Q-1) Solve for y(t) for the following system represented in state space, where u(t) is the unit step. -2 1 01 1 u(t) y = [0 1 1] x; x(0)= + %3D 0 -6 -5

Q: V1 v2 R1 R4 1ka зка 5.0v -15V R2 Ska R3 Fig 2

A:

Q: Analyze the output voltage Vo in the network efficiently for triangular input signal Vi shown in Fig...

A:

Q: -Write short notes on the following : (i) Advantages of JFET Difference between MOSFET and JFET (ii)

A: JFET-JFET stand for junction field effect transistor.It  is  like as normal FET. The types of JFET a...

Q: Solve Problem 8. Using a Program Excel Problem 8. Use Newton's method to find the positive root of: ...

A: Note : Program excel is software based so i am solving the question by Newton;s method which also me...

Q: 3. Consider a bridge rectifier circuit which is fed by a sinusoid input, Vs with 1.5kN load, whose i...

A:

Q: If kr = Eripplerms/Eave, %3D determine kr of the given waveform. 2Vp-p 10v

A:

Q: When there are in the power system, the voltage regulators will come into action to prevent instabil...

A: In the power system, the voltage regulators are come into the action to prevent instability due to v...

Q: 40 mH (15.1 2) am 120 uF 120 LO Rms 10 2 (-j22.1 Q)

A: Steps to find the power in the complex circuit, Find the equivalent impedance of the circuit Then f...

Q: 25 V 45 V 3 k2 4 kQ d. 5 k2 Figur 5

A:

Q: The open circuitt voltage external to R2 in the figure shown is

A: This question belongs to circuit theory . It is based on the concept of kirchhoff's voltage law and ...

Q: What are the two primary types of uninterruptible power supplies?

A:

Q: X1(s) X2(s) and F2(s) F1 (s) for the system shown below. Q2. Obtain the transfer functions F2(t) m2 ...

A: Given,

Q: tance oI the 50 L 18 24 26 r Ree 122

A:

Q: 2 k 6 V 1 k 2 mA 4 mA 12 V 2 kN 31 kN 1 k. 1 kn Vo ww

A:

Q: Use (C1) polarized capacitor. Provide one battery rated 9v, Connect one end of switch 1 to the posit...

A:

Q: R= ??? 2 I= 10A 2 V= 20V 200 Ohms 0.2 Ohms 2 Ohms 20 Ohms

A:

Q: Assume you want to decode the binary number 0011 with an active high output decoder. The missing gac...

A: Given circuit, Input is 0011 A3=0A2=0A1=1A0=1  

Q: Find the voltage gain, input and output resistances of the circuit

A: Transistor- A device which is used as a switch and as a voltage or current regulator in the circuit.

Q: In a pulse code modulation system, a message signal m(t) = 3.6cos(2n x 7.6 x 10°t) is sampled at Nyq...

A:

Q: An 8x1 MUX has inputs A, B, and C connected to the selection inputs S2, S1, and S0, respectively. De...

A: Eight data inputs D0 through D7, three input select lines S0 through S2, and a single output line Y ...

Q: -30 V Is 5 A 2 A R3=10 0 R2 R3

A:

Q: A 10-bit 5-V ADC operates with a sampling frequency of 1 MHz. If a linear histogram test is to be co...

A: Given data, Number of bit n = 19. Reference voltage Vr=5 V

Q: For the given circuit, which among the choices is a correct expression for V? 102 + Vs 1) Is 402 V S...

A:

Q: O[1] For the following CT signal, determine whether it is periodic or aperiodic. If periodic, find t...

A: Given signal  x(t) = 2cos(6πt) + 3sin(4πt + π/3)              +cos(8πt) We need to check whether it ...

Q: reee Vict) QH 1 Find te sansfer funciun V(S) using Vics) nodal method.

A:

Q: Consider a simple pendulum (mass m, length l) whose point of support is forced by some external mech...

A: Solution- On the horizontal axis-   x=Rcosθ+lsinϕ    put   θ=ωt,x=Rcosωt+lsinϕ  ......................

Q: SDraw the circcir 3 phase l 3¢) equivalent of the 5 Stage power sysrem ?2 * Nore the line is TI-Mode...

A: Power system: Power system deals with the power generation, transmission, and distribution to end-us...

Q: 20.A. If the light transmission characteristics of a fiber's cladding are important, which of the fo...

A: The solution is given below

Q: Consider four resistors in parallel connection: R1 = 3520.45 Q, R2 = 33.09 Q, R3 = 1484.22 Q and R4 ...

A: We know that whatever 3 resistors are connected in parallel there equivalent resistance is given as ...

Q: List twenty farming operations requiring electrical power. Discuss the advantages and disadvantages ...

A: Electricity- Flow of electrons from region of high concentration (aka high potential or high voltage...

Q: Q5. A 50 Hz sinusoidal volt is applied consisțirg! of Lomputa ) the following @) tffective valde S p...

A: Disclaimer:  Since you have asked multiple questions, we will solve the first question for you. If y...

Q: The figure shows an electric circuit which contains a double switch labelled by S. When the switch i...

A: Given Switch at 11'  ,  II=6 A Switch at 22'  ,  III=6 A Switch at 33'  , ammeter reading ?  

Q: 12/0* v 10 10 ww 10 2/0 A A

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Consider the circuit given below with R = 5k2 and Vcc = 12V. %3D The input signal is (Vs= 25 sin wt ...

A: The circuit diagram is shown below, Where,R=5kΩVcc=12VIo=0.5mAVs=25sinωt mVVD=0.7V

Q: Given that Vin 110Z30° V find Van and Ven assuming a positive (abc) sequence.

A: The solution is given below 

Q: 1. Three impedances Zı = 1– j4 , Z2= 0 – j6 and Z3 = 4 + j3 ohms respectively are connected in serie...

A: This question belongs to circuit theory . It is based on the calculation of equivalent impedance of ...

Q: Motors from two different manufacturers are being considered. Motor A is 45hp and Motor B is 60hp, b...

A: For motor A-Power = 45hpVoltage =460VPhase =3Frequency=60HzEfficiency=80%Motor life=20 yearsCosts =P...

Q: A particle with a mass of 2.0 x 10^-5 kg and a charge of +2.0 µC is released in a (parallel plate) u...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Find V, using superposition theorem. -j42 j5 2 ww 10/0° V 3/0° A

A: Given Superposition system:The response produced at an element when all rthe sources are present is...

Q: Problem 4: Assuming that the numbers below are signed 2's complement numbers with the leftmost bit r...

A: The solution is given below

Q: In the balanced three phase power measurement using two wattmeter method, each wattmeter reads 24 kW...

A: We have given the following problem

Q: Given a vector field F=(y+1)ax + xay, determine a) F at P1(-3,2,-4) and b) the unit vector defining ...

A:

Q: A PMMC frame has 0.4 m2, 50 number of winding around the coil and flux of 0.30 Wb/m2 = T or Tesla (T...

A: In this question,  If number of turn N= 50 Area = 0.4m2  Flux = 0.3wb/m2   If current flow in then f...

Q: If in a house there is a power board and a fan two bulb how you will conccet all the item with the p...

A: The following items must be connected in order for it to be easily operated manually. Number of Bulb...

Q: Find the force on a point charge of 30µC at (0, 0, 5)m due to a 4m square in the z=0 plane between x...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Stability of a system was defined in the lecture and in section 2.2.5 of the text, and it was shown ...

A: For any system to be stable the integration of h(n) should be less than infinite .

Q: Convert 1000 W into its equivalent mechanical horsepower.

A:

Q: A common bus system which is capable of transferring 8 bits at time with number of registers are 4 a...

A: Given, The total number of registers is four. Each register has an 8-bit value. The common bus sends...

Q: 18. A delta connected system has a line voltage of 220 volts and a line current of 100 Amperes. Draw...

A:

Q: +15V R4 560 Q R1 1ka R3 9100 VZR: 3V R2 3 2ka - 8V

A: The solution is given below. 

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.