Problem 8: A capacitor of capacitance C = 6 µF has been charged so that the potential difference between its plates is Vo= 205 V. The capacitor is then connected to a resistor of resistance R = 19.5 k2. The switch S is closed, and the capacitor begins to discharge. Randomized Variables S C = 6 µF Vo = 205 V R = 19.5 kQ

Problem 8: A capacitor of capacitance C = 6 µF has been charged so that the potential difference between its plates is Vo= 205 V. The capacitor is then connected to a resistor of resistance R = 19.5 k2. The switch S is closed, and the capacitor begins to discharge. Randomized Variables S C = 6 µF Vo = 205 V R = 19.5 kQ

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 68AP: A circuit contains a D-cell battery, a switch, a 20- resistor, and three 20-mF capacitors. The...

See similar textbooks

Similar questions

The student engineer of a campus radio station wishes to verify the effectiveness of the lightning rod on the antenna mast (Fig. P21.71). The unknown resistance Rx is between points C and E. Point E is a true ground, but it is inaccessible for direct measurement because this stratum is several meters below the Earths surface. Two identical rods are driven into the ground at A and B, introducing an unknown resistance Ry. The procedure is as follows. Measure resistance R1 between points A and B, then connect A and B with a heavy conducting wire and measure resistance R2 between points A and C. (a) Derive an equation for Rx in terms of the observable resistances, R1 and R2. (b) A satisfactory ground resistance would be Rx 2.00 . Is the grounding of the station adequate if measurements give R1 = 13.0 and R2 = 6.00 ? Explain. Figure P21.71
A potential difference of 1.00 V is maintained across a 10.0- resistor for a period of 20.0 s. What total charge passes by a point in one of the wires connected to the resistor in this time interval? (a) 200 C (b) 20.0 C (c) 2.00 C (d) 0.005 00 C (e) 0.050 0 C
Two conducting wires A and B of the same length and radius are connected across the same potential difference. Conductor A has twice the resistivity of conductor B. What is the ratio of the power delivered to A to the power delivered to B? (a) 2 (b) 2 (c) 1 (d) 12 (e)12
The- pair of capacitors in Figure P28.63 are fully charged by a 12.0-V battery. The battery is disconnected, and the switch is then closed. Alter 1.00 ms has elapsed, (a) how much charge remains 011 the 3.00-F capacitor? (b) How much charge remains on the 2.00-F capacitor? (c) What is the current in the resistor at this time?
A circuit contains a D-cell battery, a switch, a 20- resistor, and three 20-mF capacitors. The capacitors are connected in parallel, and the parallel connection of capacitors are connected in series with the switch, the resistor and the battery, (a) What is die equivalent capacitance of the circuit? (b) What is the KC time constant? (c) How long before the current decreases to 50% of the initial value once the switch is closed?
If the terminals of a battery with zero internal resistance are connected across two identical resistors in series, the total power delivered by the battery is 8.00 W. If the same battery is connected across the same resistors in parallel, what is the total power delivered by the battery? (a) 16.0 W (b) 32.0 W (c) 2.00 W (d) 4.00 W (e) none of those answers
A student makes a homemade resistor from a graphite pencil 5.00 cm long, where the graphite is 0.05 mm indiameter. The resistivity of the graphite is =1.38102/m . The homemade resistor is place inseries with a switch, a 10.00-mF capacitor and a 0.50-V power source, (a) What is the BC time constant of the circuit? (b) What is the potential drop across the pencil 1.00 s after the switch is closed?
Semi-truck or trucks use four large 12-V batteries. The starter systemrequires 24 V, while normal operation of the truck’s other electrical components utilizes 12 V. How could the four batteries be connected to produce 24 V? To produce 12 V? Why is 24 V better than 12 V for starting the truck’s engine (a very heavy load)?
A capacitor of capacitance C = 1 μF has been charged so that the potential difference between its plates is V0 = 295 V. The capacitor is then connected to a resistor of resistance R = 11.5 kΩ. The switch S is closed, and the capacitor begins to discharge. Calculate the time T in s after which the charge on the capacitor has decreased to one fourth its maximum value.
A capacitor of capacitance C = 1 μF has been charged so that the potential difference between its plates is V0 = 295 V. The capacitor is then connected to a resistor of resistance R = 11.5 kΩ. The switch S is closed, and the capacitor begins to discharge. Calculate the potential difference VC in volts between the capacitor plates at time t = 5.0 ms after the switch is closed.
A 10 MΩ resistor is connected in series with a 1.0 μF capacitor and a battery with emf 12.0 V. Before the switch is closed at time t=0,the capacitor is uncharged. What fraction of the final charge Qf is on the capacitor at t=10s?
Switch S in in the figure is closed at time t = 0, to begin charging an initially uncharged capacitor of capacitance C = 17.2 μF through a resistor of resistance R = 21.2 Ω. At what time is the potential across the capacitor equal to that across the resistor?