Problem 21.19 The magnetic field perpendicular to a single 16.2-cm-diameter circular loop of copper wire decreases uniformly from 0.670 Tto zero. Part A If the wire is 2.25 mm in diameter, how much charge moves past a point in the coil during this operation? The resistivity of copper is 1.68 x10-8 Express your answer to three significant figures and include the appropriate units. ? |AQ| = Value Units Submit Request Answer

Problem 21.19 The magnetic field perpendicular to a single 16.2-cm-diameter circular loop of copper wire decreases uniformly from 0.670 Tto zero. Part A If the wire is 2.25 mm in diameter, how much charge moves past a point in the coil during this operation? The resistivity of copper is 1.68 x10-8 Express your answer to three significant figures and include the appropriate units. ? |AQ| = Value Units Submit Request Answer

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter22: Magnetism

Section: Chapter Questions

Problem 24PE: (a) What is the speed of a supersonic aircraft with a 17.0-m wingspan, if it experiences a 1.60V...

See similar textbooks

Similar questions

Verify than the direction of the line force in an MHD drive, such as that in Figure 22.32, does not depend on the sign of the charges carrying the current across the fluid.
(a) What is the maximum torque on a 150-tum square loop of wire 13.0 cm oil a side that carries a 50.0-A current in a 1.60-T field? (b) Wliat is the torque when d is 10.9s?
Unreasonable results Frustrated by the small Hall voltage obtained in blood flow measurements, a medical physicist decides to increase the applied magnetic field strength to get a 0.500-V output for blood moving at 30.0 cm/s in a 1.50-cm-diameter vessel. (a) What magnetic field strength is needed? (b) What is unreasonable about this result? (C) Which premise is responsible?
(a) What is the speed of a supersonic aircraft with a 17.0-m wingspan, if it experiences a 1.60V Hall voltage between its wing lips when in level flight over the north magnetic pole, where the Earth's field strength is 8.00105T ? (b) Explain why very little current flows as a result of this Hall voltage.
Draw a sketch of the situation in Figure 22.30 showing the direction of electrons carrying the current, and use RHR-l to verify the direction of the force on the wire.
Question #1) A wire of circular cross-section carries current density that is not uniform but varies with distance from the center as j(r)= j0(1-(r/R)^2), for radius r in the range 0 < r <R. Here, j0 is a constant with units amperes per square meter, and the radius of the wire is R = 0.21 mm. A)) Find an expression for the magnetic field inside the wire, r < R, in terms of the current I. B)) What is the maximum, numerical value of the enclosed current, in amperes? C) For what r, in meters, is the magnetic field maximized? r0,B = D). What is the maximum value of the magnetic field in Tesla?
The small currents in axons corresponding to nerve impulses produce measurable magneticfields. A typical axion carries a peak current of 0. 040 μA. What is the strength of the field at a distanceof 0.9 mm?
Suppose you wish to measure the current in a wire. You have a device that can measure the strength of the magnetic field produced by the wire, but the device does not directly measure the current. If the device is place 0.98m away from the wire, and the magnetic field strength is 1.72μ T, what is the current running through the wire in Amps? Note: It is understood that the unit of your answer is in A, however do not explicitly include units in your answer.
Two wires are parallel, with one directly above the other, 9 cm apart. Each wire has aweight per unit length of 1.00 x 10-4 N/m. Assume the wires carry currents that are equalin magnitude. a. Find the current in the wires if the upper wire is floating (balanced) above the lowerwire b.What can you tell about the directions of the current in the two wires?
A current i=−40mA is flowing through the two infinitely long straight wire segments connected by a semi-circular arc, as depicted in the figure. The semi-circular arc has a radius R=18mm . Point A is equidistant from both the infinitely long straight wire segments and also very far away from the semi-circular arc. The coordinate directions are shown in the figure. Note: If the value of current given in the question is positive, then direction of current flow will be the same as depicted in the figure. For the negative value of current, the direction of current flow will be opposite to the direction shown in the figure. a) Find the magnetic field in unit vector notation at point A. (x,yx,z component) Use fig-2 image for answering b) b) Find the magnitude of magnetic field at point B. c) From Fig.2, find the magnitude of magnetic field at point C, which is very far away from point B .
A velocity selector in a mass spectrometer, like the one shown below, uses a 0.133 T magnetic field.a. What electric field strength is needed to select a speed of 4.93*10^6 m/s?b. What is the voltage between the plates if they are separated by 1.00 cm?
The resistance of the loop in (Figure 1) is 0.16 Ω. Is the magnetic field strength increasing or decreasing? At what rate (T/s)?