Problem 8.18 5 of 19 Constants | Periodic Table A 0.40-kg ball is thrown with a speed of 7.0 m/s at an upward angle of 37°. Part A What is its speed at its highest point? Express your answer using two significant figures. Vtop = m/s Submit Request Answer • Part B Problem 8.18 5 of 19 Constants | Periodic Table A 0.40-kg ball is thrown with a speed of 7.0 m/s at an upward angle of 37 Part B How high does it go? (Use conservation of energy.) Express your answer using two significant figures. Hνα ΑΣφ Submit Request Answer Provide Feedback Next >

Problem 8.18 5 of 19 Constants | Periodic Table A 0.40-kg ball is thrown with a speed of 7.0 m/s at an upward angle of 37°. Part A What is its speed at its highest point? Express your answer using two significant figures. Vtop = m/s Submit Request Answer • Part B Problem 8.18 5 of 19 Constants | Periodic Table A 0.40-kg ball is thrown with a speed of 7.0 m/s at an upward angle of 37 Part B How high does it go? (Use conservation of energy.) Express your answer using two significant figures. Hνα ΑΣφ Submit Request Answer Provide Feedback Next >

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter7: Conservation Of Energy

Section7.1: Analysis Model: Nonisolated System (energy)

Problem 7.2QQ: Consider a block sliding over a horizontal surface with friction. Ignore any sound the sliding might...

See similar textbooks

Similar questions

Hi, can you please help me with this assignment A pendulum of length L. A ball that practically carries all the weightpendulum, has a velocity of velocity v1 at the moment when the cord makes an angle \phi_1 with the vertical direction.a) Derive the relation for the velocity of the ball at the lowest point of its trajectory (\phi = 0deg).What is the smallest possible value of velocity v1 for the pendulum tob) reach a position in which the massless cord is in horizontal position \phi=90deg,c) pass the highest point above the pivot so that the cord does not kink (\phi = 180deg+)? Thank You
This is a Dynamics of Rigid Bodies subject. Thank you. A projectile is launched upward at an initial slope of 4 vertical and 3 horizontal. The ground sloped downward such that the projectile hits the ground at a point 2 m lower than that of the origin. The maximum height of the flight is attained at a horizontal distance of 8 m away from origin. a. What is the initial velocity of the projectile?b. What is the total horizontal distance travelled by the projectile?c. What is the maximum height attained by the projectile measured from the origin?
Juan's teacher gives him three objects of equal volume and shape, but of different material,and asks him to drop them from his shoulder height and watch the fall time to the ground,from each of them. Juan observes that the three take different times to reach the ground,Even though all three are subjected to the same gravitational acceleration. Taking into accountthe above information, which of the following questions can be answered from theobservations made by Juan?A. Does the falling time of objects depend on the launch height?B. Is the gravitational force proportional to the mass of the objects?C. Is the net force acting on each of the objects different?D. Is the shape of objects related to differences in friction force?
You swing a 4.6-kg bucket of water in a vertical circle ofradius 1.3 m. (a) What speed must the bucket have if it is tocomplete the circle without spilling any water? (b) How doesyour answer depend on the mass of the bucket? Show your work and explain.
Consider a block sliding over a horizontal surface with friction. Ignore any sound the sliding might make, (i) If the system is the block, this system is (a) isolated (b) nonisolated (c) impossible to determine (ii) If the system is the surface, describe the system from the same set of choices, (iii) If the system is the block and the surface, describe the system from the same set of choices.
Consider a block sliding over a horizontal surface with friction. Ignore any sound the sliding might make. (i) If the system is the block, this system is (a) isolated (b) nonisolated (c) impossible to determine (ii) If the system is the surface, describe the system from the same set of choices. (iii) If the system is the block and the surface, describe the system from the same set of choices.
Assume that the board you used was covered with two materials, material 1 and material 2. If the height where the wooden block started to slide down is higher on material 2 than on material 1, what can we say about the μs and μk associated with material 2 as compared to material 1? a. μs and μk on material 2 is higher than on material 1b. μs and μk on material 1 is higher than on material 2c. μs on material 2 is higher than on material 1, but μk material 1 is higher than on material 2d. μs on material 1 is higher than on material 2, but μk material 2 is higher than on material 1e. Regarless of any height, μs and μk is same on material 1 and material 2
A 0.300-kg block along a horizontal track has a speed of 1.60 m/s immediately before colliding with a light spring of force constant 5.25 N/m located at the end of the track. (a) What is the spring's maximum compression if the track is frictionless? If the track is not frictionless, would the spring's maximum compression be greater than, less than, or equal to the value obtained in part (a)?
Three uniform spheres are fixed at the positions shown in (Figure 1). What is the magnitude of the force on a 0.0150 kg particle placed at P? Express your answer with the appropriate units. Determine the direction of this force measured counterclockwise from the positive x axis. Express your answer in degrees. If the spheres are in deep outer space and a 0.0150 kg particle is released from rest 300 m from the origin along a line 45∘ below the −x-axis, what will the particle's speed be when it reaches the origin? Express your answer with the appropriate units.
a) Given the following ideal Atwood machine in an elevator accelerating down at ae = 4.9 m/s2, with m1 = 10 gram (two nickels) and m2 = 5 gram (one nickel) as shown, what is the tension T in the string in millinewton (mN)? (Hint: the upward arrow on ae is correct and just means use "positive is up" conventions for the elevator itself, so here we have ae = -4.9 m/s2 to be put into Einstein's rule that we discussed.) b) Exact same Atwood machine as the previous problem (two nickels and a nickel in an elevator accelerating down at 4.9 m/s2), but now how much time (s) does it take m1, starting from rest, to fall 25 cm relative to the inside of the elevator? I labeled it a and b because they are connected to each other. Please help, thanks!
For the cube from problem 1, instead of having a person push the cube, we are going to attach a spring to it. The box is pulled to compress the spring 50 cm, then released. If the stiffness of the spring is 500 N/m, what acceleration will the cube experience? b. Now, we will move the cube and spring device to a smooth, tile floor, and we will place the cube on wheels. This will lead to some, non-negligible amount of friction. If the coefficient of static friction between the wheels and the floor is 0.07, what acceleration will the cube experience? Replace the single, large cube from the previous problems with two smaller cubes with the masses 5 kg, and 10 kg. Now we're back on the ice. The two cubes are side-by-side. Now a person pushes on box 1 with a force of 50 N at an angle of 30°. What is the acceleration of the boxes?
The height of a ball is thrown straight up sith a certain force is a function of the time (t) from which it is released given by f(t)=-0.5gt2+40t (where g is a constant determined by gravity). a. How does the value of t at which the height of the ball is at a maximum depend on the parameter g? b. Use your answer to part (a) to describe how maximum height changes as the parameter g changes. c. Use the envelope theorem to answer pare (b) directly. d. On the Earth g=32, but this value varies somewhat around the globe. If two locations had gravitational constants that differed by 0.1, what would be the difference in the maximum height of a ball tossed in the two places?