Q.12. The two structural members, one of which is in tension and the other in compression, exert the indicated forces on joint O. Detemine the magnitude of the resultant R of the two forces and the angle 0 which R makes with the positive x-axis.

Q.12. The two structural members, one of which is in tension and the other in compression, exert the indicated forces on joint O. Detemine the magnitude of the resultant R of the two forces and the angle 0 which R makes with the positive x-axis.

Name: Q.12. The two structural members, one ofwhich is in tension and the o
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Q.12. The two structural members, one ofwhich is in tension and the other incompression, exert the indicated forceson joint O. Detemine the magnitude ofthe resultant R of the two forces and theangle 0 which R makes with thepositive x-axis.3 kN2 kN33

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.127P: When suspended from two cables, the rocket assumes the equilibrium position shown. Determine the...

See similar textbooks

Similar questions

When suspended from two cables, the rocket assumes the equilibrium position shown. Determine the distance x that locates G, the center of gravity of the rocket.
4. The block shown is acted on by its weight W=400 lb, a horizontal F=600 lb, and the pressure P exerted by the inclined plane. The resultant R of these forces is parallel to the incline. Determine the values of P and R.
A 50 kg load is lifted by the pulley system shown. Determinethe tension in the cable ABC and the angle θ.
The angle between spring AC and the post DA is 30°. Knowing that the tension in the spring is 40 lb, determine (a) the x, y and z components of the force exerted on the circular plate at C, (b) the angles θx, θy, and θz defining the direction of the force at C.
Pulleys A and B are mounted on bracket CDEF The tension on each side of the two belts is as shown. Replace the four forces with a single equivalent force, and determine where its line of action intersects the bottom edge of the bracket.
A wall section of precast concrete is temporarily held in place by the cables shown. If the tension is 840 lb in cable AB and 1200 lb in cable AC, determine the magnitude and direction of the resultant of the forces exerted by cables AB and AC on stake A.
If the resultant of the forces shown passes through point A, determine the magnitude of the unknown tension T2 which acts on the braked pulley.
calcualte the horizontal force F that should be appliedto the 100 lb weight shown so that the cable AB is inclined at an angle of 30° with the vertical.
The homogeneous 40-kg basr ABC is held by a horizontal rope attached to end C. Neglecting friction, determinethe tension in the rope.
Determinethe magnitude (lb) of the horizontal component of force at point C if P = 150.5 lb, x = 13.6 in, y = 6.8 in, and z = 8.3 in.
A block of Weight G is hanged over the two bars 1 and 2 and supported by hanger 3. If the resultant of the forces in all directions are zero, determine the bar forces of members 1,2, and in terms of G.
Rod AD is acted upon by a vertical force P at end and by two equal and opposite horizontal forces of magnitude Q at points B and C . Neglecting the weight of the rod, express the angle 0 corresponding to the equilibrium position in terms of P and Q.