Answered: Problem 3 Determine the increase in…

Problem 3 Determine the increase in vertical stress at a depth of 2m in the soil below point A due to the foundation shown below. The load due to the foundation is 100 kN/m². А. 5m 2m

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter16: Lateral Earth Pressure

Section: Chapter Questions

Problem 16.4P: In Problem 16.3, if there was a surcharge of 20 kN/m2 at the ground level, what would be the total...

See similar textbooks

Related questions

Q: What concetrated load can be carried by a 250 x 250 mm beam if the length is 2000 mm and the modulus…

Q: 2. Calculate the actual work done on the 200 g mass using W = mgh. Be careful to use only the change…

A: The given data is: Mass=200 g The work done, W=mgh The work done to raise the mass to the C…

Q: please solve if uktimate tensile stregth is 800MPA. assume reliabilty of 98% fatigue fraction f of…

Q: Solve

Q: A bead moves along a circular wire. Its speed increases at as2t - 4m/s?, Its initial (at t=0)…

A: For the given bead,

Q: A centrifugal pump consists out of an impeller, diffuser and casing and is powered by 300 kW (shaft…

Q: at is the half-life of the radium?

A: Given:- amount of radium disappeared=0.5% number of years=12 To find:- a) what percent will…

Q: the bottom of said strata. The sand has a dry and saturated unit weight of 14 kN/m3 and 18 kN/m3 res

A: \

Q: A rectangular tank 10 m x 5 m in plan and 3 m deep is divided by a partition wall parallel to the…

Q: Explain and differentiate asphalt, bitumen and tar.

Q: nge percentage (%) fo

A: solution of above problem is below:

Q: The figure below shows the reinforced concrete beam AB of a tourist lookout at the free end. Its…

Q: O2 F D -3 ft 1.5 ft -4.5 ft-

Q: A storm with I1.5 cm precipitation produced a direct runoff of 5.0 cm The duration of the rainfall…

Q: Determine the force (P) required to prevent block from moving, given that us = 0.4 and uk = 0.23. F…

A: Given data, μs = 0.4 μk = 0.23 F1 = 803 unit θ = 33° To find out the force P required to prevent…

Q: The critical hydraulic gradient for a soil sample is equal to 1.01. If the specific gravity of the…

A: Given data, Critical hydraulic gradient Icr = 1.01 Specific gravity G = 2.67 To Find :- Void ratio e

Q: A 435-lb block is resting on a rough horizontal surface for which the coefficient of friction is…

Q: Find the value of phy-index of the storm?

A: W = P - QT { P = Precipitation, Q = Runoff, T = time} P = 14cm Q = 8cm T = 7hour

Q: A structural joint is formed as shown in the figure with the wood members connected by 16d common…

A: Solution:- From Table of Lateral Load Capacity of Common Wire Nail, we read a value of 141 lb per a…

Q: (d) 4 kN/m 2 kN/m |B C 2 m 3 m

Q: What must be the mass of block A if it is to descend 12 m in the first 3s after the system is…

Q: Groundwater ingress from a mine and contaminated water from an industrial plant is pumped into a…

A: Sodium concentration In this Ion-specific electrode (ISE) technology detects the physiologically…

Q: A ski jumper starts with a horizontal take-off velocity of V; = 20 m/s and lands on a straight…

A: Solution of projectile motion on inclined plane

Q: A cylindrical can is to be made to hold 1 liter of oil. Find the dimensions (in cm) that will…

Q: The rate of evaporation is mainly dependent on the following except for A wind speed B air quality C…

A: The rate of evaporation is directly proportional to the wind speed, more the wind speed more will be…

Q: 1. The incoming wind at 1 bar, 20 °C and 12 m/s is swept along a wind turbine of 2 blades of 50 m…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: 78 kN 66. kN -2 m I m

Q: O 01:13:23 Question 3 of 10 -/ 10 View Policies Current Attempt in Progress The two bars are used to…

Q: The critical hydraulic gradient for a soil sample is equal to 1.01. If the specific gravity of the…

Q: The uniform cross-section of a barge with a semi-cylindrical hull floating in water is shown…

A: Given: A barge with a semi cylindrical hull floating in water Required: To determine total mass of…

Q: You use the following distances for a peg test! AM = MB = 50.000 %3D PA = 5.000 If Enr is 0.026, E…

A: ASKED: To compute the error in the far reading of the peg test. Given, Distance AM = MB = 50.000…

Q: Alpha just stole a ball in a basketball game and intends to throw a pass to à teammate, Bravo, who…

A: Given Data: The speed of a Bravo is v=2.60 m/s.The height at which brave is to catch the ball is…

Q: (4) The cross-section of a road and gutter are shown below. The slope of the gutter and roadway is…

A: Triangular section slope 1:5 Depth 10 ft Width 50 ft Bed slope 1/400 Manning's formula Assume n =…

Q: -Compute for the TOTAL VOLUME of the STRUCTURAL CONCRETE for the given structure. NOTE: STRUCTURAL…

Q: 2. For the system shown below, compute the maximum torque it can accommodate if a is 2000mm and b is…

Q: -The cross-sectional area of one limb of a U-tube manometer is made 500 times larger than the other…

Q: In what ways do the essential building elements of manufacturing differ from one another?

A: Five types of manufacturing processes- 1)Repetitive Manufacturing-Basic manufacturing that creates…

Q: The shear force and bending moment diagrams for a cantilever beam are shown in the figure. Find the…

A: The change in bending moment between two points is equal to area under shear force diagram between…

Q: rect runoff of 8 cm. The time distribution of the storm A storm with 14 cm preciplta s as shown in…

Q: e Ps. The pneumatic lines have linearized resistances R1 and eumatic capacitances, C1and C2 for…

A: considering the two pneumatic system which is comprised of two rigid tanks of the volume V1 and…

Q: Q/ Design the rectangular duct system shown in figure below using equal friction method with…

Q: Proctor's compaction test for the maximum dry density of a certain soil gave the results as : 1.77…

Q: Determine the force (P) required to cause impending motion, given that us = 0.43 and µk = 0.25. F1 =…

A: solution - Given Data:- F1 = 506 Coefficient of static Friction = 0.43 Find, the value of P

Q: 10 ft long 6 × 10 simple beam of Douglas fir–larch, No. 2 grade, supports a uniformly distributed…

Q: in the figure below. Lo- pplied at the midpoint B or at the end of the beam C A, will depend on the…

Q: what would the DHV of the road be if the AADT were 40,000 vpd and assume a D of .65 and How many…

A: DHV = daily hourly volume vehicle/ hr DHV = AADT * K * D AADT = 40000 VEHICLE / DAY D = 0.65…

Q: -A storm with 14 cm precipitation produceda direct runoff of 8 cm. The time distribution of the…

Q: figure below shows the reinforced concrete beam AB of a tourist lookout at the free end. Its weight…

Q: Point A is a slotted connection that allows free vertical movement along the upper portion of member…

Q: What is the head loss in pipe due to friction over the length of 30 km, if the diameter of pipe is…

Concept explainers

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.

Question

0.26
0.24
2.0
E1.8
0.22
0.20
0.18
0.16
0.6
0.14
0.5
Is
0.12
0.10
0.08
0.06
0.04
En'=0.1
0.02
0.1
10.0

Problem 3
Determine the increase in vertical stress at a depth of 2m in the soil below point A due to the
foundation shown below. The load due to the foundation is 100 kN/m².
A.
5m
2m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1to find the increase in vertical stress

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A circular foundation 12 ft in diameter imposes a pressure of 8,000 psf onto the soil. At the 12-ft depth, determine the vertical stress increase beneath the center and the edge of the loaded area, assuming:(a) the Westergaard conditions apply.(b) the 60° approximation.
A 4.5m square foundation exerts uniform pressure of 200kn/m^2 on a soil . Determine 1:the vertical stress increment due to the foundation load to adepth of 10 m below its centre 2: the vertical stress increment at apoint 3m below the foundation and 4m from its centre along one of the axes of symmetry
A 4.5m square foundation exerts a uniform pressure of 200kPaon a soil. Determine(i) The vertical stress increments due to the foundation load to adepth of 10 m below its center and(ii) The vertical stress increment at a point 3m below thefoundation and 4m from its center along one of the axes ofsymmetry.
Calculate the settlement due to volume distortion in a clay where a rectangular-shape (flexible category) foundation 6 ft by 12 ft imposes a total loading of 220 kips. The layer of saturated clay (cohesion c is 1,500 psf) extends 12 ft deep and is underlain by rock.
A square foundation of (5m x 5m) is to carry a load of 4000KN.calculate the vertical stress at a depth of 5m below the center of the foundation. IN=0.084 for m=n=0.50 Also, determine the vertical stress using the 1:2 distribution method.
The excavation 3 × 6 m for a foundation is to be made to a depth of 2.5 m below ground level in a soil of bulkunit weight = 20 kN/m3.What effect this excavation will have on the vertical pressure at a depth of 6 m measuredfrom the ground surface vertically below the centre of foundation? The influence factor for m = 0.43 and n = 0.86 is 0.10.
A 4.5 m square foundation exerts a uniform pressure of 200kN/m2 on soil. Determine; i. The vertical stress increments due to the foundation load to a depth of 10m below its center. ii. The vertical stress increment at a point 3m below the foundation and 4m from its center a long one of its axes of symmetry.
How should the groundwater table move to have an effective stress of 95kPA, 2m from the bottom of the profile? For specific gravity, Gs = 2.68.
A rectangular footing 6 x 3 m carries a uniform pressure of 300 kN/m2 on the surface of a soil mass. Determine the vertical stress at a depth of 4.5 m below the surface on the center line 1.0 m inside the long edge of the foundation.
A circular area having a radius of 3 m carries a uniformly distributed of 90 kPa is applied to the ground. Compute the total vertical stress in kN/m^2 increment due to this unifrom load if the unit weight of soil is 18.40 kN/m^3 at point 6 m below the edge of the circular area. a. 18.62 b. 137.66 c. 115.17 d. 129.02
In Problem 16.3, if there was a surcharge of 20 kN/m2 at the ground level, what would be the total horizontal normal stresses at A and B? Use the results from Problem 16.3. 16.3 The soil profile at a site is shown Figure P16.3. Find the total horizontal normal stresses at A and B, assuming at-rest conditions.
Consider a continuous foundation of width B = 1.4 m on a sand deposit with c = 0, = 38, and = 17.5 kN/m3. The foundation is subjected to an eccentrically inclined load (see Figure 6.33). Given: load eccentricity e = 0.15 m, Df = 1 m, and load inclination = 18. Estimate the failure load Qu(ei) per unit length of the foundation a. for a partially compensated type of loading [Eq. (6.89)] b. for a reinforced type of loading [Eq. (6.90)]