Q.2 (c) A homogeneous anisotropic embankment dam section is shown in the figure, the coefficient of permeability in the x and z directions being 5 x 10-8 and 2 x 10-8 m/s respectively. Construct the flow net and determine the quantity of seepage through the dam What is the pore water pressure at point 'P'? 15 m 2.5 m 2.5 m 1 5.5 m 45 m- 15.5 m w 0z w 81

Q.2 (c) A homogeneous anisotropic embankment dam section is shown in the figure, the coefficient of permeability in the x and z directions being 5 x 10-8 and 2 x 10-8 m/s respectively. Construct the flow net and determine the quantity of seepage through the dam What is the pore water pressure at point 'P'? 15 m 2.5 m 2.5 m 1 5.5 m 45 m- 15.5 m w 0z w 81

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter7: Seepage

Section: Chapter Questions

Problem 7.7CTP

See similar textbooks

Similar questions

For the two-dimensional flow system shown below (units in meters):Compute the total flow rate under the Dam. X = 4, Y = 8. Note 1: Point A is located in the middle point of the equipotential lines. Point B is located in the middle point of the flow lines.Note 2: Assume e=0.8 (void ratio) and k=10^-3 cm/s (coeff. of permeability).Note 3: Datum is located at the bottom level of the water (right side of Dam).Note 4: Remember, the figure is drawn to scale. So, use the value of 2X+Y to estimate any dimension that you consider necessary.
For the concrete Dam shown in figure, determine the total average seepage for the given permeable strata by drawing Flow Net. The detail dimensions are given on the figure. The head of water on upstream side is 6ft and on downstream side is 1ft. Assume of Nf= 3, Nd= 6 and rectangular flow elements
Q#3 : For the concrete Dam shown in figure, determine the total average seepage for the given permeable strata by drawing Flow Net. The detail dimensions are given on the figure. The head of water on upstream side is 6ft and on downstream side is 1ft. Assume of Nf= 3, Nd= 6 and rectangular flow elements. Use paint or graph paper
Q#4 : For the concrete Dam shown in figure, determine the total average seepage for the given permeable strata by drawing Flow Net. The detail dimensions are given on the figure. The head of water on upstream side is 6ft and on downstream side is 1ft. Assume of Nf= 3, Nd= 6 and rectangular flow elements. Use MSpaint or graph paper
A 0.34 m diameter well fully penetrates an unconfined aquifer which is 33.2 m thick. The drawdown at the pumping well is 1.34 m and the permeability of the gravel aquifer is 4.32 * 10-3 m/s. If the flow is steady-state and the discharge is 422.3 lt/min, a- find the drawdown at the site 132.4 m from the center of the pumping well, b- determine the radius of influence ‘r∞’ of this well under that discharge.
A well with a diameter of 18 in. penetrates an unconfined aquifer that is 100ft thick. Two observation well are located at 100 ft and 235 ft from the well, and the measured drawdownsare 22.2ft and 21ft, respectively. Flow is steady and the hydraulic conductivity is 1400 gpd/ft^2. What is the steady-state rate of discharge from the well?
CALCULATION USING DARCY'S LAW An aquifer system is formed by two horizontal layers. Two piezometers were installed for monitoring, the distance between them is 885m. The upper layer (A) has a thickness of 39m and K = 1.3 x 10-5 m/s and the lower layer (B) has a thickness of 25m and K = 2.7 x 10-6 m/s. THE hydraulic load in the PZA is 60m and in the PZB it is 40m. Calculate the flow and the transmissivity of each layer.
Find the rate of flow in m3/sec/m through the permeable soil layer. Given: H = 5.5 m, H1 = 2 m, h = 3.5 m, S = 40 m, a = 17°, and k = 0.085 cm/sec.
A flow net for flow around a single row of sheet piles in a permeable soil layer is shown in the Figure below. Given that kx= kz = k= 5.5 x 10-3 cm/sec, H1 = 6.5 m and H2 = 2.3 m determine: i. How high (above the ground surface) the water will rise if piezometers are placed at points a and b ii. The total rate of seepage through the permeable layer per unit length iii. The approximate average hydraulic gradient at c
Use 10 kN/m3 for unit weight of water. For a concrete structure that retains water, a flow net is sketched as shown in Figure H8-3. Noting the marked location of the Datum, answer the following: Mark on the figure all boundary Also mark the type of each boundary. Calculate the uplift pressures at points A, B, C, D, E, and F. Calculate the factor of safety against The seepage loss (q) per day per meter length of the (i.e. q in m3/day/m) if the permeability of the soil is k = 10-4 m/sec.
A double wall sheet pile coffer dam retains a height of water 9 m on one side. A flow net constructed for this structure, driven into a pervious deposit overlain by an impervious ledge, consists of five flow channels and fifteen potential drops. The length of the coffer dam is 90 metres.If the coefficient of permeability of the pervious deposit is 10^–2 mm/s determine the seepage in cubic metres per day. a. 621.4 m^3/s b. 946.5 m^3/s c. 101.0 m^3/s d. 233.3 m^3/s
Q- The wetted perimeter and cross-sectional area of a channel is 5 m and 9 sq. m respectively. What ois the hydraulic radius of the channel?