piping system that pumps water from the lower tank to the upper tank. Which location is better? Why?
A centrifugal pump driven by a 160-hp motor rotating at 2400 rpm is used to pump 70°F water in a manufacturing plant. The pump operates against a head of 100 ft and has an efficiency of 70%. If this pump is used against a head of 196 ft, how much water (in cfs) can the pump circulate?
A centrifugal pump has NPSH required of 25 ft. The water temperature is 90 deg. Fahrenheit and the friction loss at suction is 1.4 ft. The pump takes water from an open tank below the pump centerline. (Note: @90 deg. Fahrenheit: Psat = 0.69 psia and specific volume = 0.01608 ft3/lb). Determine the maximum static elevation in feet at the suction
1. A centrifugal pump delivers 900 ?3/ℎ? of sea water (sp.gr.= 1.03) from a source wherethe water level varies 2 m from high to low tide level. The pump centerline is located2.6 m above the surface of the water at high tide. The pump discharges into theatmospheric surface condenser, 3 m above the pump centerline. Loss of head due tofriction in the suction pipe is 0.8 m and that in the discharge side is 3 m. Pump is directlycoupled to a 1750 rpm, 460 volts, 3 phase, 60 Hz. Calculate: a) total dynamic headb) pump theoretical powerc) power to drive the pump if pump efficiency is 82%
Explain two types of turbine which depend on the action of water on the moving blades.
Describe the ideal process for an adiabatic turbine.