Problem 3: Write the MOST equation for the task and calculate the Normal time for the process (in seconds): "An operator reaches down to grasp a heavy box located on the floor. She walks eight steps and stoops to locate the box on an elevated pallet (36 inches from the floor) and returns to her initial location."

Problem 3: Write the MOST equation for the task and calculate the Normal time for the process (in seconds): "An operator reaches down to grasp a heavy box located on the floor. She walks eight steps and stoops to locate the box on an elevated pallet (36 inches from the floor) and returns to her initial location."

Practical Management Science

6th Edition

ISBN:9781337406659

Author:WINSTON, Wayne L.

Publisher:WINSTON, Wayne L.

Chapter2: Introduction To Spreadsheet Modeling

Section: Chapter Questions

Problem 20P: Julie James is opening a lemonade stand. She believes the fixed cost per week of running the stand...

See similar textbooks

Similar questions

Explain what are the fundamentals purpose of work measurement is to set time standard for a job ?
A hotel housekeeper, Alison Harvey, wasobserved five times on each of four task elements, as shownin the following table. On the basis of these observations, findthe standard time for the process. Assume a 10% allowancefactor.
A hotel housekeeper, Alison Harvey, was observed five times on each of four task elements, as shown in the following table. On the basis of these observations, find the standa rd timefor the process. Assume a I 0% a llowance factor.
Describe the fundamentals purpose of work measurement is to set time standard for a job ?
What are the fundamental purpose of work measurement is to set time standards for a job?
Use excel to show formulas 2.A job had an observed time of five minutes, a performance rating of .70, and an allowance factor of 20 percent of job time. Twenty cycles were timed. Standard time for the job in minutes is:
Describe when is work sampling a more appropriate work measurement technique than time study ?
Installing mufflers at the O'Sullivan Garage in Golden, Colorado, involves five work elements. Jill O'Sull ivanhas timed workers performing these tasks seven times, with the results shown in the following table: By agreement with her workers, Jill allows a 10% fatigue factor and a 10% personal-time factor, but no time for delay. To compute standard time for the work operatio n, Jill excludes all observations that a ppear to be unusual or nonrecurring. She does not want an error of mo re than ±5%.a) What is the standard time for the task?b) How many observations are needed to assu re a 95% confidence level?
Based on a careful work study in the Hofstetter Corp., the results shown in the following table have been observed: a) Compute the normal time for each work element.b) If the allowance for this type of work is 15%, what is the standard time?c) How many observations are needed for a 95% confidence level within ±5% accuracy? (Hint: Calculate the sample size of each element.)
Suppose Charlene Brewster has times (in seconds) of 8.3, 8.5, 8.4, 8.4, 8.6, 8.6 and a performance rating of 110%. a) For a given allowance factor of 15%, the standard time for the operation = ? seconds (round your response to two decimal places).
Describe some of the limitations of time study method ?
How can the time for a machine operator be classified,Turns between each job and often between work Go for stock, off the machine?