Problem 3 - 106 ! Compute the hydrostatic force and its location on semi-cylindrical indentation BCD shown. Consider only 1 meter length of cylinder perpendicular to the figure below. Ans: FH 109.5 kN @ 1.349 m below D Fy 20.5 kN @0.531 m to the left of B

Problem 3 - 106 ! Compute the hydrostatic force and its location on semi-cylindrical indentation BCD shown. Consider only 1 meter length of cylinder perpendicular to the figure below. Ans: FH 109.5 kN @ 1.349 m below D Fy 20.5 kN @0.531 m to the left of B

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A trapezoidal canal with sides slope 1H:2V discharges 20 m/s. The velocity of flow is 2 m/s.…

Q: 3. Which hydraulic jump is used in abysmal fan formation? a) Shallow fluid b) Internal wave c)…

Q: Q1: Consider the gravimetric concrete dam shown in Fig. 1. (a) Draw the flow net for the case shown…

A: Gravimetric concrete dam A gravity dam is a structure composed of concrete or stone masonry that is…

Q: e= 20° - 4 m- Stream Rock outcrop Canal FIGURE P6.12 6.12 An excavation is made for a canal that is…

A: The discharge into canal, Q = 0.25*10-4 m3 /sec per unit areaThe pressure at point A, PA = 3KPa.The…

Q: Compute the hydrostatic force and its location on semi-cylindrical indentation BCD shown. Consider…

A: Given data : circle diameter = 2.5 m oil specific gravity= 0.85 length of cylinder = 1 meter…

Q: C. Three cylinders are piled in a rectangular ditch as shown. R, = 5cm, R2 = 6 cm, R3 = 5 cm. W, =…

A: Reactions at A, B and C are :

Q: ( 3 cm ) in diameter and has a slope of ( 30° ) with the horizontal. The pressure gradient along the…

A: Given data

Q: Home Work Check the stability of the gravity dam section shown in Figure at the section AA' assuming…

A: We have to check the stability of the gravity dam section shown in the figure according to the given…

Q: An 8-m long dam was constructed with a parabolic corner shown below. What is net force xperienced by…

A: FH=ρghA=103×9.81×14×35×2×23×5×2=994.08 KnFY=ρgV¯=103×9.81×14×8×8+23×5×2×8=9312.96 Kn

Q: The flownet at a site of a reservoir is shown in Figure P4.17. (a) How many flow channels are…

A: for a flow net the equipotential lines and flow lines are perpendicular to each other and in the…

Q: * Draw the active earth pressure diagram, calculate the magnitude and location of the active earth…

Q: If a triangle of height d and base a is vertical and submerged in liquid with its vertex a distance…

Q: Water flows at a rate of 20 m3/s through a rectangular section 4 m wide from a ‘steep’ slope to a…

A: Given :- Rate of the water flow (Q) = 20 m3/s Width of the rectangular section (b) = 4 m The…

Q: A rectangular scow 9.15 m wide by 15.25m long and 3.65 m high has a draft of 2.44m in sea water. Its…

A: Given: The dimension of the rectangular scow is 9.15×15.25×3.65. The center of gravity above the…

Q: The pore water pressure (kPa) at D due to capillary rise is y = 16.0 kN/m? Ysat = 16.5 kN/m3 0.5 m D…

Q: Q1/ For the hydraulic structures below, Q = 20o0m3/sec, water way = 100m, Pond level = 160m, safe…

Q: A 10-m-thick layer of stiff saturated clay is underlain by a layer of sand. The sand is under…

Q: A rectangular scow 9m wide, 15m long, and 3.6m high weighs 3304kN. a. What is the draft in the…

A: Metacentric height: Metacentric height is calculated for the initial static stability of the body.…

Q: Q1/ For the hydraulic structures below, Q = 2000m3/sec, water way %3D = 100m, Pond level = 160m,…

Q: The water is flowing through a taper pipe of length 250m having diameters 750mm at the upper end and…

Q: Question attached

A: To find the permeability of sand Allen Hazen's empirical equation is used. The formula for the…

Q: Points A and B are 5km apart along a new 60cm diameter cast iron pipe carrying water. A is 9m higher…

Q: Water flows in a wide channel at Fr=4.5 and y1 = 2.40 m. If the flow undergoes a hydraulic jump,…

Q: 8. A masonry dam (sp.gr.=2.4) of a trapezoidal cross section with one face vertical and a horizontal…

A: The Step by Step Solution is Given Below: (1m width considered) Height of Dam =944.64inch…

Q: Q: A 300 mm diameter of a rough pipe is carrying water .If the velocities at the pipe center and at…

A: The wall shear stress for turbulent flow as per Prandtl mixing length theorem is given by: Where, l…

Q: What is the lateral earth pressure induced by the surcharge of 25 kPa at depth = 1.5m? q = 25kPa…

A: GIVEN SOIL STRATA

Q: Calculate for the hydraulic gradient if the pressure at point A is 15877N and 13577N for point B.…

Q: A wooden circular board 1-m diameter is being submerged vertically in a liquid having SG-1.15. Its…

Q: Calculate for the hydraulic gradient if the pressure at point A is 18547N and 15874N for point B.…

Q: 11.28. A trapezoidal channel is to be designed to carry a dis- charge of 75 m'/s at maximum…

A: step 1-

Q: Along the depth for r= 2m, and b. At depth z = 2m. а.

A: given Z=2 and r=2

Q: A vertical triangular gate 2.0 m wide and 4.6 m high is submerged in oil (SG=0.83) with its tip edge…

Q: An 8-m long dam was constructed with a parabolic corner shown below. What is net forced experienced…

A: Solution; Given that; Length of dam=8m long ρ=1000 kg/m3 for H2o

Q: A bore is a hydraulic jump that propagates upstream into astill or slower-moving fluid, as in Fig.…

A: In the open channel flow the froude number is used know about different flow patterns. it is the…

Q: Water enters the pump of a steam power plant at 20 kPa and 50 °C (p = 988 kg/m', & Pr = 12.352 kPa)…

Q: (b)- Calculate the total head at point C. (c)- Calculate the pressure head at point D. (k=4x10m/s…

A: T.HLT (total head at left top) = 4.5m D.H.LT (datum head at left top) = 2m P.HLT (pressure head at…

Q: rectangular scow having a length equal to 12 m, width of 10 m and height of 6 m ats in seawater. If…

A: Metacentric Height(M) = 0.75m Location of Buoyant force = 3m

Q: PROBLEM 2 The pressures at polnts 1 and 2 of the water plpe shown are 300 kPa and 100 kPa,…

Q: Check the over all stability for an earth dam with top width =8 m, height of dam=25m hw= 1.2m, u/s…

Q: Water flows upward in a vertical 300-mm pipe at the rate of 0.222 m³/s. At a point A in the pipe the…

Q: Trapezoidal section Q=120 m³/s S = 12 cm/km, Side slope 2:1, n=0.0182 Compare the dimensions for two…

A: Answer : (1) Let us first calculate the dimensions using the given data for the trapezoidal section…

Q: Q-4: A 9-m-thick layer of stiff saturated clay is underlain by a layer of sand (following figure).…

Q: Storm water from a housing area is discharging 10.8m'/s and is designed to flow a trapezoidal…

Q: 7.) Water flowing in an open channel at a depth of 2 m and a velocity of 3 m/s. If flows down a…

Q: Q1 For the flow net shown below, K=(5.3*10 cm/sec ),Ysat=18.2 kn/m and the wide of concrete dam =305…

A: Given γsat=18 kN/m3 k=5.3*10-5m/s NF=no of flow channel=4 Nd=no. of equipotential drops=13 H=Net…

Question

Problem 3 -106
Compute the hydrostatic force and its location on semi-cylindrical indentation
BCD shown. Consider only 1 meter length of cylinder perpendicular to the
figure below.
Ans: Fy @ 1.349 m below D
109.5kN
Fv3D20.5kN @ 0.531 m to the left of B

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three independent lines oflevels are run from BM1 to BM2. Route A is 6km long, route B is 4 km long and route C is 8km long. By route A, BM2 is 82.27 m aboveBM1, by route B, BM2 is 82.40 m above BM1and by route C, BM2 is 82.10 m above BM1.1. Compute the probable elevation of BM2if the elevation of BM1 is 30.5 m. a. 113.13 m c. 113.45 m b. 112.79 m d. 113.06 m
q = 4.6 kN/m
Help ASAP! w: 2.8 kN/m , a: 3.4 m, b: 3.5 m, theta: 30 degrees
F (kN)=36 L1 (m)= 37.0053 Eal (GPa)=74
water flows at 12m^/s in a concrete trapezoidal channel n=0.015 bottom width 4m side slopes 2H:1V longitudinal slope = 0.0009.if the depth flow at a gauging station is measured as 0.8m use the direct step method to find the location where the depth is 1.0m
Ans in kN/m
HELP ASAP!!!! P: 4.5 kN , x: 10.8 m, y: 8.7 m
A swimming pool has a width of 12ft and a side profile as shown. Determine the eccentricity e of the resultant force the pressure of the water exerts on bottom BC. inclined BC makes an angle of 14.478 with the horizontal.
Use fbd rectilinear motion
Solveforthemean velocity and dischargeof atrapezoidal channel in whichdepth of flow is3.0 m. The channelis 10.0 m wide and has a side slope of 1.5 horizontal: 1 vertical. The bed slope is 0.0003. The channel is lined with smooth concrete of n =0.012
24.5m is the right ans.
A rectangular gate 1.60 m wide and 2.40m high has water on one side and is inclined 45\deg with them horizontal. Water is 1.50m above the top of the gate. Evaluate the location, in meters, of the center of pressure from the top of the gate. a. 1.34 b. 1.49 C.1.56 d. 1.64