Problem 3. Honey is being pumped through a network of small tubes with inner diamter D = 15 µm (Fig. 1). The straight section of the tube has length of L = 5 cm, while the circular section of the tube forms a circle with radius R = 5 cm. 1. Given the viscosity of honey lhoney = 10 Pa-s, density of honey Phoney = 1450 kg/m³, and assuming the flow splits evenly at the intersections, what is the total pressure drop required to maintain a flow rate Q = 0.5 mL/min as predicted by Poiseuille's law? 2. Does the Reynolds number of the flow support the use of Poiseuille's law? R Figure 2: Honey is being pumped through a network of small tubes. to

Problem 3. Honey is being pumped through a network of small tubes with inner diamter D = 15 µm (Fig. 1). The straight section of the tube has length of L = 5 cm, while the circular section of the tube forms a circle with radius R = 5 cm. 1. Given the viscosity of honey lhoney = 10 Pa-s, density of honey Phoney = 1450 kg/m³, and assuming the flow splits evenly at the intersections, what is the total pressure drop required to maintain a flow rate Q = 0.5 mL/min as predicted by Poiseuille's law? 2. Does the Reynolds number of the flow support the use of Poiseuille's law? R Figure 2: Honey is being pumped through a network of small tubes. to

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Estimate the discharge of a well pumping water from a confined aquifer of thickness 20 m with the following data. Distance of observation well from the pumping well = 100 m Drawdown at the observation well after 4 hours of pumping = 1.5 m Drawdown at the observation well after 16 hours of pumping = 2.0 m Storage coefficient, S = 0.0003 Ans. Q = 1611 lpm
6. Freshwater and seawater flowing in parallel horizontal pipelines are connected to each other by a double U-tube manometer, as shown in figure. Determine the pressure difference ?????? ?????−???? ?????= ?(kPa) between the two pipelines. Take the density of seawater at that location to be P = 1035 kg/m³. (2 decimal)
Oil with a specific weight of 8.64 kN/m3 flows from A to B through the special fabricated system shown in figure 6.31. Calculate the volume flow rate of oil
USING FOL Differential Equation APPLICATION SOLVE THE FOLLOWING PROBELM AND SHOW COMPLETE SOLUTION AND FINAL ANSWER.In a tank of 100 liters of brine containing 50 kg total dissolved salt. Pure water is allowedto run into the tank at the rate of 3 liters a minute. Brine runs out of the tank at the rateof 2 liters a minute. The instantaneous concentration in the tank is kept uniform bystirring. How much salt is in the tank at the end of 1hour?
In a falling head permeability test, head causing flow was initially 50 cm and it drops 2 cm in 5 minutes. How much time in minutes required for the head to fall to 25 cm ? a. 89.4 b. 98.4 c. 84.9 d. 49.4
A cylindrical tank 2.20 meters in diameter and 15 meters high is filled with liquid Z. Apressure gage at elev. 10m at the side of the tank reads 105 kPa.Another gage at elev. 6m reads 140 kPa. Compute the specific weight of the liquid, density and specific gravity.
Ken discovered an element (11.15 kN/m3) that flow through a 215-mm-diameter pipe at a mean velocity of 9 m/s. Determine its mass flow rate in slug/s. Use 1 slug = 32.2 lb and 1 kg = 2.2 lb.
A 12.5mm diameter orifice at the vertical side of the tank showed a discharge of 60 liters for every 85 seconds at a constant total producing head of 4.5m. Measurement of the jet showed that it travelled 2.4m horizontally while dropping 400mm. Determine the coefficient of contraction.
In a falling head permeability test, head causing flow was initially 50 cm and it drops 2 cm in 5 minutes. How much time in minutes required for the head to fall to 25 cm ? Provide a diagram. a.49.4 b.89.4 c.98.4 d.84.9
Figure P3.12 shows a jet pump that consists of a tube within a tube. Air is forced into the smaller tube at a pressure of 700kPa, a temperature of 300K, and a velocity of 3 m/s. This high-velocity jet draws atmospheric air into the larger tube at a pressure of 101.3kPa, a temperature of 300K, and a velocity of 8 m/s. Determine the velocity of the air drawn in by the jet.
Fresh and seawather flowing in parallel horizontal pipelines are connected to each other by a double U-tube manometer. The pressure difference between the two pipelines is to be determined. The densities of seawather = 1035 kg/m3 and mercury=13600 kg/m3.
ii, Calculate the volume and surface area of a solid cylinder 1.5 m diameter and 2.5 m tall.