Problem 5: Is a rice cooker is plugged into a 220 V outlet that supplies 2.7 A of current, what amount of power is used by the rice cooker and find also the resistance.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 10PP: In an R-L parallel circuit, ET=240 volts, R=560, and XL=330. Find apparent power.

See similar textbooks

Related questions

Q: 3. Determine the current through each resistor. 20 10 0 12 V 50 10 Q 5 V

Q: 1. a) Find an expression for the equivalent resistance of two resistorsof value R in parallel.2. b)…

A: The given appendix H is shown below.

Q: The total area of a football ground is 1500 m?. If we cover this ground with PV cells to make it as…

A: The valuer of solar irradiance varies from place to place and with the season. The value at the…

Q: Find the equivalent resistance for the circuit shown in Fig. 300 ww 100 100 ww ww 300 100 300 Rec ww

A: To find the equivalent resistance across any terminal, it is advised to simplify the circuit using…

Q: Using Kirchhoff's laws, find voltage across each resistances for the circuit sho Fig. 6

A: Write KVL equations; -I11-2I1-I3+3I2+I3+4I2=0 -3I1+7I2+5I3=0…

Q: labäi In the series parallel circuit shown in Fig.6. the supply voltage and drop voltage across the…

A: The parallel combination of 10 and 8 ohm branch and the parallel combination of 24, 12 and 8 ohms…

Q: For the network graph shown in the given figure, find the number of nodes, branches, and independent…

A: As it can be observed from the above figure, the number of nodes present in the given network is 8

Q: It is desired to measure the voltage of the R2 load in the circuit given on the side. Find the…

A: In the question, Voltmeter is connect to measure to voltage across the resistance R2 Find the…

Q: Find the voltage Vs ,using superposion

A: While using super position theorem, we consider one source of power at a time. Compute the…

Q: H.W: Choose values of resistance (Rc and Rs) in Kilo ohm and then voltage sources in volt (Vcc>…

A: Here i have assumed that the transistor is in active mode and derived the current and voltage…

Q: Use superposition principle to find the voltage across 1k2 resistance in the circuit shown in Fig.1

A: By using superposition theorem: When only 12 mA Find current 1 kΩ:i1kΩ=1.54.5×12i1kΩ=4 mA When only…

Q: Q5: Find the maximum power transferred to the (452) resistor in the circuit shown below:

A: According to the question, for the given figure as shown below We need to calculate the maximum…

Q: (5) A manufacturing plant installed the system above (500 KW) and has a full load capacity of 700KW…

A: Note: Here it is mentioned that "the system above". but the system details not given. We assume,…

Q: 2. Using Millman's Theorem, find the value of output voltage Vo in the circuit shown. All…

Q: 1. Use Kirchhoff's laws to find the current flowing in the 60 resistor of Fig. and the power…

Q: Compute for the voltage Vabin the circuit shown below RS w- 2 Ohms R3 ww S Ohms R1 R2 4 Ohms 8 Ohms…

A: Resistance opposes the flow of current. The resistance of element having voltage V across it and…

Q: 1. a) Find an expression for the equivalent resistance of two resistorsof value R in series.2. b)…

A: As per our policy, i have attempted 3 parts. a) Calculating equivalent resistance of two resistor in…

Q: 1. Connect the circuit shown in Fig. (6). 2. Measure the values of voltages and currents of each…

Q: Consider the circuit diagram below. In this question, the resistor Rip has a value, in Ohms, that is…

Q: 1. State Kirchhoff's laws and apply them to the solution of the following problem. Two batteries, A…

A: 1) VA =1005+95315+13+180 (By millman's theorem)=51.670.545VA = 94.8 Volt terminal voltage

Q: Choose two Renewable Energy sources make your own design set-up of the systems that can be use in…

A: Renewable energy sources generate energy without providing harm to the environment as these are the…

Q: In the circuit shown, a) obtain the condition from maximum power transfer to the load Rl. Hence,…

Q: Q5/ Using a A-Y or Y-A conversion, find the current I in each of the networks in Fig. 5. www www 6kn…

A: We need to find out current for given circuit

Q: 23. Use Kirchhoff's laws to determine, for the network shown in Figure current flowing in (a) the 20…

Q: Two coils connected in series have resistances of 600 N and 300 Q with temperature coefficient of…

Q: Q1/ For the circuit shown below of Shunt type ohmmeter calculate the value of Im at different values…

A: The shunt type ohmmeter connection can be done with the given components. the Potentiometer…

Q: Solve as a function or equation of the Resistance R, unCox, and ratio of (W/L)1 and (W/L)2.

A: Since M3=M4, ID3=ID4=ID1=ID4=IBIASIBIASR=VGS1-VGS2IBIAS=1RVt-IBIASμnCox2 ωL1-Vt2-IBIASμnCox2…

Q: If the same meter movement in no.4 is used to construct a multi range voltmeter whose ranges are 5…

A: The given voltmeter ratings are: Voltage range of the meter Vm=3 V Meter resistance Rm=500+2500=3000…

Q: Think logically and design a small wind turbine of your own which is having the turbine power output…

A: In this design problem, the following information is given: Energy generated (E)=200 kWh per year.…

Q: Determine the current in the 5Ω resistance of the network shown in the image using DC circuit…

A: The solution is given below

Q: Find the power dissipated in the 12-ohm resistor and the power delivered by the current source.

Q: a) What value of Vg is required in order for the interconnection to be valid? b) For this value of…

A: The above circuit can be solved using either of the circuit theory rules mentioned below:…

Q: The headphones have a resistanceof 600Ω . The headphone amplifier in a battery-powered deviceis…

A: Consider the expression for current, I0=2P0RL Where, P0 is headphone output power RL is load…

Q: - Calculate V and current flow through all the resistance in the circuit shown in Fig. 5

A: Find current in 125 ohm,…

Q: For the crcuit shown below, find v().

Q: I Iska + + + Vs -12 V 1k2 5k2 VA10k2 C

A: Given circuit

Q: Rg VIN

Q: For the plant in Exercise 4, assume that the total plant load varies between 150 MW and 500 MW. For…

A: Q6.

Q: Find, theoretically and using Thévenin's theorem, the current in the 1 k ohm resistor.

A: The solution can be achieved as follows.

Q: Use nodal analysis to find the current in various resistors of the circuit shown in Fig. 6.

A: First let us consider the nodes and the currents in the branches ,

Q: R=2 kn R4=2 kN Ix Ix Rz-l kf R2=1 kft R1=2 kt R1=2 k V- 5 VỘ R3=3 ka Y-5 VO R3-3 ka|O V= 4lx V= 41x…

Q: 30 k2 ww 10 kQ 5 kO Consider the following circuit and find the voltage gain.

A: Calculation of voltage gain of the given op-amp circuit. We know, Volatge gain AV=V0VI Input is…

Q: In the Power Transfer experiment, which of the following is true? a. The power generated by the…

A: a). The power generated by battery does not depends on the load resistance. Option a is wrong why…

Q: Determine the Equivalent Resistance (Rab) of the circuit. ( please provide illustrations/drawings it…

Q: Q1: Given the circuit shown in figure below, determine the mesh currents in the circuit.

Q: The heating element in an oven has a resistance of R =32 ohms. One of the wires connecting the oven…

Q: 2 A 7 V 20 4 V 4 AO Oav )4 V

Q: ctice Problem 5.10 If v = 7 V and v2 3.1 V, find v. in the Fig. 5.33. 60 k2 20 k2 30 k2 50 k2 ww 10…

A: Given data, v1=7 V, v2=3.1 V Circuit diagram is given as,

Question

Topic: Ohm's Law, Current, Voltage and Resistance Concepts

Kindly answer the problem. Thank you.

Problem 5:
Is a rice cooker is plugged into a 220 V outlet that supplies 2.7 A of
current, what amount of power is used by the rice cooker and find also
the resistance.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 30-volt source battery is connected in series with the 6-load resistors namely 1 ohm, 2 ohms, 3 ohms, R ohms, 5 ohms, and 6 ohms respectively. If the total power is 30 watts, find the value of R in resistance and its current drawn as well as the total resistance (a) provide solution (b) provide circuit diagram
Design a 25V solar PV panel system that can power a home that requires two 30-Watt lamps and four 15-Watt fans for 6 hours daily if the factors for the solar panel generation and the total energy losses respectively are2.92 and 1.3. Take the rating of the available solar PV cell as 5V, 5W
Design a 24v zener regulated power supply circuit that will power a 500 ohms load with 1A of of current. Determine the power rating of both bleeding resistor and load resistor. Note the computed power dissipation differ from the required power rating of the device.
Simplify the circuit to determine VR1 and then determine the power delivered by the three current sources.
in order for the maximum power transferred on the 4kΩ load in the circuit, find R.
For the circuit shown in Figure, find, using the superposition theorem, (a) the current flowingin and the potential difference across the 18-ohm resistor, (b) the current in the 8 V battery and(c) the current in the 3 V battery
answer the following questions using the attached picture. (c) To measure the current flow though R1 and the voltage onR5, how should we connect the ammeter and voltmeter?Draw a circuit diagram showing your answer. (d) What is the ideal impedance of1). an ammeter?2). a voltmeter?
find resistor 2k , current using mesh, nodal and superposition
Solve the given questions and show your complete solution. Determine source voltage and unknown resistances.
Determine the mesh currents in the circuit given.Please provide a CLEAR and COMPLETE solution
A electrical company provides power to a house at 220V AC and can supply up to 600A, for a maximum power of 132kW. The wiring in the house is sized so that the total resistance of wiring is 0.02 Ohms. What is the worst case power loss in the house due to voltage drops in the wiring?
Given that the total resistance is 15 Ohms and the Voltage Source is 30 V: (1) Determine the current through the 18W resistance of the circuit.(2) Potential difference across the 10W resistance if a 30Vdc source is connected across the terminals.