Answered: Problem 8 - 55 A rectangular echannel…

Problem 8 - 55 A rectangular echannel has a width of 3 m. If the discharge flowing in the canal is 2.1 m/s and coefficient of roughness n= 0.015, compute the critical slope. Ans: 0.00414

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter15: Slope Stability

Section: Chapter Questions

Problem 15.28P

See similar textbooks

Related questions

Q: 3. | Calculate the change in total vertical normal stress (o) and in effective stress (6') au a dept...

A: given data: water content, w = 35% = 0.35 Depth, h = 10 ft Degree of Stauration, S = 100% Specific g...

Q: used in a transmission not restrained in directio N/mm?.

Q: urve is to connect 50 meters and 400

Q: The concrete pier (E=29 GPa) is reinforced by four steel rods (E=200 GPa). If the pier is subjected ...

Q: A reservoir discharges water through a large gate 1m wide and 1.5m deep. The top of the gate is 0.8 ...

A: b =1m d = 1.5m Cd= 0.6 It has been asked in the question to determine the discharge through the g...

Q: Q.5: During Project Planning and Financing for maintenance work, requires Insurance, Precautionary a...

A: Brief concept introduction- Project planning and financing- The process of project evaluation and bu...

Q: Problem 3. Member ABC is supported by cable CD and a square collar at A that fits loosely over the s...

A: Given -

Q: 2. The lengths LAB = LBC = 20o mm and LCD = 240 mm. The diameter of parts AB and CD of the bar is 25...

Q: Y water is transpor ted at 75°F (v- 10$ for 1500ft .in (l.s)in - dianeter wrought iron horizontal pi...

A: Given: T = 75 F, D = 1.5 in, Q = 0.1 m3/sec, We need to determine the pressure drop over 1500 ft le...

Q: The top width and the depth of flow in a triangular channel were measured as 5 m and 1 m respectivel...

Q: Two pipes are connected to an open tank of water; pipe A and B have diameters of 8 in and 10 in, res...

A: Given Data -

Q: PISBILM N8. For the embankment shown in Figure below, determine the vertical stress increases at poi...

Q: Calculate the collapse load of a fixed end beam subjected to a load Wat one-third span. - 1/3 м, 15 ...

Q: Why does the government need to publicly bid for their various government projects? Briefly Justify ...

A: Just like private companies, the government needs to buy goods and services for their operation and ...

Q: Problem 3. Member ABC is supported by cable CD and a square collar at A that fits loosely over the s...

A: CALCULATIONS of tension in Cable CD###

Q: Based from a study to a certain player using Aldous in Rank Game, the No. of Stack collected by the ...

Q: Problem 1. Use slope-deflection method and determine the following unknowns on the beam show below. ...

Q: sorption study of Cd2+ on a sandy loam gave the following results: Equilibrium Concentration ...

Q: 70 kN/m y 25 kN/m A В C D 2.5 m 4.0 m 1.5 m

Q: 2-1. The steel framework is used to support the rein- forced stone concrete slab that is used for an...

A: given data thickness of slab = 200 mm a=2 m b=5 m We have to Sketch the loading that acts along memb...

Q: 100 kN 300 kN · m A В 6 m 3 m

Q: The bar shown determines: a) The internal force in section AB, BC and CD. b) The approach or dista...

A: Given, Cross sectional area=50 mm2 Modulus of elasticity=200×109 Pa

Q: A simple curve has a central angle of 36° and a degree of curve of 6°. a) Find the nearest distance ...

Q: & For the flow f an incomprusible fluid, the velocity componeut in component in z-direem is zero · f...

A: Given, For compressible fluid, Velocity components in x-direction, U= ax²+by In z-direction = 0, Ve...

Q: Determine the solid loading rate on a secondary circular clarifier (diameter = 20 m) if the plant in...

Q: SITUATION. A fully continuous monolithic floor system consists of slab as shown. Use the ACI moment ...

Q: Problem 2. A parcel land has been surveyed in the field and the lengths and bearings of the various ...

A: Calculate the latitude and departure as given as, Latitude=L cosθ Departure=L sinθ LAB=59.82×cos53°2...

Q: Design a stanchion 3.5 m long in a building subjected to an axial load of 350 kN. Both the ends of t...

Q: The steel plate shown below is put in into a rigid chamber, such that spacings of size s-000188 m. T...

Q: What is the hydraulic radius of the channel shown in the Figure? 1.5 m 1.5 m 1.2 m

Q: Design a prestressed beam using the elastic design method. Given, MT = 320k-ft, MG = 40k-ft, h =36in...

A: Prestress: The method of applying precompression to control the stresses in a concrete member. These...

Q: nt is shown on the

A: given:σx=102MPaτxx=124MPa

Q: 3. | Calculate the change in total vertical normal stress (6) and in effective stress (o') at a dept...

A: Given, Specific gravityGs=2.75 Degree pf saturation S=100% Water content =35% Depth=10 ft

Q: o a depth of 20 feet below the ground surface. S = 100% and G, = 2.75. Assume that no change occurs ...

A: Data given water content =35%S=100%Gs =2.75void ratio of soil is given as wG=Se35×2.75=100×e e=0.9...

Q: 7) Find the bar forces for the bars marked with an "X". 32 B, 24 F 20 k 40 k 30 k 2 @ 32' = 64'

A: To Determine The bar forces for the bars AD CD CG FG

Q: | Calculate the change in total vertical normal stress (o) and in effective stress depth of 10 feet ...

A: solution: Given: water content = 35% saturation = 100% Specific gravity = 2.75 void ratio; e=wGS=0.3...

Q: PROBLEM 3. A cylindrical steel column as shown below is subjected to an axial load of 50 kN. Determi...

A: This question is related to the Engineering Mechanics from Civil Engineering.

Q: Determine the seepage through the homogeneous earthen dam section shown below, if coefficient of per...

Q: Determine the slope and displacement at point A. Assume Cis pinned. Use the principle of virtual wor...

Q: Water flows through a sand filter as shown on the figure. The soil has a cross sectional area of 0.2...

Q: Rax Ray Rbx 3.5 Rby Cx Cy Pin 6 kip Dx Dy Ex Rolkr Ey 25tt, 2.5ft, 5t

Q: Rod AB has a diameter d and fit snugly between the rigid supports at A and B when it is unloaded. Th...

Q: Problem 1. Use slope-deflection method and determine the following unknowns on the beam shown below....

Q: A linear sinusoidal water wave with wave length 140m and 3-m wave height at 30m water depth. (use se...

A: The 'total pressure' is the sum of the static pressure, the dynamic pressure, and the gravitational ...

Q: 3. Part AB of the bar has a solid circular cross section and part BC has a hollow circular cross sec...

Q: Calculate the passive earth pressure coefficient for the foundation soil to the right of the toe of ...

A: Given data for the soil to the right of the toe Moist unit weight γm = 18 KN/m3 Angle of internal f...

Q: Problem 1. From the field notes of a closed traverse shown below, adjust the traverse. Lines Bearing...

Q: main span ground anchoroge typical (main spon' 11 (0) (b) (c) (0) (e)

A: Suspension bridge Bridge in which span weight is supported by suspended cables. The load carrying c...

Q: 2. In Fig. P-226 assuming counterclockwise moments as positive, compute the moment of force F 200 kg...

Q: he shaft is supported by a smooth thrust bearing at A und a smooth journal bearing at B. Figure 1) f...

Question

Show the solution of the problem, Explain every step.

Problem 8 - 55
A rectangular echannel has a width of 3 m. If the discharge flowing in the canal
is 2.1 m/s and coefficient of roughness n= 0.015, compute the critical slope.
Ans: 0.00414

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Give me right solution Determine the length of back water curve caused by an affux of 5 m in a rectangular channel of width 50 m and depth 2 m . The slope of the bed is 1 in 2000 . Take n = 0.03
width of rectangular channel = 3.6 meters discharge = 2.7 m^3/s Assume n = 0.012 What is the critical slope of this wooden flume?
Determine the critical slope for a rectangular smooth concrete flume (n=0.013) 4.5m wide which is to carry 4.5 m3/s per meter width of channel. Unit of answer: n/a No. of decimal places: 4
A river 30m wide and 3m deep has stable bed and vertical banks with a surface slope of 1 in 2500. estimate the length of the back water curve produced by an afflux of 2m. assume n =0.035.
Find the velocity and discharge through a trapezoidal channel of 1.5 m wide and side slopesof 1.5 horizontal to 1 vertical. The depth of water is 1.2 m. Manning’s constant n = 0.025.The slope of bed of the channel is 1 in 2500
a v-shaped channel, build of unplanned timber 0.080 m/ with a velocity of 2.5 m/s. each of the sides makes an angle of 45° with the horizontal. determine the slope if n = 0.014
a v-shaped channel, build of unplanned timber 0.080 m/ with a velocity of 2.5 m/s. each of the sides makes an angle of 45° with the horizontal. determine the slope if n = 0.014 determine the slope with complete solution.
A triangular channel has a vertex angle equal to 900. If the discharge uniformly flowing in the canal is 1.50 m3/s and coefficient of roughness n = 0.030, compute the critical slope using Manning’s equation.
A canal cut in rock (n — 0.030) is trapezoidal in section with a bottom width of 6.10 m and side slopes of 1 on 1. The allowable average velocity is 0.76 m/s. What slope will produce 5.66 m /s?
A circular channel having a diameter of 2m (n=0.015) is 3/4 full of water flowing. Determine the discharge if the channel has a slope 0.0005.
Find the required slope of a rectangular open channel when the water flows at a rate of 20,000 L/s, having a base width of 4m and depth water depth of 2.5m. (n = 0.013)
The streamflow in the trapezoidal canal cross-section has n = 0.013, side slope of 3:4 and bottom with 2m and the depth of water flow is 2m. The channel bed of the trapezoidal canal is laid on a slope of 3 m per 2km. Determine the wetted area in sq.m.