Two thousand kilograms of a 94% NaNO3 solution in water is at a temperature of 1000C. This is sent to a crystallizer where it is cooled to 300C. At this temperature, the solubility of NaNO3 is 86 g of NaNO3 per 100 g of water. Draw the process diagram. Calculate the amount of crystals that precipitate if 8% of the original water evaporates during cooling

Q: Can you please show the complete solution for these

A: The atmospheric pressure is considered to be entering from the right side pipe. The pressure can be…

Q: 4): An atmospheric flow tank use to storage crude oil (s.gr 0.86) has working capacity 12000 m³,…

A:

Q: Name major three classes of column packings and give a currently-popular and an obsolescent example…

A: To  a. three major three classes of column packings  b. give a currently-popular and an obsolescent…

Q: Calculate the mass flux (kg/m2-s) for the following tank leaks given that the storage pressure is…

A: Introduction The rate of mass flow is referred to as mass flux in physics and engineering. kg/m2sare…

Q: 4. What is the normality of a solution containing 8.5 g of H2SO4 (MW-98.08) to make 500 ml solution?

A: Mass of H2SO4 = 8.5 g Molecular Weight of H2SO4 = 98.08  The volume of Solution =500 ml = 0.5 L…

Q: There is a laminar flow of petroleum with Reynolds number equal to 1900 (s = 0.895; μ = 8.3x10-4…

A:

Q: 7.6. A gas enters a converging nozzle at pressure P₁ with negligible velocity, expands…

A: A conduit that is most suitable for the isentropic flow can be termed the nozzle. There are two main…

Q: 3. What is the meaning of the phrase "tare the mass of a piece of weighing paper?"

A:

Q: An oil has a kinematic viscosity of 2 x 10 m²/s and a density of 0.8 x 10 kg/m³. If we want to have…

A:

Q: Q3: The parallel piping gas system shown below is designed for flow rate of 3x10 m/day. BC DE AB is…

A:

Q: A Zamboni in Edmonton's new ice hokey arena emits carbon monoxide at a rate of 8.38 mg/s. The arena…

A:

Q: Example (2): - Nicotine (C) in a water (A) solution 1% is to be extracted with kerosene B at 20°C,…

A:

Q: The average human adult has 0.18 Ibm of potassium distributed in his body. One isotope of 40…

A:

Q: A stack gas from a combustion reaction is given off of a furnace which contains mole fractions of…

A:

Q: What is specific objective for Sewage Water Treatment to produce electricity.

A: Right Now, 90% of Sewage Water are Flowing Open. This sewage water have 8-12% Methane in it. This…

Q: 1. The pressure difference between two air tanks A and B is measured by a U-tube manometer, with…

A:

Q: Assuming the validity of Raoult's law, do the calculations for the acetone(1)/tert-butanol (2)…

A: Dear Subscriber! We have answered the first three subparts as per our authoring guidelines. Please…

Q: Q7] Two specimens of paraffin having densities 2.144 g/cm³ with crystallinity ratio 51.3% and 2.215…

A:

Q: Condensation of Steam on Vertical Tubes. Steam at 1 atm pressure abs and 100°C is condensing on a…

A: The average film temperature is, Tf = 100+97.782Tf = 98.89oC The average heat transfer coefficient…

Q: A liquid combination of 50% mole n-butane and 50% mole n-pentane was pressed to a total pressure of…

A:

Q: pressure in the oil at point A.

A:

Q: Steam enters an adiabatic turbine at 1.2 MPa and 451 °C and leaves at 129 °C with a quality of 44…

A: Given  Adiabatic turbine with Intel pressure P = 1.2MPa Intel temperature of turbine T = 451 oC At…

Q: Which of the following is sulphur compound.

A:

Q: Chemical engineering exercise 2.1  Estimate the heat loss per m² of surface area for a furnace wall,…

A:

Q: 1. What are the differences and similarities of measuring and transferring pipettes? 2. When do you…

A: 1) The differences and similarities between a measuring and a transferring pipette are as follows:…

Q: Sulphur dioxide is circulated as refrigerant in a small refrigerator. SO2 gas at a  pressure of 5…

A: Introduction  Ideal gas equation provides the relationship between Temperature , pressure , volume…

Q: I am trying to decide thesis topic for chemical engineering. Help me find thesis topic related to…

A: Chemical Engineering is known to create Valuable Products from waste.

Q: What is the value of g is it 9.8 m/s?

A: Given: h1 =  2 cm = 0.02 m  h2 = 86 cm = 0.86 m Barometric pressure = 700 mm   we know that,…

Q: 1. Liquid A(sp gr = 1.13) at a temperature of 27°C is flowing at a rate of 181gal/min in a pipe with…

A: For a detailed solution, please see the attached files.

Q: A 5.8734 g sample of beef was analyzed for its N content and the liberated NH; was collected in a…

A:

Q: 4. Let us consider a process flow diagram describing the water conditioning setup for a salt- water…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Given the following reaction: 24+6B →2C+6D ,if 5 moles of A and 10 moles of B enter the reactor,…

A: Given reaction is: 2A + 6B →2C + 6D Given data are: Initial number of moles of A = 5 moles Initial…

Q: Write two ways by which you can prove that the reaction is a composite reaction, not an elementary…

A: Number of ways, to prove that the given reaction is elementary or not, are to be outlined.

Q: B) The coefficient of isothermal compressibility is defined as: KT = -(5) and the coefficient of…

A: Given, The expressions for coefficient of isothermal compressibility and coefficient of thermal…

Q: 8.29 Two streams containing pyridine and acetic acid at 25°C are mixed and fed into a heat…

A:

Q: Urgent solution required

A: The pressure at which standard boiling conditions are present is considered and the given boiling…

Q: Heat Loss from a Furnace. Two horizontal metal plates having dimensions of 0.8 x 1.0 m comprise the…

A: Dimensions of plate is 0.8×1 Temperature of lower plate T1 = 400 oC…

Q: 15 A cylindrical workpiece is forged in an open die. The workpiece is 60 mm in diameter and 30 mm…

A:

Q: Chemical compounds composed of carbon and hydrogen atoms bonded to one of the inorganic atoms are…

A: ASKED Chemical compounds composed of carbon and hydrogen atoms bonded to one of the inorganic atoms…

Q: What is main objective for Sewage Water Treatment to produce electricity

A:

Q: For the vertical pipe with manometer attached, as shown in Fig. 2-19, find the pressure in the oil…

A:

Q: What is the net force exerted on each bolt holding the end cap in place? force: lbf

A:

Q: A differential manometer is shown below. Calculate the pressure difference between points A and B in…

A: For a detailed solution, please see the attached files.

Q: Predict the value of DAB for the system CO-CO₂ at 296.1K and 1.0 atm total pressure.

A:

Q: What is specific objective for Waste Vegetable Treatment to produce electricity

A: The overall objective for the assessment carried out for waste management is described below: a) To…

Q: i need the answer quickly

A: One of the processes of heat transfer is convection. This heat transfer moves in the fluid's bulk…

Q: The following ratios make up an inert gas mixture: 80% N2, 15% CO2, and 5% Ar. The gas is injected…

A:

Q: 7. A Carnot engine is coupled to a Carnot refrigerator so that all of the work produced by the…

A: The hot and the cold temperature for the engine given are: TH = 250oC = 523.15 K TC= 25oC = 298.15 K…

Q: Calculate the enthalpy change to take liquid water from 100 kPa and 25 °C to superheated steam at…

A: It is given that liquid water initially at 100kPa and 25oC is changed to superheated steam at 100kPa…

Q: In the concentration of fruit juices, a portion of the feed is redirected to bypass the evaporator…

A: