Q.1 Find the solution of following ODE by Laplace transform of the function x( t ) and Ca(t) that satisfies the differential equation and initial conditions. (b) 3²x+2.5 x - x = 2 dt² dt at x(0) = 1

Q: An isochoric process, also called a constant-volume process, an isovolumetric process, or an…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which…

Q: X 1. The exothermic reaction A→B+C was carried out adiabatically. The entering molar flow rate of A…

A: 1) The reaction given is A → B + C The molar flow rate of A is FAo = 300 mol/min a) For conversion…

Q: A furnace burns 10 kg/s of fuel oil (C = 86%, H = 10%, S = 4%). Measurements carried out at the base…

A: Given, The mass flow of fuel oil is 10 kg/s. The mass% of C, H and S are 86%, 10% and 4%…

Q: Determine the heat of formation of sulfuric acid, H₂SO4(1), from the following thermochemical…

A:

Q: An evaporation-crystallization process

A:

Q: Heat Loss from a Furnace. Two horizontal metal plates having dimensions of 0.8 x 1.0 m comprise the…

A: Dimensions of plate is 0.8×1 Temperature of lower plate T1 = 400 oC…

Q: Can you as well solve e) f) d) please?

A: (d) Given that- to find the rate of heat transfer for the heating load in kJ/h. The equation for…

Q: Water contained in a piston-cylinder assembly, initially at 300°F, a quality of 70%, and a volume of…

A: The internal energy is calculated at each state. The amount of mass is obtained from volume and…

Q: Consider the equilibrium reaction H2O H2 + 0.5 O2, at 1 atm and 298K. The mass fractions of H2O. H2…

A:

Q: The mole fractions of the main components of dry air at sea level are ??2 = 0.78, ??2= 0.21, ??? =…

A:

Q: -3 The purchased and installation costs of some pieces of equipment are given as a function of…

A: Given that the cost of the equipment is a function of weight rather than capacity.  The cost of the…

Q: A water solution contains 90.0 g of glucose, C6H12O6. It has a density of 1.10 g/cm³ and a total…

A:

Q: Knowing that: in linear polymers the individual polymer chains rarely have the exact same degree of…

A:

Q: Calculate the pressure exerted by Ar for a molar volume 0.39L at 265K using the van der Waals…

A: The Vanderwaal equation of state is for real gases. One of the parameters explains the interaction…

Q: 10. Given the following analysis: Producer Gas CO₂ C₂H4 со H₂ CHA N₂ Compute the percent of the…

A: Given, The composition of Producer gas is 9.2% CO2, 0.4% C2H4, 20.9% CO, 15.6% H2, 1.90% CH4 and…

Q: Device produce from natural gas by methane steam reforming hydrogen (efficiency of MSR 75%). Fuel…

A: Methane reforming by steam is a endothermic reaction. Hydrogen is used in fuel cell which produces…

Q: Q7] Two specimens of paraffin having densities 2.144 g/cm³ with crystallinity ratio 51.3% and 2.215…

A:

Q: The minimum temperature at which * hydrocarbon vapor when mixed with air can spontaneously ignite…

A: It is required to determine the minimum temperature at which hydrocarbon vapor when mixed with air…

Q: Assume that the permeability of oxygen in the alveoli is P=4x10-8 cms-1. The P O2 in alveolar air is…

A:

Q: A liquid film of constant thickness L flows down an inclined wall that makes an angle with the…

A: Given, The liquid film has thickness= L Make necessary assumptions and then do the shell momentum…

Q: Two isomeric forms of a saturated hydrocarbon Have a different content of the isotopes of hydrogen.…

A: Given that there is two isomeric forms of a saturated hydrocarbon then we have to identify which…

Q: C₁=C₂₁ (929) [1-a (25)] + The schematic diffusion profile in Figure 5.13 shows these concentration…

A: Given data: Temperature = 1000 0C Distance = 15 µm Pre-exponential factor = 2.3 × 10-4 m2/s…

Q: The concentration of BDE-47 (MW = 486) in Orono wastewater was 0.3 ppb. The Henry's Law constant for…

A: Given data: Concentration of BDE-47 in wastewater = 0.3 ppm Concentration of BDE-47 in air = 0.05…

Q: Two thousand kilograms of a 94% NaNO3 solution in water is at a temperature of 1000C. This is sent…

A:

Q: PROBLEM 1 Given the following cases for water, fill in the missing information: diagram region (2…

A: (C) Given  P = 5 bar  = 500 KPa v = 0.52 m3/kg Given

Q: Given the following reaction and concentration of reagents and product from time 1 to time 4 A + B →…

A: Note: We are authorized to provide the typed answers. Please follow the provided solution.…

Q: Which of the following compounds is called 18-Crown-6? A B 0 C

A:

Q: For the circuit below : RL =) Determine the range of R₂ and I that will result in VR being…

A:

Q: Which reagents will achieve the following transformation? OH O 0 conc. H₂SO4 heat PCC conc. H₂SO4…

A:

Q: A large deep lake, which initially had a uniform oxygen concentration of 1 kg/m3, has its surface…

A:

Q: Specific volume=0.904 L/kg Isothermal compressibility = 7.45 x 10-5 bar¹ Volume expansivity=0.94 x…

A: Given data: Specific volume of chlorobenzene = 0.904 L/kg Isothermal compressibility = 7.45 × 10-5…

Q: Assuming the validity of Raoult's law, do the calculations for the acetone(1)/tert-butanol (2)…

A: Dear Subscriber! We have answered the first three subparts as per our authoring guidelines. Please…

Q: The decanted sludge of 20,000 kg/h contains 5 weight % water, 10 weight % zinc sulfate and the…

A: INTRODUCTION - Target compounds in a solid raw material are leached by solvents in a process known…

Q: 3. The heat capacity of sulfur is Cp= 15.2 +2.68T where Cp is in J/(g- mol K and T is in K, Convert…

A: Given that Cp=15.2+2.68T here Cp is in J/(g-mol K) then Cp can be written as  Cp=15.2Jg-mol…

Q: Q3: The parallel piping gas system shown below is designed for flow rate of 3x10 m/day. BC DE AB is…

A:

Q: The vapour pressure of water (kPa) is represented by the equation log ps +B-e-20(7,-6)² T where A =…

A:

Q: Write two ways by which you can prove that the reaction is a composite reaction, not an elementary…

A: Number of ways, to prove that the given reaction is elementary or not, are to be outlined.

Q: FR&B 3.32. A mixture of methane and air is capable of being ignited only if the mole percent of…

A: Given that- For basis air- methane mixture feed= 1 mol Mol of methane in mixture= 9 mol % = 0.09 mol…

Q: in a job shop operation, four jobs may be performed on any of four machines. The hours required for…

A: The hours required for each job on each machine are presented in the following table as JOB…

Q: blood serum sample is analyzed and round to contain ug of the serum is 1053 kg/m³; AW Ca= 40.08.…

A:

Q: Badly need help pls. Use a tolerance value of 1 x 10-2 for your calculations. Do not use excel.

A: Note:  Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the…

Q: The time it takes to bake a bread at 120°C is 25 min. The same bread can be baked only in 360 s in…

A:

Q: the cell: pt / H₂ (latim) / NaOH cm) / HgO cs) / Hg = 0.924V 0.854 V and Егадк Calculate standard…

A:

Q: A Zamboni in Edmonton's new ice hokey arena emits carbon monoxide at a rate of 8.38 mg/s. The arena…

A:

Q: If you were to analyze your distillate by GC, you might notice a trace amount (<0.05%) of methanol.…

A: Introduction Moonshine, also known as "hooch" or "homebrew," is made by fermenting a sugar source to…

Q: A homeowner uses 2471 m3 of natural gas in a year to heat a home. Assume that natural gas is all…

A: Given that, Volume of methane CH4 V = 2471 m3 Pressure P = 1.3 atm Temperature T = 25.2oC = 25.2 +…

Q: Q4: Calculate the gas film coefficient (kg) and (ky) for the absorption of sulfur dioxide SO₂ from a…

A:

Q: Predict the value of DAB for the system CO-CO₂ at 296.1K and 1.0 atm total pressure.

A:

Q: 1 mole of CO₂ is expanded from 50 bar to 1 bar in a piston-cylinder arrangement. Assume the…

A: Given data: Number of moles of CO2 = 1 mol Initial pressure =50 bar Final pressure = 1 bar…

Q: If the tank was actually pressurized such that the top surface of the milk was at a pressure of…

A: Given Bottom pressure=40kPa Top pressure=110kPa SGmilk=1.030 Find Actual height of milk in the…