Problem 5: 1-17.* What is the maximum number that we can count up to using 10 bits?

Q: What is the minimum number of bits required to store the result of the operation (-6410 - 6410) if…

A: Two's Compliment: Two's complement is a numerical complement that is a mathematical operation on…

Q: .How many bits are needed to represent each whole number from 0 to 31 uniquely?

A: here the number 0 to 31 consist of total 32 numbers

Q: Draw a truth table for half adder, half subtractor, Full adder and Full subtractor. Clearly mention…

A: According to our rules , we will answer only the first three parts .If you want solution for the…

Q: a) Write a program to PUSH R0, R1, and R3 of Bank 0 onto the stack and POP them back into R5, R6,…

A: The question has two parts. Since you have not mentioned which part you are looking for, so we are…

Q: Design the interfacing circuit shown below and write a program to display single digit (between 0…

A: According to the question, we need to write the program for LPC1768 to display prime number, even…

Q: Convert the BCD NUMBER 0001 1000 0000 0100. 0101 0110 0010 0101 to BINARY number showing the steps…

A:

Q: The minimum decoders using to design 6- to-64 decoder are

A:

Q: A 10 bit ADC is working with a voltage ranging between 0 V to 122 V. What will be the maximum…

A:

Q: Q4/ A- Using the signal constellation shown: 100 270 1- What type of modulation does this represent?…

A: The given signal constellation is shown below:

Q: esign a 4-bit combinational circuit that counts DOWN and UP. Counts 1 - 7 only. The first and the…

A: A truth table is a tabular representation of the digits with 0 and 1, which shows the working of the…

Q: What is the maximum number that we can count up to using 10 bits?

A: To Find:- Maximum Number that can be count up to using 10 bits.

Q: Q0 Q1 Q2 Q3 clock - Given: • Counter starts at decimal 9 when Q viewed as a 4-bit unsigned number…

A: Number   Unsigned        Signed (+ve)             Signed (-ve)              0…

Q: What is the maximum number that we can count up to using 14 bits?

A: The smallest storage unit is referred to as a Bit. Bit stands for Binary Digit. A bit stores any one…

Q: Suppose you have 4 bits at your disposal. What is the largest number you can write with these bits?…

A:

Q: Add 3 and 5 Carry bits 1. 4-bit number 4-bit number

A: Given :

Q: Design 6- stages Ring counter. (Write truth table and draw block diagram)

A: Solution: Block diagram of a six-stage ring counter is as follows:

Q: what are the application of Flip – Flop. b- What is the difference between the Flip – Flop circuit…

A: In this question we will write about applications of flip flops...

Q: BINARY NUMBERS

A: Given- Binary digit- B1 = 10001.0001 B2 = 101.11

Q: what is -4 (negative 4) in a 2's complement of 8 bits?

A: 8-bit representation of a binary number is extremely useful and it is often called sign-magnitude…

Q: How to store (1050000)10 in register $s0? Write down the instructions that stores the data in $s0…

A:

Q: If a 10-bit ring counter has an initial state 1101000000, what is the state after the second clock…

A:

Q: الإنجليزية A report on the explanation of the types of flipflops, type SR with simple explanation,…

A: JK flip flop:-

Q: A report on the explanation of the types of flipflops, type SR with simple explanation, type Jk with…

A: A report on the explanation of the types of flip flops, type SR with simple explanation, type Jk…

Q: 7-1. *The following memories are specified by the number of words times the number of bits per word.…

A:

Q: Does your data table verify Ohm’s law ?

A: Ohms law .: According to  ohms law current is directly proportional to the current flowing through…

Q: Which of the following BCD number (100000000011)BCD converted to decimal number? *

A:

Q: mplement a 8:1 Multiplexer using 2:1 Multiplexers. NOTE: Please explain clearly, make a truth table,…

A: Given: Implement 8:1 Multiplexer using 2:1 Multiplexers. According to question: For Designing: Here…

Q: For single bit Parity after adding the redundancy the number of once should be

A: consider the given question;

Q: the diagram on the right is for a register bank circuit that contain 8 registers. Each register is…

A: The following circuit gives the 8 x 16 memory unit

Q: How many bits are required to numerically represent the temperatures between 0 ° C and 100 ° C with…

A:

Q: Static RAM are used as cache memories. Select one: True False

A: We need to tell about cache memory.

Q: (B) Suppose you have a reg. contains 8-bits I1001001 & we need to replace the four leftmost bits by…

A:

Q: Q2: Consider a line of code- LDD $C100. Before execution of this line of code, the memory locations…

A: We need to select correct option for given statement

Q: -map, the bits can be grouped in powers of

A: K-map is used to simplify boolean expressions.

Q: 5- Convert five bit Gray to bináry code, write truth table and draw the circuit diagram.

A: This question is from "digital electronics" in which we are going to convert gray to binary codes.

Q: This is a block diagram of 4-bit adder. Show how binary number 1101+1001 is added. Write the values…

A: The four-bit adder can be implemented using the one-half adder and three full adders.

Q: In linked list, memory is always fixed, and memory is allocated in the beginning, and once…

A: Linked list memory

Q: The address that locates a variable within memory is what we call a to that varjable

A: The explanation is as follows.

Q: What is the largest number that can be represented using eight bits? a) In decimal system b) In…

A: 8-bits  8-bit is a computer information measurement that was commonly used to refer to hardware and…

Q: 3- Two numbers (A,B), each number have two bits, Use Decoder to design a comparator between numbers…

A:

Q: 3- Write the truth table for 8 to 3 encoder. 5-4

A:

Q: wing decimal numbers to their bin

A: The number system is categorized into the following types, Decimal number system Binary number…

Q: What will be truth table

A: There are two variables used in the given boolean function so we will have only 4 combinations of…

Q: Write a verilog code for ring counter using D flip flop.

A: Counter is a  sequential circuit made up of flip flop which are connected to count the pulses .…

Q: The address that locates a variable within memory is what we call a to that variable

A: As per Bartleby guidelines, we are allowed to solve only one question, please ask the rest again.…

Q: Write one line of code to print a random value between 10 and 60 inclusive.

A: The minimum required code to print  random value between 10 and 60 inclusive is   #include…

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.